4 Semester 1 CHAPTER 4 REVIEW JEOPARDY Presented by: Terren L. Bichard.

Slides:

Advertisements

Similar presentations

IST 126 Transmission Media. Characteristics of Transmission Media Cost Ease of installation Bandwidth capacity – the amount of data that can be sent in.

Advertisements

Cisco CCNA Sem 1 Chapter 4 Cable Testing, Cabling LAN’s and WAN’s

SUNY Ulster Cisco Semester 1 Unit 4 – Cable Testing K. Wick CCAI.

CCNA 1 v3.1 Module 4 Cable Testing. Purpose of This PowerPoint This PowerPoint primarily consists of the Target Indicators (TIs) of this module in CCNA.

DCN286 Introduction to Data Communication Technology Session 5.

Oct-03 ©Cisco Systems CCNA Semester 1 Version 3 Comp11 Mod4 – St. Lawrence College – Cornwall Campus, ON, Canada – Clark slide 1 Cisco Systems CCNA Version.

Network+ Guide to Networks, Fourth Edition Chapter 3 Transmission Basics and Networking Media.

WXES2106 Network Technology Semester /2005 Chapter 2 Networking Media CCNA1: Module 3, 4 and 5.

1 Version 3.0 Module 4 Cable Testing. 2 Version 3.0 Waves Networking professionals are interested in voltage waves on copper media, light waves in optical.

Measuring Frequency The amplitude of an electrical signal represents height and is measured in volts. The period is the amount of time to complete one.

Physical Layer B. Konkoth.

Media Chapter 2. Two types of Cables Baseband Broadband.

Copyright CCNA 1 Chapter 4, Part 1 Cable Testing By Your Name.

CCNA 1 v3.0 Module 4 Cable Testing. Purpose of This PowerPoint This PowerPoint primarily consists of the Target Indicators (TIs) of this module in CCNA.

CCNA 1 Module 4: Cable Testing.

1 Semester 1 Module 4 Cable Testing Andres, Wen-Yuan Liao Department of Computer Science and Engineering De Lin Institute of Technology

思科网络技术学院理事会. 1 OSI Physical Layer Network Fundamentals – Chapter 8.

DCN286 INTRODUCTION TO DATA COMMUNICATION TECHNOLOGY Network Cable Testers and Tests.

Cisco 1 - Networking Basics Perrine. J Page 19/3/2015 Chapter 3 Which of the following correctly describes the type of signal that the network media carries?

Mod 4 – Cable Testing CCNA 1.

Chapter 2.  Types of Network  Circuit Switched & Packet Switched  Signaling Techniques  Baseband & Broadband  Interference  Transmission Medium.

1 CCNA SEMESTER 1 V 3.0 CHAPTER 4 – Cable testing.

1 Business Telecommunications Data and Computer Communications Chapter 4 Transmission Media.

NESCOT CATC1 Cable Testing CCNA 1 v3 – Module 4. NESCOT CATC2 Waves 1. The _________ of the waves is the amount of time between each wave, measured in.

1 CISCO NETWORKING ACADEMY PROGRAM (CNAP) SEMESTER 1/ MODULE 4 Cable Testing.

7.1 Chapter 7 Transmission Media. 7.2 Figure 7.1 Transmission medium and physical layer Transmission media are located below the physical layer and are.

Physical Transmission

1 © 2003, Cisco Systems, Inc. All rights reserved. CCNA 1 v3.0 Module 3 Networking Media.

Networking Fundamentals Copper Core Cable as Network Media.

Cisco 1 - Networking Basics Perrine. J Page 110/16/2015 Chapter 4 Which of the following best describes a digital signal? 1.A sine wave of normal shape.

7.1 Chapter 7 Transmission Media Copyright © The McGraw-Hill Companies, Inc. Permission required for reproduction or display.

Bits (0s and 1s) need to be transmitted from one host to another. Each bit is placed on the cable as an electrical signal or pulse. On copper cable the.

CCNA 1 Module 4 Cable Testing. 2 Waves Frequency: Frequency: –the number of waves per second Period: Period: –the amount of time that it takes to complete.

Sep-03 ©Cisco SystemsCCNA Semester 1 Version 3 Comp11 Mod4 – St. Lawrence College – Cornwall Campus – Clark slide 1.

CCNA 1 v3.0 Module 4 Cable Testing. Objectives Waves.

7.1 Chapter 7 Transmission Media Copyright © The McGraw-Hill Companies, Inc. Permission required for reproduction or display.

 Cables  Network Interface Card (NIC)  Repeaters  Hubs  Switches  Routers  Gateways  Bridges.

CCNA1 v3 Module 4 v3 CCNA 1 Module 4 JEOPARDY S Dow.

Cisco CCNA Semester 1 Chapter 4 V3.0 By: Terren L. Bichard.

Cisco Semester 1 Chapter 4 Slides Cable Testing

Module 4 Cable Testing.

Lesson 2—Networking BASICS1 Networking BASICS Network Media Unit 1 Lesson 2.

William Stallings Data and Computer Communications 7th Edition

Network Media. Copper, Optical, Fibre (Physical Layer Technologies) Introduction to Computer Networking.

