Engineering Technology Division

Slides:



Advertisements
Similar presentations
Power Plant Construction and QA/QC Section 2.3– Steam Generators
Advertisements

Combined Heat and Power plants – carbon AND cost saving? Daman Ranby – Director Ashley Allsop – Head of Sustainability.
A novel IGCC system with steam injected H2/O2 cycle and CO2 recovery P M V Subbarao Professor Mechanical Engineering Department Low Quality Fuel but High.
What’s the only thing that moves slower than the a glacier? An IOU Power Generation Technologies.
1 ENERGY EFFICIENCY IMPROVEMENT IN THE POWER SECTOR Presentationby BHEL - Corporate Engineering & Product Development 5 June 2008.
DISTRICT HEATING: AN OVERVIEW PRESENTED BY: NIELSEN SYSTEMS APRIL 8, 2011.
Engineering Technology Division
Power Plant Construction and QA/QC Section 5.2 – Combustion Control and Burner Management Engineering Technology Division.
Cogeneration. Is the simultaneous production of electrical and thermal energy from a single fuel source.
Power Plant Construction and QA/QC Section 2.4– Boiler Auxiliaries
ENERGY CONVERSION ES 832a Eric Savory Lecture 11 – A small-scale power plant worked example Department of Mechanical.
3-Multi - Can Annular Combustor 3-Multi - Can-Annular Combustor The third design and the one preferred by most manufacturers, is the can-annular combustor,
“Energy Efficiency Guide for Industry in Asia”
Project: Energy Resources. Non-renewable Fossil fuels Fossil fuels generate electricity by the fuel (coal, oil, gas, or wood) is burned in a furnace at.
Lecture 4 Ideal cycles III Polytropic efficiencies Exercise
ES 202 Fluid and Thermal Systems Applications of Thermodynamics and Fluid Mechanics.
PACCON 2013 PREDICTION OF NITROGEN OXIDE GENERATED FROM GAS TURBINE ENGINE Global Chemical Sciences for Green Community NATCHANON CHAIPRASERT / AMORNCHAI.
GAS TURBINE POWER PLANTS
Shaft Power Cycles Ideal cycles Assumptions:
Combined_Cycle_Power_Plant Prepared by: Nimesh Gajjar.
EGR 334 Thermodynamics Chapter 9: Sections 7-8
Cogeneration.
Large Steam& Gas Turbines P M V Subbarao Professor Mechanical Engineering Department Backbones of Modern Nations ……
High Efficiency UTILITY RESCUE THE MEANS TO ABUNDANT SAFE CLEAN POWER.
JET PROPULSION Part 2 Combustion.
Power Plant Construction and QA/QC Section 3.5 & 3.6 – Hydraulic Turbines & Reciprocating Engines Engineering Technology Division.
Gas Power Cycle - Jet Propulsion Technology, A Case Study
Ship Propulsion Systems
Prof. D.N. Reddy Director Centre for Energy Technology University College of Engineering Osmania University.
Power Plant Construction and QA/QC Section 7.4 – Hydroelectric Generators, Transformers and Controls Engineering Technology Division.
Air Pollution Sources: Coal-Fired Power Plants April 13, 2011.
Engineering Technology Division
Energy and the Environment Spring 2014 Instructor: Xiaodong Chu : Office Tel.: Mobile:
Plant Utility System (TKK-2210) 14/15 Semester 4 Instructor: Rama Oktavian Office Hr.: M-F
Power Plant Construction and QA/QC Section 5.4 – Key Systems and Components Engineering Technology Division.
Power Plant Construction and QA/QC Section 1.9– Biomass Energy Engineering Technology Division.
Power Plant Construction and QA/QC Section 1.3– Oil and Natural Gas Engineering Technology Division.
Earth’s Changing Environment Lecture 15 Energy Conservation.
Unit 2 -Gas And Diesel Power Plants
Power Plant Construction and QA/QC Section 1.8– Wind Energy
11. 2 Steam Energy Energy that comes from the push of steam.
Power stations Thermal power stations Sankey diagrams World power generation Tsokos p.430 qns3-7 11May Physics8.1, 8.2, 8.3 Power generationTsokos.
Gas Turbines for Aircraft Propulsion. AIR CRAFT ENGINE The turbojet engine consists of three main sections: the diffuser, the gas generator, and the nozzle.
Prof. R. Shanthini Nov 12, An engineering example for unsustainable development.
Power Plant Construction and QA/QC Chapter 2– Guide to ASME Code VIII, Division 1, Pressure Vessels Engineering Technology Division.
ENERGY CONVERSION MME 9617A Eric Savory Lecture 10 – Analyzing a complete plant: Energy conversion cycles Department.
Power Plant Construction and QA/QC Section 1.4– Nuclear Energy Engineering Technology Division.
Power Plant Construction and QA/QC Section 8.3 – Wind Energy Technology Engineering Technology Division.
Workings of a generator Energy sources Renewable and non-renewable Energy density.
Power Plant Construction and QA/QC Section 5.3 – Turbine and Engine Governors Engineering Technology Division.
Power Plant Construction and QA/QC Section 9.5 – Power Plant Noise and its Control Engineering Technology Division.
 FAN  COMPRESSOR  COMBUSTOR  TURBINE  MIXER  NOZZLE.
Power and Energy Consumption: State and National Perspective Created for: Illinois Math & Science Partnerships Energy Workshop 7/8/2013.
I ntroduction.. 1 Energy Conversion  Energy Conversion  Energy Conversion is when energy changes into another form. In physics, the term energy describes.
Closed Brayton Cycle Power Conversion Design James C. Conklin 18 February 2004
WORK Work = Force x Distance POWER power = work done ÷ time taken ENERGY 1-POTENTIAL ENERGY (Potential Energy = Force x Distance ) 2-KINETIC ENERGY Energy.
Power Plant Construction and QA/QC Section 5.1 – Power Plant Instruments Engineering Technology Division.
Des. Ton Nguyen. MAIN PARTS  Fan  Compressor  Combustor  Turbine  Nozzle.
Gas Turbine Power Plant
Gas Turbine Engine – Turbojet
Power Plant Construction and QA/QC Section 2.1– Steam Fundamentals
Date of download: 10/10/2017 Copyright © ASME. All rights reserved.
Engineering Technology Division
Power Plant Construction and QA/QC Section 1.1– US Energy Resources
Engineering Technology Division
Engineering Technology Division
Content Development of the second generation Power2 Case studies
Power Plant Construction and QA/QC Section 1.2– Coal
Engineering Technology Division
Engineering Technology Division
Presentation transcript:

