How To Install A New Hard Drive To Replace An Old One Sample Instructional Guide Odetta Rodriguez – Week 5

Install A New Hard Drive To Replace An Old One Hard drive space isn’t infinite. Today’s massive drives, with capacities exceeding 1TB, can create that illusion. But as drive sizes increase, ways to consume drive capacity also expand. HD video, for example, can eat gigabytes for breakfast.

Identifying The Proper Replacement Before you can upgrade a hard drive with a new replacement you’ll need to determine the type of drive you need to buy. Today, most hard drives use a data connection known as SATA. However, computers that are several years old might instead support a data connection called IDE. You can easily tell the difference between the two because an IDE connection uses numerous pins, while SATA uses a pin-less L-shaped connector. The picture below provides a comparison – the SATA drive is on the left and the IDE drive is on the right. Laptop drives will obviously be smaller, but have the connections have the same appearance.

Size Matters Speaking of size, you’ll also need to make sure you buy a drive with the correct physical dimensions. There are two popular hard drive sizes – 3.5″ and 2.5″. The larger is built for desktop systems, while the smaller is generally for laptops and compact desktops. However, solid state hard drives often come in the 2.5″ size regardless of the type of machine they’re meant to be installed in. This rule isn’t absolute, however, because some all-in-one computers use 2.5″ drives.

Contents of the hard drive The process of installing a new hard drive is one of the least difficult hardware installation procedures around in terms of the physical effort required. However, the hard drive is one of the most critical components in your system because it stores all of your information. Everything from your operating system to your s to your favorite songs are stored on your hard drive.

Replacing The Old Drive Desktop computer hard drives are usually placed in the lower front half of a mid-tower enclosure and are attached using between two and six screws. The process isn’t overly difficult, but is detailed enough to warrant its own post. Laptops are different, but easier. Most laptops will offer a plastic hard drive bay cover on the bottom of the laptop that is held in with one or two screws. Removing the cover will reveal the drive, which is itself typically attached with a few screws. Installing a replacement drive is simply a matter of taking the existing drive out and putting the new drive in its place. The power and data connections are built into the mount itself, so you don’t have to worry about tracking down the cables. Please note that not all laptops are intended to be user serviceable in this way, so please read your laptop’s manual for information about hard drive replacement before proceeding.

Booting & Partitioning Once you’ve replaced your old drive you will, of course, want to boot up your PC to make sure everything is functioning well. Assuming you did clone your data from your old drive to your new once, this process should be painless. Your PC will barely realize that anything has changed. You should probably visit the Disk Management utility, which can be found by visiting the Administrative Tools –> Computer Management section of the Windows Control Panel, to ensure that Windows is recognizing and using all of your new hard drive’s capacity. If it isn’t, you can extend the current partition to cover the free space or create a new drive partition.

References Smith, M. (2011). How to Install a New Hard Drive to Replace an Old One. Retrieved Fhttp:// replace/rom: