1 Thesis Writing

2 What is a Thesis? Thesis is the document describing the Project Work carried out as a part of partial fulfillment of academic requirement to get a degree. It describes the complete process of the project starting from the problem formulation to the solution and conclusions in a Scientific and Methodical manner.

3 What is the significance of Thesis ? While carrying out the project, the delegates get an opportunity to work on technical problem and bring out the solution by following scientific and technical methods. During this phase the delegates put all their learning and apply the theoretical knowledge and analytical skills gained during the course to derive the solutions.

4 It involves a systematic approach to document the proceedings of the project and gives a thorough training for the candidate to re-look at the presentation skills. It is a proud document a student can produce to prove his/her capability to analyse and solve an engineering problem. Thesis are often considered to be the testimonials for the candidates who aspire for a good job or higher education. What is the significance of Thesis..?

5 What level of work is expected in a Master’s thesis? Master’s thesis is just one step below the Ph.D. thesis in terms of originality and contribution. However, finding solution to the original engineering problem using the scientific and technical methods would suffice at Master’s level. Although “new invention” in the work is not expected, the originality in the solution and solution procedure is very much sought.

6 What is Size of a Master’s Thesis ? A Master’s thesis will fill around pages in A4, inclusive of certificates, declarations, references, appendices and main text. A too small thesis represent the inadequacy of the work content. A too big thesis reflects the inability of the candidate to write a concise report.

7 Format of the Thesis FORMAT

8 Mandatory Sections/Chapters Acknowledgement Abstract Table of Contents List of Tables List of Figures Nomenclature 1 - Introduction 2 – Literature Review 3 – Problem Definition 3.1 Problem Definition 3.2 Objectives 3.3 Methodology

9 4 – Validation Studies 5 – Deisgn/Experimental/Computational Studies 6 - Resuts and Discussions 7 -Conclusions and Recommendations for future work References Appendix Mandatory Sections/Chapters

10 Mandatory Submissions Number of dissertation Copies: (4 ) as per the standards specified by AROs office Student Copy-1, Academic Project Guide-1, Industry Project Guide-1, Library Copy-1 If you have any extra guide other than mentioned above, you need to provide a copy for him/her also Electronic version of your dissertation 6-8 page length IEEE/Elsevierstandard research paper (Electronics Stream –IEEE, Mechanical Stream-Elsevier) A3 size poster in colour depicting highlights of your project for display