ADVANCED INTEGRATED CIRCUITS Eugenio Culurciello Spring 2005 Yale University SWITCHED CAPACITORS CIRCUITS.

Slides:

Advertisements

Similar presentations

Controller Tests Stephen Kaye Controller Test Motivation Testing the controller before the next generation helps to shake out any remaining.

Advertisements

1 Practical OP-AMP Circuits. 2 i i Integrator 3 Differentiator i i.

SIGNAL PROCESSING WITH ANALOG CIRCUIT Chun Lo. Analog circuit design  Main disadvantage: low precision  Due to mismatch in analog circuit components.

Digital to Analog and Analog to Digital Conversion

A/D Conversion and Interfacing Physics 270. Voltmeters.

Design and Implementation a 8 bits Pipeline Analog to Digital Converter in The Technology 0.6 μm CMOS Process Eri Prasetyo.

Negative vs. positive feedback What is the difference? Consider what happens when there is a perturbation Positive feedback drives op amp into saturation:

Bandpass Sigma-Delta Modulator Michael Vincent Brian McKinney ECEN5007.

Introduction to Analog-to-Digital Converters

Announcements Tuesday’s Lecture next week is cancelled –October 18 th Assignment 4 is active, due in my mailbox by 5pm Friday (October 14 th ) Mid-term.

VLSI System Design – ECES 681 Lecture: Interconnect -1 Prashant Bhadri Office: Rhodes Hall - 933C Department of ECECS, College of.

Prof. Yasser Mostafa Kadah – BASIC ELECTRONICS PART 4: OPERATIONAL AMPLIFIER.

Introduction to Op Amps

1D or 2D array of photosensors can record optical images projected onto it by lens system. Individual photosensor in an imaging array is called pixel.

High-speed Current- based Comparators ECE 1352 Presentation By: Duy Nguyen.

Sigma Delta A/D Converter SamplerModulator Decimation Filter x(t) x[n]y[n] Analog Digital fsfs fsfs 2 f o 16 bits e[n] Over Sampling Ratio = 2f o is Nyquist.

Op-Amp Based Circuits Section 8.2. Topics Non-Inverting Amplifier Inverting Amplifier Integrator Differentiator.

Operational Amplifiers David Lomax Azeem Meruani Gautam Jadhav.

Operational Amplifier based Charge Amplifiers

© The McGraw-Hill Companies, Inc McGraw-Hill 1 PRINCIPLES AND APPLICATIONS OF ELECTRICAL ENGINEERING THIRD EDITION G I O R G I O R I Z Z O N I 15.

PowerPoint slides of selected figures from the textbook.

Intro to Digital Electronics. Classifications of Electronic Circuits Switching Circuits – by turning electricity on and off. – Figure 1 – Known as the.

Analog to Digital conversion. Introduction  The process of converting an analog signal into an equivalent digital signal is known as Analog to Digital.

3V CMOS Rail to Rail Op-Amp

ECE 2799 Electrical and Computer Engineering Design “ANALOG PROCESSING TECHNIQUES” Prof. Bitar.

Mixed Signal Chip LAB.Kyoung Tae Kang Dynamic Offset Cancellation Technique KyoungTae Kang, Kyusun Choi CSE598A/EE597G Spring 2006.

ELECTRONICS PRIMER II.

Vital Signs Monitor UConn BME 4900 Vital Signs Monitor Purpose As the population ages, many people are required by their doctors to take vital signs.

PH4705/ET4305: Sample & Hold Measurement system often can’t keep pace with changing input signal particularly where a conversion into a digital signal.

BASIC LOGIC GATES. In studying digital in integrated circuits, one must start with the simples group of circuits, the SSIs or Small Scale Integrated Circuits.

William. Operational Amplifier (op amp) Drawing Circuit Diagrams Inverting Amplifiers – Negative potential is higher than Positive Potential Non-Inverting.

What is an Amplifier…? An Amplifier is a device which takes small voltage at the input, amplifies it and produce higher voltage at the output. The gain.

Lecture 4: Electrical Circuits

The ECG UConn BME 290. Buffers What is a buffer? –Non-inverting amplifier with a gain of 1 Why use a buffer? –Buffers provide a high input impedance.

