Pressure Drop Through an Orifice as Measured by a Manometer. By: Austin Thompson As part of: BIEN 301 February 13, 2007.

Slides:



Advertisements
Similar presentations
Devices to measure Pressure
Advertisements

3.5 Non-Newtonian fluids Newtonian fluids are fluids which follow Newton’s law: Shear Stress Shear Rate CHE Non-Newtonian fluids.
VISCOSITY CALCULATION MARYCYNTHIA EZIKE BIEN 301 INDIVIDAUL PROJECT. 5TH FEBUARY, 2007.
Integration Relation for Control Volume
Obstruction Flowmeters: Orifice, Venturi, and Nozzle Meters.
Continuity of Fluid Flow & Bernoulli’s Principle.
Solving Equations = 4x – 5(6x – 10) -132 = 4x – 30x = -26x = -26x 7 = x.
L OUISIANA T ECH U NIVERSITY BIOMEDICAL ENGINEERING Turbulent Flat-Plate Flow *P7.34 Sarah Jeffords Travis King Scott Laura Eric Post.
Pitot Stagnation Tubes Under Laminar Conditions *P7.24 Jace Benoit February 15, 2007.
CE 230-Engineering Fluid Mechanics Lecture # BERNOULLI EQUATION.
Viscous Fluid Flow (14 p.341) Viscous Fluid Flow A. Prof. Hamid NEBDI Faculty of Applied Science. Department of Physics. Room: 315 second.
Fluid Friction. Outline Bernoulli ’ s Equation The Pressure-Drop Experiment Laminar Flow Turbulent Flow The Three Friction Factor Problems Computer Methods.
1 Lec 26: Frictionless flow with work, pipe flow.
CE 230-Engineering Fluid Mechanics Lecture # 18 CONTINUITY EQUATION Section 5.3 (p.154) in text.
Fluid mechanics 3.1 – key points
Chapter Five Flow Measurement
Flow Sensors.
Fluid Mechanics 05.
Paul Drosinis UBC Phys 420. Introduction Short history on fluid dynamics Why bother studying fluid flow? Difference between Newtonian and Non-Newtonian.
DIFFERENTIAL MANOMETER
Simple U-TUBE Manometer
PFR design. Accounting for pressure drop Chemical Reaction Engineering I Aug Dec 2011 Dept. Chem. Engg., IIT-Madras.
Problem Network Flow Scott Jewett BIEN 301 January 30, 2007.
Introduction to COMSOL Travis Campbell Developed for CHE 331 – Fall 2012 Oregon State University School of Chemical, Biological and Environmental Engineering.
SURVIVAL MODE Quiz 3 –
APLIKASI BERNOULLI PADA
PHAROS UNIVERSITY ME 259 FLUID MECHANICS FOR ELECTRICAL STUDENTS Basic Equations for a Control Volume.
Fluid Properties: Liquid or Gas
Measurement of flowing fluids
CHAPTER 5: PRESSURE 5.1 Pressure and Its Units
Unit: IV-Fluid Dynamic
Chapter Six Non-Newtonian Liquid.
Things to grab for this session (in priority order)  Pencil  Henderson, Perry, and Young text (Principles of Process Engineering)  Calculator  Eraser.
Nondimensionalization of the Wall Shear Formula John Grady BIEN 301 2/15/07.
CHAPTER 2 Fluid Statics and Its Applications Nature of fluids
Cost-effectiveness: An Engineers's Real Job Problem 3.138* Created By: Patrick Thomas.
2.6 Instantaneous Rates of Change 1 We have established a graphical interpretation of the derivative as the slope of a tangent line. Now, we want to understand.
ME421 Heat Exchanger Design
Estimating The Viscosity Bio-fluids Bien 301 Jasma Batham.
Amy Stephens BIEN February 2007
Height Differences Using Flat-Plate Boundary Layer Problem 7.24* Pamela Christian BIEN 301 Individual Project February 15, 2007.
PIPELINE DESIGN ‘ THE ENGINEERING APPROACH’ SESSION OBJECTIVES THE ENGINEERING EQUATIONS TRANSMISSION LINE GAS FLOW LIQUID SYSTEM.
1 Chapter 6 Flow Analysis Using Differential Methods ( Differential Analysis of Fluid Flow)
Flow In Circular Pipes Objective ä To measure the pressure drop in the straight section of smooth, rough, and packed pipes as a function of flow rate.
ME 101: Fluids Engineering Chapter 6 ME Two Areas for Mechanical Engineers Fluid Statics –Deals with stationary objects Ships, Tanks, Dams –Common.
VISCOUS FLOW IN CONDUITS  When we consider viscosity in conduit flows, we must be able to quantify the losses in the flow Fluid Mechanics [ physical.
Friction Losses Flow through Conduits Incompressible Flow.
BIEN 301 Group Project Presentation Hydrostatic Force Against A Wall Jasma Batham,Mootaz Eldib, Hsuan-Min Huang,Sami Shalhoub.
Potential Flow and Computational Fluid Dynamics Numerical Analysis C8.3 Saleh David Ramezani BIEN 301 February 14, 2007.
Lecture 4. Pressure. 4.1 Pressure and it units Pressure = “the normal (perpendicular) force per unit area” Pressure at the bottom of the static (nonmoving)
Incompressible Flow in Pipes and Channels
Viscosità Equazioni di Navier Stokes. Viscous stresses are surface forces per unit area. (Similar to pressure) (Viscous stresses)
Heat Transfer Su Yongkang School of Mechanical Engineering # 1 HEAT TRANSFER CHAPTER 9 Free Convection.
SUGGESTED MINIMUM KNOWLEDGE OF FLUID MECHANICS AND FOR FE EXAM
1 Dept. of Agricultural & Biological Engineering University of Illinois TSM 363 Fluid Power Systems TSM 363 Fluid Power Systems Bernoulli’s Law and Applications.
Lesson 6: Mathematical Models of Fluid Flow Components ET 438a Automatic Control Systems Technology lesson6et438a.pptx1.
Copyright © Cengage Learning. All rights reserved.
FLUID FLOW STREAMLINE – LAMINAR FLOW TURBULENT FLOW REYNOLDS NUMBER.
Energy Loss in Valves Function of valve type and valve position
Flow through tubes is the subject of many fluid dynamics problems
Physics 21.
Notes Over 9.6 An Equation with One Solution
Review of ChE Fluid Mechanics
All dimension in mm Set A
FLUID MECHANICS REVIEW
FLUID MECHANICS LAMINAR AND TURBULENT FLOW.
Internal Flow: General Considerations
Find: ΔPAF [Pa] T=20 C kerosine benzene 40 [cm] air A F 20 [cm] 8 [cm]
12. Navier-Stokes Applications
Flow Measurements.
Presentation transcript:

