+ Using Ohm’s Law to Build a Voltage Divider 1. + Learning Objectives Understand and demonstrate the engineering design process Use Ohm's Law as a tool.

Slides:

Advertisements

Similar presentations

Series and Parallel Circuits

Advertisements

Chapter 7 Series-Parallel Circuits. Objectives Analyze series-parallel circuits Analyze loaded voltage dividers Analyze ladder networks Analyze a Wheatstone.

Unit 7 Parallel Circuits

Circuits Series and Parallel. Series Circuits Example: A 6.00 Ω resistor and a 3.00 Ω resistor are connected in series with a 12.0 V battery. Determine.

Basic Circuits – Lab 1 Xmedia Spring Basically Power –Provides energy for the sensor and the output Sensor –Changes aspects of the circuit based.

Electronics: Bridging the gap between 8 th grade studies and High School Presented by: Donna J. Casanova 8 th grade Physical Science Providence Public.

Basic Circuits – Lab 1 Xmedia Spring Basically Power –Provides energy for the sensor and the output Sensor –Changes aspects of the circuit based.

Use Ohm’s Law to solve the following equations.

Series and Parallel Circuits. Circuits  Can either be series or parallel.

Lab 2: Ohm’s Law Only 10 more labs to go!!

Electricity Define Electricity: Electrons: Short Circuit: Current: Battery: Voltage:

Electrical Circuits Utah Underwater Robotics Instruction Slides.

Do Now Describe what you think happens electrically when you dim a light.

NPN Foundations of Technology NPN © 2013 International Technology and Engineering Educators Association, STEM  Center for Teaching and Learning™ Foundations.

Chapter Twenty: Electric Circuits

Concurrent Assessment DC Electronics 1 1.When you have a complete series circuit, is the current flow the same at every place in the circuit? 2.What is.

Measuring the Current and Voltage of a 820 Ω Resistor Setting for Multimeter = 200 mA DC Measure Voltage in 2 V increments up to 20 V.

SCR (Silicon-Controlled Rectifier) Foundations of Technology SCR (Silicon-Controlled Rectifier) © 2013 International Technology and Engineering Educators.

Potentiometer Foundations of Technology Potentiometer © 2013 International Technology and Engineering Educators Association, STEM  Center for Teaching.

4.2.3B Electrical Power What About Watts?. Power Law Moving electrons (current) requires ENERGY How much energy gets used depends on: Strength of push.

Capacitor Foundations of Technology Capacitor © 2013 International Technology and Engineering Educators Association, STEM  Center for Teaching and Learning™

+ Using Ohm’s Law to Build a Voltage Divider 1. + Learning Objectives Understand and demonstrate the engineering design process Use Ohm's Law as a tool.

Engineering Fundamentals Session 4 (3 hours). Resistance Amount of current flows in an electric circuit depends on the resistance of the material through.

Voltage, V Voltage tells us how hard a positive charge is pushed between two different points. Something, such as a battery, is needed to create a voltage.

Regents Physics Chapters 17/18 Circuits  Series Circuits.

J. Gabrielse Ohm’s law V I R. J. Gabrielse Voltage (V) Definition: what pushes charges Unit: volt (V) Measured by putting voltmeter in parallel. -+

CH Review Series resistors have the same current; the total voltage is “divided” across the resistors. Parallel resistors have the same voltage;

EGR 101 Introduction to Engineering I1 Resistors in Parallel Resistors connected at a single node pair Voltage across each resistor is the same.

Circuits. In circuits, elements are connected by wires. Any connected region of wire has the same potential. (same color = same potential) The potential.

Chapter 8. Ohm’s Law  George Ohm experimented with circuits and came up with a mathematical relationship relating voltage, current and resistance in.

Ohm’s Law Foundations of Technology Ohm’s Law © 2013 International Technology and Engineering Educators Association, STEM  Center for Teaching and Learning™

Ohm’s Law Resistance in Series Circuits

Resistors Foundations of Technology Resistors © 2013 International Technology and Engineering Educators Association, STEM  Center for Teaching and Learning™

Resistance and Ohm’s law. Resistance Some materials are better conductors than others. How do we quantify this difference? Electrical resistance R is.

