Warm up a)State if the following angles are adjacent angles. b)Explain why or why not 1)∠ AXB and ∠ BXD 2) ∠ AXD and ∠ AXB 3)∠ AXB and ∠ CXE 4)∠ AXC and.

Slides:

Advertisements

Similar presentations

Constructing Lines, Segments, and Angles

Advertisements

DO NOW Sketch each figure. CD GH AB Line m Acute ABC XY II ST.

Geometric Constructions: Congruent Segments and Congruent Angles Geometry Mr. Zampetti Unit 2, Day 1.

Warm Up Using a compass, create one of each of the following:

Constructing Perpendicular Bisectors

1-1a Slide 1 of 2 (over Lesson 3-2). 1-1b Slide 1 of 2 (over Lesson 3-2)

1.5 Segment and Angle Bisectors Goal 1: Bisect a segment Goal 2: Bisect an angle CAS 16, 17.

Introduction Tangent lines are useful in calculating distances as well as diagramming in the professions of construction, architecture, and landscaping.

Angle Bisectors Adam J. Flick Sarah A. Porter. Congruent Angles- two angles with the same measure Example ◦Given:Angle 1 is congruent to angle 2 measure.

Constructing Inscribed Circles Adapted from Walch Education.

Section 1-5: Constructions SPI 32A: Identify properties of plane figures TPI 42A: Construct bisectors of angles and line segments Objective: Use a compass.

Bisecting a Line Segment. You want to bisect line segment PQ.

Bisecting Segments and Angles

1 Objectives: 1. Measure segments. 2. Calculate with measures. 1-2 Linear Measure and Precision.

Perpendicular Bisector of a Segment and Angle Bisector

Constructions. Supplies Paper (thick stack) Compass Straight Edge.

1.6 Basic Constructions.

Copying Segments and Angles Adapted from Walch Education.

Success Criteria: I can use special geometric tools to make a figure that is congruent to an original figure without measuring I can apply this method.

CHAPTER 1: Tools of Geometry

Constructing Perpendicular and Parallel Lines Adapted from Walch Education.

1.7 Basic Constructions.

Constructions Mrs. Brook. Constructions For these constructions we will use a compass and a straightedge.

CONSTRUCTION DAY! Segment and Angle Bisectors LEARNING TARGETS: 1. I will be able to construct line segment bisectors and angle bisectors with a compass.

Geometric Construction Notes. Table of Contents How to navigate this presentation Geometric Construction Introduction Drawing Guidelines Parts of the.

Objective: Inscribe and circumscribe polygons. Warm up 1. Length of arc AB is inches. The radius of the circle is 16 inches. Use proportions to find.

Basic Constructions Constructing Perpendicular Lines I.From a point to a line II.Perpendicular Bisector.

Chapter 1: Tools of Geometry

Lesson 1.7 – Basic Constructions “MapQuest really needs to start their directions on #5. Pretty sure I know how to get out of my neighborhood”

Constructing Perpendicular Bisectors and Lines Right angles Cut in Half.

Unit 1 All About Angles and Constructions (not necessarily in that order) Ms. Houghton Geometry Honors Fall 2014.

Chapter 1.7 Basic Constructions 16.0 Students perform basic constructions.

1-6 Basic Constructions.

1.6 Basic Construction 1.7 Midpoint and Distance Objective: Using special geometric tools students can make figures without measurments. Also, students.

1.4 Measuring Angles 1.5 Exploring Angle Pairs.

Lesson 10-1: Constructions 1 Lesson 10-1 Constructions.

GEOMETRY HELP Use the method learned for constructing congruent angles. Step 2: With the same compass setting, put the compass point on point N. Draw an.

Constructing Triangles Tri 1 side/2 angles Constructions Example 1: To construct a triangle of base 9 cm with angles of 35 o and 65 o. To construct a.

Basic Geometric Constructions

LEARNING TARGETS:  I will be able to construct congruent angles. VOCBAULARY Compass and Straightedge.

5.2 Congruent Triangles Pythagorean Theorem Angle Bisectors Transformations Constructions Objectives: To review and practice concepts involving congruent.

5.3.2: Introduction Segments and angles are often described with measurements. Segments have lengths that can be measured with a ruler. Angles have measures.

Constructions Bisect – To divide something into two equal parts Perpendicular – Lines that intersect to form right angles. Today’s constructions: –Bisect.

{ Constructions Duplicating and Line and an Angle.

Slide 1-1 Copyright © 2014 Pearson Education, Inc. 1.6 Constructions Involving Lines and Angles.

Construct TW congruent to KM.

Lesson 10-1: Constructions

Introduction Geometry construction tools can also be used to create perpendicular and parallel lines. While performing each construction, it is important.