Pressure Drop Through an Orifice as Measured by a Manometer. By: Austin Thompson As part of: BIEN 301 February 13, 2007

Problem: Water at 20°C flows through the orifice shown in figure P6.154, which is monitored by a mercury manometer. If d = 3cm… a)What is h when the flow rate is 20 m 3 /h b)What is Q in m 3 /h when h = 58cm

Required: Find h when Q = 20 m 3 /h Find the volumetric flow rate when h is given to be 58 cm.

Assumptions Laminar Flow Liquid Incompressible Frictionless pipe Thin plate (type) orifice

Sketch

Solution To solve for h, we must have C d, d, D, ΔP, Re D, V, β, and Q. We are given d, and Q, from which we can derive the others as follows: Part a)

With the Reynolds Number now solved for, we can go to figure 6.41 and find that C d is about Now for the Reynolds Number:

Using these Values, the following equation can be solved. Note that ΔP = (p mercury - p water )(g)(h).

Part b) Part b asks us to find Q when h is a known value of 58 cm. Using the same equation from part a…

Biomedical Application This problem shows relationship in pressures across an orifice. Given that this example does have perfectly rounded corners and given dimensions, it could be compared to something in the body. A blood clot could be described as an orifice, only with more complex forms of exemplification. Knowing how to calculate pressure changes in an artery or vein may be vital knowledge in saving someone’s life.