Introduction to ARIA IP - 60 Anton Hattingh

Content System overview Connection diagram System Recourses Connections Hardware Features

System overview Hybrid telephone system with 12 analog PSTN’s & 48 ext. Caller ID service for CO line & SLT Conference, SMDR, LCR, Call duration control Collect call barring, Mobile extension Other services for enterprise communications - Alarm detection - External door phone control - External paging interface, - External music source interface

General connection diagram

System Resources 1/2 DESCRIPTION CAPACITY/BOARD TOTAL Time Slots 128 CO Line Ports 3/MBU, 3/EMBU, 3/CHB308, 3/CSB316, 8/VOIB, 30/E1HB8 Max. 36 Max Direct Station (DKT, SLT, DSS) Connections 8/MBU, 8/EMBU, 8/CHB308, 16/CSB316, 8/VOIB, 8/E1HB8 Max. 48 Max. Door 2/MBU, 2/EMBU 4 LAN MBU, VOIB, E1HB8 3 MODEM Channel 1/MODU 1 Attendant Positions 5/System Intercom Links Non-Blocking Paging - All Call - Internal 1 zone 5 zones Station Speed Dial 100/station, 24 digits each 500 System Speed Dial 24 digits each Last Number Redial 15 ~ 50(by admin programming) 32 digits

System Resources 2/2 DESCRIPTION CAPACITY/BOARD TOTAL CO Line Group 8 Station Group 10 Conference 3~15 Party All ports are available Multi-Conference Max. 3 groups Internal MOH (13 Music Sources) 1/MBU 1 External MOH External Paging port External Relay Contact 2/MBU, 2/EMBU 4 Alarm Input RS-232C Port DTMF/CPT Receiver channels 16 chs/MBU 16 chs FSK Receiver channels PFT Circuit 1/MBU, 1/EMBU, 1/CHB308, 1/CSB316

MBU connectors and LED Status LED LD1 : System running indication ※ Available Option: 1. CN2 : E1HB8, CHB308, CSB316 or SLIB8 2. CN4 : MODU 3. CN5 : VMIU or AAFU 4. CN14: VOIB 5. CN9 & CN10: CMU50PR or CMU12PR LD1 : System running indication LD2-4 : S/W task indication SW1 : Default ON Pole1 : reserved Pole2 : system trace on Pole3 : reserved Pole4 : system backup SW2 : Backup battery ON for protection Status LED

System Connections BKSU EKSU BKSU Only RJ-11 CO# : Loop start CO Port 1: N/A 2: DKT-Tip 3: SLT-Tip or CO-Tip 4: SLT-Ring or CO-Ring 5: DKT-Ring 6: N/A CO# : Loop start CO Port STA# : Hybrid Port DKT# : DKTU Only Port SLT# : SLT Only Port BKSU EKSU BKSU Only

Connector Pin-out 1/3 MBU (CO) MBU (Extension) DKT ONLY MBU (Hybrid) PIN Number NO Signal Name RJ11 1,2 N/A 3,4 CO-T, CO-R 5,6 MBU (Extension) DKT ONLY CONNECTOR PIN NUMBER NO SIGNAL NAME RJ11 1 N/A 2 DKT-T 3,4 ALARM_Detection 5 DKT-R 6 MBU (Hybrid) CONNECTOR PIN NUMBER NO SIGNAL NAME RJ11 1 N/A 2 DKT-T 3,4 SLT-T, SLT-R 5 DKT-R 6 NOTE—When installing DKT or SLT on Hybrid Ports, (MJ2-2,3,4,5,6,7,8), keep the above pin assignment. Otherwise the DKT or SLT will not operate normally.

Connector Pin-out 2/3 TERMINAL DKT TERMINAL SLT CONNECTOR PIN NUMBER SIGNAL NAME RJ11 1 N/A 2 RING 3,4 Reserved 5 TIP 6 TERMINAL SLT CONNECTOR PIN NUMBER NO SIGNAL NAME RJ11 1,2 N/A 3,4 TIP, RING 5,6

Connector Pin-out 3/3 CN13 Pin Assignment (Relay Contact) SIGNAL NAME 4 PIN 1 Relay 1-pin1 2 Relay 1-pin2 3 Relay 2-pin1 4 Relay 2-pin2 MJ3 Pin Assignment (LAN) Connector Pin Number NO SIGNAL NAME FUNCTION RJ45 4,5,7,8 RESERVED 1 TX+ Transmit Data 2 TX- 3 RX- Receive Data 6 RX+

Terminal/SLT Cabling Distance

Expansion Card CHB308 CO Line and Hybrid Board (3 CO + 8 HYB) External. Provides 3 circuits Loop start CO line interface. DTMF or pulse signaling to line Loop current detection FSK & DTMF CID detection. Call progress tone detections Internal. Provides 8 digital Stations or 8 SLT station circuits. FSK & DTMF CID detection and Generator. +36V Power Circuit for SLT feeding SLT feeding Current is 20mA at 900ohm loop impedance.

Expansion Card CSB 316 CO Line and SLT Board (3 CO + 16 SLT) External. Provides 3 circuits Loop start CO line interface. DTMF or pulse signaling to line Loop current detection FSK & DTMF CID detection. Call progress tone detections. Internal. Provides 16 SLT station circuits. FSK & DTMF CID detection and Generator. +36V Power Circuit for SLT feeding SLT feeding Current is 20mA at 900ohm loop impedance.

