By: Colt Schmidt Required 4 AA Re-chargeable Batteries Finished piece.

Slides:

Advertisements

Similar presentations

Examples of Solar Products. Solar Electricity for Homes Inverter, DC to AC.

Advertisements

Self contained power supply.  My Project converts a nine volt battery into a five volt normal output capable of charging or powering virtually anything.

AnaSonde Assembly. What is the AnaSonde? *Reads temperature, pressure, and humidity data from the atmosphere *After it is sent into the atmosphere, it.

RF Hardware Setup Empowering Intelligent Interaction Qwizdom, Inc.™ Copyright 2007.

The ZAGGsparq™ family of chargers is the most convenient, powerful, and sleek portable backup battery collection available. Their 2.1A rapid output charges.

VOLTAGE -is the potential difference between two points in a circuit By: Enrique Montano, Grant Davis, Anna Missana, Santiago Arriaga.

MySOS User Guide.

Make sure that you have a grounding strap to avoid static discharge that can ruin your computer. You always need to have a grounding strap connected to.

1 Hands-on: Heater Circuit Kit includes: 3 9 Volt batteries (for flight only) 1 Perf Board 3Ceramic Resistors (4 5W) 39 V connectors 1 White wire 1.

Meter Lab Introduction to Electricity Assignment for tomorrow: Read chapter R1.

SpectraSonde Assembly. What is the SpectraSonde? Reads temperature, pressure, and humidity data from the atmosphere. The SpectraSonde doesn’t fly like.

Electronic Component Functions What is this component doing my in electronic device?

Design, Implementation and Validation of a USB Charger Ilia Baranov Department of Electrical and Computer Engineering University of Waterloo 2A Candidate.

Power Supplies And Batteries ARRL Book Section 3.3.

A Dirt-Cheap Battery Tester RARS Meeting – April 2011.

LunaLight PCB Rev 2.1 Mike Deagen (MATE) IME 458 May 25, 2012 Fully Integrated Solar-Rechargeable LED Lantern and Cell Phone Charger.

Lesson: Circuits Contributed by: Integrated Teaching and Learning Program, College of Engineering, University of Colorado at Boulder.

The USB Charging Station (TUCS) Basheer and Connor’s Make Project.

Electric Current. The rate at which electrical charges flow through a wire or conductor is called electric current.The rate at which electrical charges.

MICRO CONTROLLER MODULE 1. Learning Objectives Name some gadgets that use microcontrollers. Define a microcontroller. Differentiate between a computer.

Electricity Jeopardy Circuits 1 Circuits 2 Electric Current OhmExtra Q $100 Q $200 Q $300 Q $400 Q $500 Q $100 Q $200 Q $300 Q $400 Q $500 Final Jeopardy.

Section 2 Current. Voltage and Current Electrical Potential Energy: the ability to move an electrical charge from one point to another. Depends on position.

INTRO TO COSTRUCTION 150 ELECTRONICS FOR ELECTRICANS SPRING 2014.

Electricity. What is electricity? Electric current – flow of electrons through a _______ Current (I) is measured by how many __________pass a given point.

Luigi Galvani ( ) “Animal electricity”. Galvanic Cells Alessandro Volta showed that chemical reactions between metal electrodes and an electrolytic.

Introduction to Current Electricity, Part 1 Grade 9 Academic Science R.H. King Academy.

Bellringer A standard household outlet has a voltage of what?

IPod analyses Paul, Ethan, Niels. Casing: Plastic cover Dual injection molding ▫White cover ▫Transparant layer on top of this Advantages ▫Lower part cost.

Charging a Battery SC2 Objective Student will determine the state of charge of a battery and charge a battery in or out of the vehicle.

Hand Tools By Tynedra Murphy. Torx Driver Set Set of screwdrivers varying in sizes.

AMSTI Circuits Lesson 14. Overview Semiconductor diode = allows electricity to flow in one direction Examples: battery chargers, radios, computers, and.

PRACTICAL ELECTRONICS

1 Chapter 20 Review activity! Fun in B208!.  A. Unit of energy  B. Unit of charge  C. Unit of current  D. Unit of voltage. 2 What is a coulomb?

Dance Pad Project By: David Dorsten. Understand  Electric Engineering Project = Dance Pad and Light Bulb Station  This activity will demonstrate the.

How does my lighthouse work?

SHAKE CELL PHONE CHARGER PROTOTYPE PRESENTATION GROUP 6 1.

How to Create RJ – 45 Wire.   To create the RJ – 45 cable or better known as the Cat wire it is very simple all you need to do is follow my simple instructions.

Avoid _____________ _____________ _____________ _____________ _____________ _____________.

Steps for the Teacher to do  Make 2 versions of the picture but put the faulty bulb in one of the circuits.

Oisture Tester How to Solder. Learning Objectives Understand the soldering process Practice soldering Continue with design ideas Produce an information.

Solar Portable Folding Solar Kit 12W. Solar opening & folding panel Folded Panel - Back 2 Pockets Open Panel Size: 61 x 21.5 x 0.4 cm (24 x 8.5 x 0.2.

Electricity and Circuits I can describe an electrical circuit as a continuous loop of conducting materials. I can combine simple components in a series.

Electric Circuits. Ohm’s Law Current, voltage, and resistance are related to one another. The relationship among resistance, voltage, and current is summed.

Altoids Solar Panel Phone Charger By Allison Hook.

SeaPerch Electrical System. Electrical System Overview Assemble the control box. Make the Cat5 connector. Wire the motors to the tether. Wire the control.

How to Fix NiCad Batteries Dead 18volt Craftsman drill. About 6 years old. Worked great 9 months ago.

The batteries of smartphones can’t last forever but sure it can last for a long time if used with proper care. Getting your phone charged properly is.

Introduction to Hybrid Drive Vehicles

Jag Mark Name 4 factors that can affect the resistance of a current?

The Contemporary Home Free standing Lamp/Light

Introduction to Soldering

Keva Industries has launched

SeaPerch Electrical System

Installing an Xbox 360.

Electrical Circuits.

Research 5 different electronic toys

Computer Basics.

Reduction In Charger Sales

FeMaidens Programming

Circuits & Voltage.

Series And Circuits.

Wiring the Light and Relay

Basic Electronics Part Two: Electronic Components.

Investigating Electricity

Charging a Battery SC2 By Vance Bloom.

Electricity/Start & Charge systems

Electricity/Start & Charge systems

SeaPerch Electrical System

Presentation transcript:

By: Colt Schmidt

Required 4 AA Re-chargeable Batteries Finished piece

 Needed a lot of experimenting on different batteries  I tried 2 AA batteries, 9V battery, 4 AA batteries, and 4 AA Re-chargeable batteries  4 AA re-chargeable batteries worked  Gives your device about 3 full charges

 I found a new way to charger your device without using the wall or the car  It is portable and small  It runs off of batteries and it is re-useable  Most of my information came from tests and the internet

1. 9V battery holder 2. Battery holder 2 AA 3. Battery holder 4 AA 4. Wires 5. Circuit board with components 6. Tin can 7. Voltage tester 8. Pliers 9. Soldering gun 10. Wires cutter 11. Batteries

1. Assemble circuit board 2. Solder wires to battery sockets 3. Test battery socket 4. Solder USB port to circuit board 5. Perform another test 6. Test by plugging in an IPod using a USB cable to see if battery charger works 7. If it doesn’t work repeat on different batteries

Put out less volts Can be constantly re-used Better for the environment

Fixed Wall ChargerPortable Battery Charger

Colt Schmidt