#3205. What is the relationship of lift, drag, thrust, and weight when the airplane is in straight-and-level flight? A- Lift equals weight and thrust equals drag. B- Lift, drag, and weight equal thrust. C- Lift and weight equal thrust and drag. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#3204. The term ‘angle of attack’ is defined as the angle A- between the wing chord line and the relative wind. B- between the airplane’s climb angle and the horizon. C- formed by the longitudinal axis of the airplane and the chord line of the wing. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#5199. The angle of attack of a wing directly controls the A- angle of incidence of the wing. B- amount of airflow above and below the wing. C- distribution of positive and negative pressure acting on the wing. Comm. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#5204. The angle of attack at which a wing stalls remains constant regardless of A- weight, dynamic pressure, bank angle, or pitch attitude. B- dynamic pressure, but varies with weight, bank angle, and pitch attitude. C- weight and pitch attitude, but varies with dynamic pressure and bank angle. Comm. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#3316. During an approach to a stall, an increased load factor will cause the airplane to A- stall at a higher airspeed. B- have a tendency to spin. C- be more difficult to control. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#5219. Which is true regarding the force of lift in steady, unaccelerated flight? A- At lower airspeeds the angle of attack must be less to generate sufficient lift to maintain altitude. B- There is a corresponding indicated airspeed required for every angle of attack to generate sufficient lift to maintain altitude. C- An airfoil will always stall at the same indicated airspeed; therefore, an increase in weight will require an increase in speed to generate sufficient lift to maintain altitude. Aviation Seminars Comm.
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#5153. For a given angle of bank, in any airplane, the load factor imposed in a coordinated constant-altitude turn A- is constant and the stall speed increases. B- varies with the rate of turn. C- is constant and the stall speed decreases. Aviation Seminars Comm.
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#3216. If an airplane weighs 4,500 pounds, what approximate weight would the airplane structure be required to support during a 45 degree banked turn while maintaining altitude? A- 4,500 pounds. B- 6,750 pounds. C- 7,200 pounds. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#5195. To maintain altitude during a turn, the angle of attack must be increased to compensate for the decrease in the A- forces opposing the resultant component of drag. B- vertical component of lift. C- horizontal component of lift. Comm. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#3311. The angle of attack at which an airplane wing stalls will A- increase if the CG is moved forward. B- change with an increase in gross weight. C- remain the same regardless of gross weight. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#5221. What is the stall speed of an airplane under a load factor of 2 G’s if the un-accelerated stall speed is 60 knots?(Use fig. 4) A- 66 knots. B- 74 knots. C- 84 knots. Aviation Seminars Comm.
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#3220. What is one purpose of wing flaps? A- To enable to pilot to make steeper approaches to a landing without increasing airspeed. B- To relieve the pilot of maintaining continuous pressure on the controls. C- To decrease wing area to vary the lift. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#3303. Which aileron positions should a pilot generally use when taxiing in strong quartering headwinds? A- Aileron up on the side from which the wind is blowing. B- Aileron down on the side from which the wind is blowing. C- Ailerons neutral. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#5656. While taxiing a light, high-wing airplane during strong quartering tailwinds, the aileron control should be positioned A- neutral at all times. B- toward the direction from which the wind is blowing. C- opposite the direction from which the wind is blowing. Aviation Seminars Comm.
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#5227. Longitudinal dynamic instability in an airplane can be identified by A- bank oscillations becoming progressively steeper. B- pitch oscillations becoming progressively steeper. C- Trilatitudinal roll oscillations becoming progressively steeper. Comm. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#3305. How should the flight controls be held while taxiing a tricycle-gear equipped airplane into a left quartering headwind? A- Left aileron up, elevator neutral. B- Left aileron down, elevator neutral. C- Left aileron up, elevator down. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#5237. The reason for variations in geometric pitch (twisting) along a propeller blade is that it A- permits a relatively constant angle of incidence along its length when in cruising flight. B- prevents the portion of the bade near the hub from stalling during cruising flight. C- permits a relatively constant angle of attack along its length when in cruising flight. Comm. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#3209. When does P-factor cause the airplane to yaw to the left? A- When at low angles of attack. B- When at high angles of attack. C- When at high airspeeds. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#3223. One purpose of the dual ignition system on an aircraft engine is to provide for A- improved engine performance. B- uniform heat distribution. C- balanced cylinder head pressure. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#3653. How is engine operation controlled on an engine equipped with a constant-speed propeller? A- The throttle controls power output as registered on the manifold gauge and the propeller control regulates engine RPM. B- The throttle controls power output as registered on the manifold pressure gauge and the propeller control regulates a constant blade angle. C- The throttle controls engine RPM as registered on the tachometer and the mixture control regulates the power output. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#5174. If the ground wire between the magneto and the ignition switch becomes disconnected, the most noticeable result will be that the engine A- will not operate on the left magneto. B- cannot be started with the switch in the ‘ON’ position. C- cannot be shut down by turning the switch to the ‘OFF’ position. Aviation Seminars Comm.