Lecture 25: Implementation Complicating factors Control design without a model Implementation of control algorithms ME 431, Lecture 25.

SAMPLE AND HOLD CIRCUIT. CIRCUIT CONSTRUCTION The circuit samples the input and holds the last sample until the input sampled again. The circuit has an.

ECE/CS 352 Digital System Fundamentals© T. Kaminski & C. Kime 1 ECE/CS 352 Digital Systems Fundamentals Spring 2001 Chapter 6 – Part 2 Tom Kaminski & Charles.

Dynamic Logic Circuits Static logic circuits allow implementation of logic functions based on steady state behavior of simple nMOS or CMOS structures.

The AQuA Converter An Analog Memory Cell Micah O’Halloran Prof. Rahul Sarpeshkar Analog VLSI & Biological Systems Group Jan. 25, 2002.

1 Operational Amplifiers n Ideal Op-Amp –input terminals –differential gain, open-loop gain.

OP-AMPs Op Amp is short for operational amplifier. An operational amplifier is modeled as a voltage controlled voltage source. An operational amplifier.

CMOS Analog Design Using All-Region MOSFET Modeling

An operational amplifier (Op-Amp) is a differential amplifier that amplifies the difference of voltages applied to its two input terminals (differential.

Signal conditioning Noisy. Key Functions of Signal Conditioning: Amplification Filter  Attenuation  Isolation  Linearization.

CHOPPER AMPLIFIER Chop means sample.

Sampling. Introduction  Sampling refers to the process of converting a continuous, analog signal to discrete digital numbers.

The Ideal Op-amp (Operational amplifier) v+ VOUT v– +15V VIN VOUT –15V

IMPROVING THE PERFORMANCE OF COMPARATORS

PULSE MODULATION.

Introduction to Digital Signal Processing

SUMMING AMPLIFIER INTEGRATOR DIFFERENTIATOR COMPARATOR

B.Sc. Thesis by Çağrı Gürleyük

Digital Electronics Introduction

VLSI Design Methodologies

What is an Op-Amp Low cost integrating circuit consisting of:

Quiz: SAR ADC Input Types TIPL 4003 TI Precision Labs – SAR

AC Inlet & AC Input Filter

Op-Amps and Analog Computers

Comparator What is a Comparator?

تقویت کننده های عملیاتی

Propagation Time Delay

PRESS RELEASE DATA SHEETS

K.N. Toosi University of Technology

Sample & Hold Circuits CSE598A/EE597G Spring 2006

Chapter 10 Figure 07.

Comparator What is a Comparator?

ADS7841 SAR Input Model (6/1/17)

סימנים מוסכמים בחשמל ואלקטרוניקה

Op Amps and Voltage Dividers

1.Introduction to Advanced Digital Design (14 marks)

Presentation transcript:

ADVANCED INTEGRATED CIRCUITS Eugenio Culurciello Spring 2005 Yale University SWITCHED CAPACITORS CIRCUITS

Continuous Time Continuous Value Analog circuits, op- amps, filters… Discrete Time Continuous Value Switched capacitors Continuous Time Discrete Value Asynchronous Digital Logic Discrete Time Discrete Value Synchronous Digital Logic

Switched Capacitors are often used in modern analog VLSI: Integrators both for voltages and currents Filters (many more advanced filters have been developed) Operational Amplifiers Comparators Noise-reduction circuits (CDS) Charge pumps Isolation circuits

Switched Capacitors Yes, but how do we implement switches?

Switched Capacitors And are the switches good? No! Because of charge injection due to gate charge which divides into 2 charges We need to cancel the added charge using a compensated switch – a simple technique!

Switched Capacitors And are the switches good? Other compensation techniques: differential signaling Pay attention to noise in the sampling capacitors! The noise power is kT/C!

Switched Capacitors Operational Amplifiers Comparators Integrators

Switched Capacitors CDS = noise reduction in image sensors removes offsets and fixed-pattern noise Michael will present a paper on this next Thursday Please remember to read the paper for discussion!

Switched Capacitors Charge Pumps

Switched Capacitors Charge Pumps

Switched Capacitors Isolation Amplifiers

Switched Capacitors Isolation Amplifiers