TOPIC 1.2 INTRODUCTION TO NETWORKING. OBJECTIVES By the end of the topic, students should be able to: a) List the elements of data communication systems.

LECTURE#6 - CABLES Asma AlOsaimi. Copper Coaxial Cable - Thick or Thin Unshielded Twisted Pair - CAT 3,4,5,5e&6 Optical Fiber Multimode Singlemode Wireless.

By: Thomas Olivotti.  PSNEXT stands for Power Sum Near End Crosstalk and is calculated by transmitting a signal down each wire pair in turn and summing.

+ Lecture1 Transmission Media Asma Alosaimi 1. + Topics: Review Transmission media types Copper Media Fiber Optical Media Wireless Media 2.

NET 222: COMMUNICATIONS AND NETWORKS FUNDAMENTALS ( NET 222: COMMUNICATIONS AND NETWORKS FUNDAMENTALS (PRACTICAL PART) Tutorial 3 : Chapter 4 Data & computer.

Wired Transmission 24 Wired Transmission 24. Wired Transmission 24 This is about the method used to actually transmit or send data That means actual wires.

Data Transmission Common media concepts. Data Transmission and Media.

Chapter Four Networking Media. Chapter Objectives  Explain concepts related to data transmission and noise  Describe the physical characteristics of.

Lecture #01 Transmission Media

Lecture #01 Transmission Media

Chapter 7 Transmission Media.

Network Media Types COMPUTER NETWORKS 4TH Edition Chapter3

Networking TRANSMISSION MEDIA.

Transmission Media.

Module 4 Cable Testing.

Lecture #01 Transmission Media

James Chen Module 4: Cable Testing James Chen 2018/11/10 Yuda college of business.

LECTURE #01 TRANSMISSION MEDIA

Lecture #01 Transmission Media

CCNA 1 version 3.0 Rick Graziani Cabrillo College

CCNA 1 v3.1 Module 4 Cable Testing

CCNA 1 v3.1 Module 4 Cable Testing

Transmission Media Located below the physical layer and are directly controlled by the physical layer Belong to layer zero Metallic Media i.e. Twisted.

Transmission Media.

Presentation transcript:

4 Semester 1 CHAPTER 4 REVIEW JEOPARDY Presented by: Terren L. Bichard

WavesCablingNoise Cable Testing StandardsHodge-Podge

Waves 100 Name two types of Waves Sine Waves & Square Waves

Waves 200 What is Frequency? The number of waves that reach the shore per second.

Waves 300 What is Amplitude? The height of a wave.

Waves 400 What is Hertz? Frequency is measured in this.

Waves 500 Fiber Voltage waves is to copper as light waves is to…

Cabling 100 What are two types of cabling? Copper and Fiber

Cabling 200 What are shielded and unshielded? Types of Copper wire

Cabling 300 What is the distance in meters of Thinnet coax cable? 185 meters

Cabling 400 What is the purpose of twisting in UTP & STP cables? Prevents crosstalk

Cabling 500 What is UTP (Unshielded Twisted Pair)? The least expensive type of LAN wiring

Noise 100 What are some causes of noise on copper cable? EMI, RFI, Fluorescent lights

Noise 200 What is noise? Rock Music

Noise 300 What is an acronym for Radio Frequency Interference? RFI

Noise 400 What is an acronym for Electromagnetic Interference? EMI

Noise Daily Double What is crosstalk? Interference from data on the other pairs of data wires

Cable Testing Standards Wire Map 2.Insertion loss 3.Near-End crosstalk (NEXT) 4.Power Sum Near-End crosstalk (PSNEXT) 5.Equal-Level Far-End crosstalk (ELFEXT) 6.Power Sum Equal-Level Far-End crosstalk (PSELFEXT) 7.Return Loss 8.Propagagation delay 9.Cable length 10.Delay Skew 1.Wire Map 2.Insertion loss 3.Near-End crosstalk (NEXT) 4.Power Sum Near-End crosstalk (PSNEXT) 5.Equal-Level Far-End crosstalk (ELFEXT) 6.Power Sum Equal-Level Far-End crosstalk (PSELFEXT) 7.Return Loss 8.Propagagation delay 9.Cable length 10.Delay Skew Name the ten cable testing standards

Cable Testing Standards 200 What is propagagion delay? The length of time it takes for a signal to travel along the cable being tested.

Cable Testing Standards 300 What is PSELFEXT? The combined effect of ELFEXT from all wire pairs.

Cable Testing Standards 400 What is Return Loss? A measure in decibels of reflections that are caused by the impedance discontinuities at all locations along the link.

Cable Testing Standards 500 What are the four separate tests for crosstalk? NEXT, ELFEXT, PSELFEXT & Return Loss

Hodge-Podge 100 What is the official title of the standard for Cat 6 cable? ANSI/TIA/EIA-568-B.2-1

Hodge-Podge 200 What is the Physical Layer? 90% of all LAN problems are found at this layer.

Hodge-Podge 300 What is Analog Bandwidth The frequency range that is associated with FM Radio

Hodge-Podge 400 How much information can flow from one place to another in a given amount of time in bits per second. Description of digital bandwidth

Hodge-Podge 500 What is Optical Link Loss Budget? The acceptable amount of signal power loss that can occur without dropping below the requirements of the receiver.