SATELLITE MIGRATION PROJECT Contractor Orientation
SATELLITE FREQUENCY Hyundai-Crystal 1.Press “menu”, select “installation” and press “ok”. 2.Select “factory set” and press “ok”. 2
SATELLITE FREQUENCY Hyundai-Crystal 3.A prompt will appear “do you want to reset all data?”, press “ok” for “yes”. 4.The “first installation” prompt will appear, press “ok” to save. 3
SATELLITE FREQUENCY Hyundai-Crystal 5.Wait for “scanning progress” to finish. Press “exit” button. 6.Press “menu”, select “installation” and press “ok”. 4
SATELLITE FREQUENCY Hyundai-Crystal 7.Select “LNB configuration” and press “ok”. 8.To “add new” satellite, press “red button” on the remote control. 5
SATELLITE FREQUENCY Hyundai-Crystal 9.A prompt will appear “do you want to add a satellite?”, press “ok” for “yes”. 10.Press “exit” button. Under “installation window, select “TP edit/scan” and press “ok” button. 6
SATELLITE FREQUENCY Hyundai-Crystal 11.Enter the following parameters: a.TP Frequency GHz b.Polarization - Vertical 14V c.Symbol Rate MSPS 12.Select “scan” and press “ok” (Do not press “exit” while scanning is in progress). 7
SATELLITE FREQUENCY Hyundai-Crystal 13.After scanning, repeat steps but enter the frequency “12430” in step Repeat steps but enter the frequency “12470” in step 11. 8
SATELLITE FREQUENCY Hyundai-Crystal 15.Press “exit” after scanning has been completed. Under “installation”, select “scan” and press “ok”. 16.Under “scan”, select “all network scan start” then press “ok” button. 9
SATELLITE FREQUENCY Hyundai-Crystal 17.You will see the scanning progress. After scanning is done, press “ok”. 18.Exit the installation view by pressing the “exit” button four (4) times. 10
FORMS & FORMATS 11 JOB ORDER FORM Control No.: Installer Name : Dealer : Subscriber Name : Subscriber Contact No. : Address : Items Replaced : Low Noise Block (LNB) ConverterOthers : Antenna Dish Bracket RG-6 Cable I certify that that the Out-Door-Unit (ODU) has been re-aligned/relocated and my unit is working properly. Subscriber/Representative Name & Signature