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#5184. In aircraft equipped with constant-speed propellers and normally-aspirated engines, which procedure should be used to avoid placing undue stress on the engine components? A- When power is being decreased, reduce the RPM before reducing the manifold pressure. B- When power is being increased, increase the RPM before increasing the manifold pressure. C- When power is being increased or decreased, the RPM should be adjusted before the manifold pressure. Aviation Seminars Comm.
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#3244. For internal cooling, reciprocating aircraft engines are especially dependent on A- a properly functioning thermostat. B- air flowing over the exhaust manifold. C- the circulation of lubricating oil. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#3238. Detonation occurs in a reciprocating aircraft engine when A- the spark plugs are fouled or shorted out or the wiring is defective. B- hot spots in the combustion chamber ignite the fuel/air mixture in advance of normal ignition. C- the unburned charge in the cylinders explodes instead of burning normally. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#5667. To develop maximum power and thrust, a constant-speed propeller should be set to a blade angle that will produce a A- large angle of attack and low RPM. B- small angle of attack and high RPM. C- large angle of attack and high RPM. Aviation Seminars Comm.
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#3240. The uncontrolled firing of the fuel/air charge in advance of normal spark ignition is known as A- combustion. B- pre-ignition. C- detonation. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#3224. On aircraft equipped with fuel pumps, the practice of running a fuel tank dry before switching tanks is considered unwise because A- the engine-driven fuel pump or electric fuel boost pump may draw air into the system and cause vapor lock. B- the engine-driven fuel pump is lubricated by fuel and operating on a dry tank may cause pump failure. C- any foreign matter in the tank will be pumped into the fuel system. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#3226. The basic purpose of adjusting the fuel/air mixture control at altitude is to A- decrease the amount of fuel in the mixture in order to compensate for increased air density. B- decrease the fuel flow in order to compensate for decreased air density. C- increase the amount of fuel in the mixture to compensate for the decrease in pressure and density of the air. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#5609. Unless adjusted, the fuel/air mixture becomes richer with an increase in altitude because the amount of fuel A- decreases while the volume of air decreases. B- remains constant while the volume of air decreases. C- remains constant while the density of air decreases. Aviation Seminars Comm.
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#5767. Which is true regarding preheating an aircraft during cold weather operations? A- The cabin area as well as the engine should be preheated. B- The cabin area should not be preheated with portable heaters. C- Hot air should be blown directly at the engine through the air intakes. Aviation Seminars Comm.
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#3229. Which condition is most favorable to the development of carburetor icing? A- Any temperature below freezing and a relative humidity of less than 50 percent. B- Temperature between 32 and 50 degrees F and low humidity. C- Temperature between 20 and 70 degrees F and high humidity. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#3234. Generally speaking, the use of carburetor heat tends to A- decrease engine performance. B- increase engine performance. C- have no effect on engine performance. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#5768. If necessary to take off from a slushy runway, the freezing of landing gear mechanisms can be minimized by A- recycling the gear. B- delaying gear retraction. C- increasing the airspeed to “Vle” before retraction. Comm. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
That’s Right!!! Next Question Aviation Seminars
#3711. The most important rule to remember in the event of a power failure after becoming airborne is to A- immediately establish the proper gliding attitude. B- quickly check the fuel supply for possible fuel exhaustion. C- determine the wind direction to plan for the forced landing. Aviation Seminars
Sorry that is Incorrect. Go Back and Try Again. Aviation Seminars
Move on to the Next Section!!! That’s Right!!! Move on to the Next Section!!! Aviation Seminars