Performance New requirement s for circuit integrity: enhanced cables BS 5839-1 : 2002 Fire Detection and Fire Alarm Systems for Buildings Part 1: code.

Slides:

Advertisements

Similar presentations

Safety Testing of Medical Electrical Equipment

Advertisements

International Telecommunication Union Technical Session on Home Networks Geneva, 29/04/2011 ITU-T Study Group 5 Protection against Lightning Phil Day Australia.

Electrical Installation-Module 3

© Abb Control Ltd - 1 ABB Protection - Overload What do we mean by a fault? Overload Operating condition in an electrically undamaged circuit which causes.

Relocation of the Operations Control Center Oil Movements May 4, 2007 For RCAC Board Meeting.

N.F.P.A. 13R Justin Bohlmann FIR-204.

Electrical Safety and Grounding Essentials Copyright © Texas Education Agency, All rights reserved.

Protecting life, environment and property… 1 AutroFlame Detectors ID: AFLAME_X33_1_intro

CIRCUIT ARRANGEMENT (Note: All the mentioned tables in this course refer to, unless otherwise specified, Low Voltage Electrical Installation Handbook,

Assumption University Thailand EE4503 Electrical Systems Design Introduction 1.

GST FIRE ALARM SYSTEM INTERNATIONAL BUSINESS DEPARTMENT , GST BEIJING

FIRE DETECTION FOR DWELLINGS A Short History of Developments in the Use of Smoke Alarms in the UK, Related to Ongoing European Developments Jason Perrins.

ELECTRICAL INSTALLATION DESIGN

ECE 4411 Mechanical Power and Developed Torque Total power across the air gap is mechanical power plus power lost in the rotor conductors.

Circuits Series and Parallel. Series Circuits Example: A 6.00 Ω resistor and a 3.00 Ω resistor are connected in series with a 12.0 V battery. Determine.

1 Fire Service Professionals. 2 Overview n Industrial Fire Systems n Innovations n Hazardous Areas n Changes to regulations n System integration n Future.

Lesson.5: Fuses and Safe Plugs

BUILDING SECURITY ALARM SYSTEM. BUILDING SECURITY ALARM SYSTEM Any electrical or mechanical device which is designed or used for the detection of an unauthorized.

FET Current Mirrors ECE Current Sources Ideal independent current sources are difficult to make and are almost impossible to fabricate on an integrated.

City & Guilds Level 3 Award in the Periodic Inspection, Testing and Certification of Electrical Installations.

Scheduled Versus Event Driven Testing of Distribution Protection IEDs Dr. Alexander Apostolov, Benton Vandiver, Will Knapek, OMICRON electronics.

IP Electricity and energy © Oxford University Press 2011 Electricity and energy.

Circuits and Electronics. Circuits A circuit is a closed path through which a continuous charge can flow. A circuit is a closed path through which a continuous.

Your Hospital What are sensing circuits ?

Intelligent Detection Systems l integrity of system confirmed continuously l pre-alarm facility l high flexibility of system configuration l performance.

A PRACTICAL TRAINING SEMINAR ON PLCC

Bieffe Coaxial Cables Distributed by Cables Britain Limited.

CB200 Conventional Control Panels

COMMISSIONING: REDUCING THE CARBON FOOTPRINT (…and Maintenance Costs) (…and Operating Costs)

No content in the brand signature area No content in this area CYAN RGB= 000,153,255 DARK GREY RGB= 075,087,095 DRAKA BLUE RGB= 000,051,153 DRAKA Colors.

Session 11 Grid Tied PV Systems – Part 1 Standards and Codes October 01, 2015.

API Recommended Practice 17X Recommended Practice for Design, Installation, and Maintenance of Subsea Booster Pump Systems Status Report October 3,

Purpose NEW BEAM DUMP TUNNEL Launch Safety Agreement - conventional aspects LIU-SPS external beam dump meeting - C. Colloca DGS/SEE LSA conventional.

ICT Module 4 Revision. ICT Attenuation and cable type What is attenuation What cable should be used between buildings and why?