Engineering Technology Division Power Plant Construction and QA/QC Section 3.3 and 3.4 – Gas Turbine Fundamentals and Design

Off-shoot from Aircraft Engines Section 3.3 – Gas Turbine Fundamentals Overview Concept – 1791 First Design – 1872 Off-shoot from Aircraft Engines Materials and Temperatures are problems Lower Power Outputs (400 MW) than Coal, Nat Gas or Nuclear Emissions – CO2 Fuel Type

Section 3.3 – Gas Turbine Fundamentals Typical

Section 3.3 – Gas Turbine Fundamentals Plant

Section 3.3 – Gas Turbine Fundamentals Questions?

Materials – Compressor and Turbine Heat Extraction – Co Generation Section 3.4 – Gas Turbine Design Overview Materials – Compressor and Turbine Heat Extraction – Co Generation Mass and Speed – Power Optimum Alignment Operating Range - Speed

Section 3.4 – Gas Turbine Design Working Overview

Typical Power Generation Gas Turbine Section 3.4 – Gas Turbine Design Typical Power Generation Gas Turbine

Typical Power Generation Gas Turbine Section 3.4 – Gas Turbine Design Typical Power Generation Gas Turbine

Section 3.4 – Gas Turbine Design Compressor

Section 3.4 – Gas Turbine Design Combustors

Turbine Blades Section 3.4 – Gas Turbine Design HP 1st Stage Blade HP 2nd Stage Blade

Section 3.4 – Gas Turbine Design Overview Cooling Needed

Section 3.4 – Gas Turbine Design Questions?