Traffic Light Control PREPARED BY: Sherasiya Akaram (ID NO: 09EC04) Shukla Dhaval (ID NO: 09EC67) Department of Electronics & Communication Shankersinh Vaghela Bapu Institute Of Technology,Vasan.
INTRODUCTION One way traffic light controllers having three signal Red, Green and Yellow To ensure that suitable traffic signals are provided to reduce accidents and improve conditions for public transport
Signal To Stop Signal to Proceed With Caution Signal To Go-Ahead
How Traffic Light Control Work ? The circuit based around 555 Timer IC (Astable mode) + 4017B Johnson counter The 555 astable circuit provides clock pulses for the 4017 counter which has ten outputs (Q0 to Q9) the sequence of the traffic lights is spread over 10 clock pulses
PART LIST IC SEMICONDUCTOR LIST 1. NE555 2. 4017B 1. D1 TO D6: 1N4148 2. L1,L2,L3 : LED
RESISTOR LIST CAPACITOR 1. 3*01 K OHM 2. 1*10 K OHM 3. 2*22 K OHM 47 µF 0.01 µF 6.8 nF
MISCELLANEOUS 1. 16 pin IC socket 2. 08 pin IC socket 3. Battery snap 4. 2 pin battery connecter
CIRCUIT DIAGRAM
WORKING OF CIRCUIT The 555 timer IC is connected for Astable Operation, the clock pulses are fed to the 4017 IC via the 10K resistor. The 4017 is a 10 stage counter, therefore the sequence of the traffic lights is spread over 10 clock pulses, 4on red, 1 on red & amber, 4 on green and 1 on amber
Each output becomes high in turn as the clock pulses are received Each output becomes high in turn as the clock pulses are received. Appropriate outputs are combined with diodes to supply the amber and green LEDs. The red LED is connected to the ÷10 output which is high for the first 5 counts (Q0-Q4 high), this saves using 5 diodes for red and simplifies the circuit.
OBSERVATION TABLE 4017 COUNTER HIGH RED YELLOW GREEN Q0 and ÷10 On
APPLICATION Control the flow of traffic Reduce the risk of accidents
REFERENCE www.clarkson-uk.com www.rshelectronics.co.uk