AT-MEL-MI Hardware Commissioning Review, , Suitbert Ramberger 1 The Normal Conducting Magnets and their Circuits Suitbert Ramberger, AT-MEL-MI.

Promoting Quality in Fire Safety Presentation by:.

V-Shaped Software Development Life Cycle Model. Introduction: Variation of water fall model. Same sequence structure as water fall model. Strong emphasis.

Classroom Module 2 Engineering Exam Guide pg. 10.

1Directional Sound Performance Directional Sound Performance Testing Scott Lang Mike Dybas.

Chapter 3 PHYSICAL INJURY AND CONTROLS 3.2 Electrical Safety

Electrical Installation II1 Regulations, Standards & Code of Practice (Chapter 1)

1 Interfaces, Engineering and Standards. 2 Interfaces LoKI Interface document description for deliverables Elements: PBS number, Deliverable description,

COMMISSIONING STANDARDS DESIGN STANDARDS INSTALLATION STANDARDS INSTALLATION STANDARDS DESIGN SPECIFICATION PLANNING INSTALLATION INSPECTION HANDOVER OPERATION.

Laser Line work package (WP6) AWAKE Technical Board meeting 19 May 2014.

ELA Forum The basis, objective and content of SNEL - EN81-80 The basis, objective and content of SNEL - EN81-80 Michael Savage.

Fire Risk Assessment Judith Evans BEng(HONS) CMIOSH

4.0 DOMESTIC ELECTRICITY Domestic electricity is that electricity which is supplied to homes under specific conditions of current and voltage. Voltage,

NONINCENDIVE INSTALLATIONS FOR CLASS I DIV 2 AREAS

NFPA Circuits & Pathways

Main Interferometer Subsystem

EHN1 Extension planning

PV System Quality and Performance

IEEE 383 Standard for Qualifying Electric Cables and Splices for Nuclear Facilities Preview SC-2 May 12, 2014 Robert Konnik.

All you Need to Know About the Wiring Harness

Business opportunities related to CERN electrical network

Voltage, Current and Resistance

Compliant Installation of Voice Alarm Systems

Voltage, Current and Resistance

Learning Outcome 4 Understand the types, applications and limitations of wiring systems and associated equipment This presentation looks at emergency management.

ICAS Alarm Upgrade ICAS Alarm Upgrade Project

- '1:- bs? a ' I.

Major PAR form questions

Workshop: Equipment June 29, 2006.

Fire Alarm Practice Drill # 11 Denver Fire Department Journeyman Installer License Test © Ted Smith 2017.

Biosco: MV/LV prefabricated substations IEC Presentation of the standard Safety is a choice.

FIRE ALARM DRILL 26 © Ted Smith 2017.

Lantech 10G Uplink Rolling Stock Switches Presentation

Presentation transcript:

Performance New requirement s for circuit integrity: enhanced cables BS : 2002 Fire Detection and Fire Alarm Systems for Buildings Part 1: code of practice for system design, installation, commissioning and maintenance Par. 26 Cable, wiring and other interconnections Recommendation for two level of fire resistance: Standard for general use Enhanced when cables might need to operate correctly during a fire for periods in excess of those normally required for single phase evacuation of building under fire condition

Performance New requirement s for circuit integrity: enhanced cables BS : 2002 Standard EN PH 30 classification (improved) 830 °Cmechanical shock for 15 min. mechanical shock and water for 15 min. Enhanced EN PH 120 classification (improved) 930 °Cmechanical shock for 60 min. mechanical shock and water for 60 min. under fire condition

Performance New requirement s for circuit integrity: enhanced cables BS : 2002 Regarding fibre optic cables, “When fibre optic connections are used, they need to provide at least equivalent integrity and reliability to other cables that are recommended for the same purpose”. under fire condition

Products SR 114E Control Cables 300/500 V These cables have been designed to meet requirements of BS : 2002 for enhanced cables for certain specific building applications. Standards: BS 6387 C W Z, BS 7629, SS 299 part 1, IEC 60331, IEC , IEC , IEC , IEC 61034, EN PH120, CEI 20-35, CEI 20-36, CEI 20-37, CEI , CEI 20-22/3