Expansion Card SLIB 8 SLT Board (8 SLT’s) Internal. Provides 8 SLT station circuits. FSK & DTMF CID detection and Generator. +36V Power Circuit for SLT feeding SLT feeding Current is 20mA at 900ohm loop impedance.

E1 Digital trunk & 8 Hybrid Expansion Card E1HB8 E1 Digital trunk & 8 Hybrid CN5 on the MBU, but not on the EMBU E1 digital trunk: maximum 30 CO lines at the same time 8 Hybrid ports that provide DKT or SLT connection 2.048Mbps E1 line as CAS(Channel Associated Signaling) HDB3 CODE DID, DOD, and TIE according to each country’s specifications Pulse dialing, DTMF dialing, and MFC-R2 signaling(30 channels at the same time) SLU8(Single Line Interface Unit: 8 ports CN6, CN7 on the E1HB8 +36V power circuit for SLT feeding Single Line Interface circuit: 8 EA

Add on board MODU Modem function board MODEM function board   MODU provides analogue modem connection. MODU should be installed on the CN4 Supports Bell, ITU-T, V.34, V.32BIS, V.90 Protocol 300bps up to 33Kbps speed rate Automatic rate negotiation  

Voice Mail Interface Unit Add on board VMIU Voice Mail Interface Unit VMIU provides 4 channel Record/Play VMIU provides Time & System prompt All message are saved in Flash memory Max record time - Prompt : 8 Min. - System greeting : 24 Min - User record time : 99 Min Max. Number of User Voice Message: 800ea Note : User Greeting does not lost by system power off or reset because of this message is stored in FLASH memory

Auto Attendant Function Unit Add on board AAFU Auto Attendant Function Unit AAFU provides 4 channel Record/Play AAFU provides Time & System prompt All message are saved in Flash memory Max record time - Prompt : 8 Min. - System greeting : 24 Min - User record time : 9 Min Max. Number of User Voice Message: 800ea Note : User Greeting does not lost by system power off or reset because of this message is stored in FLASH memory

Voice over Internet Protocol Interface board Add on board VOIB & VOIU Voice over Internet Protocol Interface board VOIB can be installed on the basic MBU Provides the Ethernet interface for S/W applications and VoIP features . Optional VoIP daughter board.(VOIU) Maximum Capacity: 8 channels -VOIB provides four(4) VoIP channels. -VOIU provides four(4) VoIP channels. Item Specification LAN Interface 10 / 100 Base-T Ethernet(IEEE 802.3) Speed 10 Mbps (Auto-Negotiation) Duplex Half Duplex or Full Duplex(Auto-Negotiation) VoIP Protocol H.323 Revision 2 Voice Compression G.711/G.726/G729/G.723.1 Voice/Fax Switching T.38 Echo cancellation G.165

Add on board CMP50PR & CMU12PR Call Metering & Polarity Reversal Detection unit 50Hz and 12Hz CMU50PR (Call Metering-50 Hz & Polarity Reversal Detection unit) Provides 3 channels Call Metering detection for 50Hz Provides 3 channels of Polarity Reversal Detection It can be installed on the MBU, EMBU, CHB308 or CSB316 CMU12PR(Call Metering-12KHz & Polarity Reversal Detection unit) Provides 3 channels Call Metering detection for 12 KHz or 16Khz Provides 3 channels of Polarity Reversal

Not Compatible with OptiCon IP and GDK Systems. Proprietary Terminals MODEL DESCRIPTION LDP-7224D 3 Line LCD display, 24 Flexible Button,3 Soft keys, Navigation key LDP-7208D 2 Line LCD Display, 8 Flexible Button LDP-7248DSS 48 Button DSS Console LDP-DPB Door Phone Box LDP-7224D LDP-7208D LDP-7248DSS LDP-Door phone Not Compatible with OptiCon IP and GDK Systems.

IP Terminals MODEL DESCRIPTION LIP-7024LD LIP-7024D LIP-7016D 3 Line LCD display, 24 Flexible Button,3 Soft keys, Navigation key, Dual LED,Calender,Scheduler LIP-7024D Dual LED LIP-7016D 3 Line LCD display, 16 Flexible Button,3 Soft keys, Navigation key, LIP-7008D 2 Line LCD Display, 8 Flexible Button LIP-7024LD LIP-7024D LIP-7016D LIP-7008D

Maintenance PSTN Dial-up Connection Off-site (Remote) Maintenance Data Network In-site maintenance Digital Terminal Admin Console On-site & Off site maintenance through RS-232C, Ethernet, Modem On line PC Admin : DB up/download, Diagnostics, S/W upgrade, PC Admin Off line PC Admin (PC Admin Pro) Speed Editor for system speed dial User level admin program – adjustable level program

Voice Mail / Auto Attendant Optional Voice Mail and Auto-Attendant Auto-Attendant : 4 channels / 10 min recording / 25 min system greeting Voice Mail SMS Notification to virtual extension (mobile extension) 4 ch. / Max. 100 min recording time/ 25 min greeting / 800 user message recording Max. 100 system greetings / Max. 25 min

Networking Business models for SIP operator / Nortel IP platform SIP / H.323 proxy registration ARIA IP – 60 Voice Networking

Questions?