1.6 Basic Constructions SOL: G4 Objectives: The Student Will …

Chapter 5.1 Segment and Angle Bisectors

Constructing Bisectors

Warm up Find the midpoint of segment AB A(0,0) B(6,4)

Geometric Constructions

Constructing Perpendicular Bisectors and Lines

Introduction Two basic instruments used in geometry are the straightedge and the compass. A straightedge is a bar or strip of wood, plastic, or metal that.

5 Construction 2 Perpendicular Bisector of a Segment, Using Only Compass and Straight Edge Draw a line segment [CD]. Place the compass needle point on.

Basic Constructions Constructing Perpendicular Lines

Warm-Up #28 Monday 5/2 Write an equation in slope intercept form with these two points: (2, 4) and (0, -6). Given f(x)= f(x-1) +3 and f(0) = 6, find f(2).

Compass Constructions

Lesson 10-1: Constructions

Basic Constructions Skill 06.

Use a ruler and a protractor to draw a segment 5 cm long and a 50 degree angle . Then use the ruler and a protractor to draw a bisector of the segment.

1.6 and 3.6 Constructions By Brit Caswell.

Basic Constructions.

Geometry Unit 1: Foundations

3.3 Constructions of Equilateral Triangles and Isosceles Right Triangles TSWBAT: Construct equilateral and isosceles right triangles.

Constructing and bisecting Line Segments

3.7 Constructing Parallel and Perpendicular Lines

Presentation transcript:

Warm up a)State if the following angles are adjacent angles. b)Explain why or why not 1)∠ AXB and ∠ BXD 2) ∠ AXD and ∠ AXB 3)∠ AXB and ∠ CXE 4)∠ AXC and ∠ CXE A B C D E X

4.3 Constructions

For these constructions, first watch me model the construction then we will go through the steps again as you do a construction. Make all markings very light and make your arcs short. Make sure lead is sharp. You may use sand paper to sharpen the lead. If you make a mistake either erase fully or start over. DO NOT SCRIBBLE OUT YOUR MISTAKES!!

#1 Construction Construct a congruent line segment. 1)Draw 1)Draw a ray. 2)Open 2)Open compass to the length of original line segment. 3)Place 3)Place point on the vertex of your ray, make an arc on the ray.

#1 Construction Construct a line segment that is congruent to a segment that is 3 inches long. So first you must draw a segment that is 3 inches long. 1)Draw 1)Draw a ray. 2)Open 2)Open compass to the length of original line segment. 3)Place 3)Place point on the vertex of your ray, make an arc on the ray.

#2 Construction Construct segment bisector. 1)Place 1)Place point of compass on an endpoint of the line segment. 2)Open 2)Open compass so that it is open well beyond where the bisector of the segment should be. 3)Make 3)Make slight arc marks above and below the line segment approximately above and below where the bisector of the segment should be. 4)Pick 4)Pick up compass and without changing the opening of your compass, repeat step 3. 5)Connect 5)Connect the two intersecting point to form the bisector of the line segment.

#2 Construction Construct a segment bisector of a line segment 3 inches long. So first you must draw a segment that is 3 inches long. 1)Place 1)Place point of compass on an endpoint of the line segment. 2)Open 2)Open compass so that it is open well beyond where the bisector of the segment should be. 3)Make 3)Make slight arc marks above and below the line segment approximately above and below where the bisector of the segment should be. 4)Pick 4)Pick up compass and without changing the opening of your compass, repeat step 3. 5)Connect 5)Connect the two intersecting point to form the bisector of the line segment.

#3 Construction Construct an angle bisector. 1)Place 1)Place point of compass on the vertex of the angle. 2)Open 2)Open the compass to any length and mark both rays of the angle with a slight arc. 3)Move 3)Move point of compass to the intersection of the new arc and the ray, make an arc in the interior of the angle. 4)Move 4)Move point of the compass to the second intersection of the arc and ray and make an arc in the interior of the angle. 5)Draw 5)Draw a ray whose vertex is the vertex of the angle and that passes through the intersection of the arcs in the interior of the angle.

#3 Construction Construct a bisector of an angle whose measure is 60°. So first you must draw an angle that has an angle measure of 60°. 1)Place 1)Place point of compass on the vertex of the angle. 2)Open 2)Open the compass to any length and mark both rays of the angle with a slight arc. 3)Move 3)Move point of compass to the intersection of the new arc and the ray, make an arc in the interior of the angle. 4)Move 4)Move point of the compass to the second intersection of the arc and ray and make an arc in the interior of the angle. 5)Draw 5)Draw a ray whose vertex is the vertex of the angle and that passes through the intersection of the arcs in the interior of the angle.