Electric Circuit Types Series and Parallel Circuits.

Solving Circuits 1. _______________ Circuit: A circuit in which there is ___________ path for electrons to follow. 2. _______________ Circuit: A circuit.

Electronics for Physical Computing Materials: capacitor, diode, LED, transistor, switch,resistor, relay, proto board, multimeter.

Circuit Electricity. Circuit Builder Interactive: Builder/Circuit-Builder-Interactive.

6.2 ELECTRONICS. CAPACITOR An electrical device used to store electrical charge.

HOW FAST IS A NANOSECOND?. ONE-BILLIONTH OF A SECOND!!!

Intro to Electricity Electricity Definition: Circuit Definition: Three things for a circuit to work:

Solving Problems 14.1 & A circuit contains 5-ohm, 3-ohm, and 8-ohm resistors in series. What is the total resistance of the circuit? Rt = R1.

Series and Parallel Circuits SNC1D. Series and Parallel Circuits Key Question: How do series and parallel circuits work?

Using a Mulitmeter A digital multimeter is a test tool used to measure two or more electrical values—principally voltage (volts), current (amps) and resistance.

Ying Yi PhD Lab 3 Resistance and Ohm’s Law 1 PHYS HCC.

Diode Foundations of Technology Diode © 2013 International Technology and Engineering Educators Association, STEM  Center for Teaching and Learning™ Foundations.

Photocell Foundations of Technology Photocell © 2013 International Technology and Engineering Educators Association, STEM  Center for Teaching and Learning™

The Series Circuit Summary 1. The sum of the _____________or voltage equals the potential rise of the source. 2. The current is ______________ everywhere.

Electricity Definitions

Determining Equivalent Resistance

Unit 7 Parallel Circuits

Thevenin Theorem Any combination of batteries and resistances with two terminals can be replaced by a single voltage source e and a single series resistor.

Series Circuit – 1 bulb Series Circuit – 1 bulb.

Warm Up #13 What is an electric current?.

Circuit Introduction Section 1:

Resistive Circuits Resistors in series Resistors in parallel

Review of Calculations

Resistance in Circuits

3.1 Resistors in Series When two elements connected at a single node, they are said to be in series Series-connected circuit elements carry the same.

Resistive Circuits Resistors in series Resistors in parallel

Ohm’s Law If the current I = 0.2A and the resistance R = 1000 ohms, solve for voltage. If V = 110V and R = ohms, how much current is flowing through.

Series vs Parallel Circuits

Current Directions and

(2 or more cells in series)

Comparing Series and Parallel Circuits

Voltage Difference The difference in electrical potential between two places. Unit of measure = V (volts) Voltage causes current to flow through an electric.

Series and Parallel Circuits

Electric Circuits Chapter 35.

Voltage, Current and Resistance

Presentation transcript:

+ Using Ohm’s Law to Build a Voltage Divider 1

+ Learning Objectives Understand and demonstrate the engineering design process Use Ohm's Law as a tool for engineering design. Use a digital multimeter to collect data. Analyze the electrical requirements of light emitting diodes (LED’s). 2

A Voltage Divider A voltage is applied to two resistors in series The same amount of current flows through each resistor Voltage is divided between R1 and R2 Ohm’s Law 3

+ Getting Started Divide into Teams - Engineers work with Teachers Review the materials Challenge #1: Voltage Divider Challenge #2: Light an LED 4

+ Challenge #1 Learning to read resistor values Using a breadboard to build an example voltage divider Build a voltage divider to meet a design requirement 5

+ Challenge #2 Design your circuit - What voltage and current are required by the LED? Build your circuit - What is the polarity of your LED? Test your design. Did you get the desired voltage and current? What is the voltage across the LED Try a different design goal 6

+ Reflections What factors affected your design Measured vs Specified Battery Voltage Measured vs Specified Resistance Teaching the Math Concepts Solving Simultaneous Equations Trial and Error Modifications to the lesson for your grade level Incorporating the lesson into our classroom 7