Jacto Incorporated, 9650 SW Herman Road, Tualatin, Oregon (800)

J-1000 is shipped in three crates 66” x 42” x 22” 506 lbs 131” x 59” x 47” 1496 lbs Large crate is the sprayer unit, packed within this crate will be the parts for assembly. In the smaller crate the axle and tires can be found below the bumper. Notice each crate has Serial Number. When assembling multiple units insure to match SN’s on the crates. 40” x 40” x 40” 417 lbs

Hoist the front of sprayer at the chassis. Attach the jack support to the front of the chassis using the pin and cotter key set provided with it. Insert the retaining pin with the jack in the upright position as shown below. Step One: Attach front jack support and tires to the axle... Secure a tire to each end of the axle using the 12 lug nuts provided.

The tracking axle linkage will attach here later, this should be facing forward on the right side of the sprayer. Hoist the rear of sprayer at the chassis. Position the axle with tires into position under the sprayer. Place the spacer between the chassis and the axle. Secure using the four bolts, lock washers, and nuts provided in accessories box. Step Two: Slide the crate bottom out and move the tires/axle in...

Step Three: Attach tongue and tank sump protective cover... Using the two long pin and cotter key sets. Attach the tongue to the bottom front of the sprayer. Insert the rear pin first (as the hole is slotted). Using the four bolts, washers, and nuts provided secure the tank sump protective cover to the tongue.

Step Four: Attach draw bar and tie rod to tracking axle... Slide the draw bar into the tongue, secure with washer, castle nut and cotter pin. Straighten up the tires. Rotate the tie rod clockwise to connect to tracking axle linkage. Adjust the distance of the tie rod so that the draw bar is squared. Use the nuts on the tie rod to tighten into position. After connecting the rear of the tie rod to the tracking axle and the draw bar is square, then connect the tie rod to the drawbar using the pin & cotter set. 1 - adjusts tracking axle 2 - adjusts wheel alignment

Step Five: Prepare chemical hose... Remove the two wing nuts and washers (one on each side) and lift off front hood. Unwrap all hoses and route them through the opening in the front of the hood. The black hose must be connected securely to the top/front of the pump. Replace the front hood.

Step Six: Install the chemical control valve... Affix the Control Valve Mount to the front of the chassis using the two (2) bolts provided. Attach the Control Valve to the mount using the two (2) bolts & nuts provided. Also, attach the chemical line as shown. Attach the chemical line as shown.

Step Six: Install the chemical control valve (continued)... Notice the lower connection for Black chemical hose from the pump uses two (2) retainers. Attach the Blue (chemical bypass) hose to the upper port by pulling out the retainer, pushing in hose connector and replacing retainer. Pulled Out Pushed In Connect the chemical hoses.

Step Seven: Install PTO and drive shaft cover... Slide the PTO onto the drive shaft then secure with the nut and bolt. Then slide the drive shaft cover over the PTO. Secure the drive shaft cover in place using the two bolts provided in the front of the chassis.

Step Eight: Install fan guard and rear bumper... Secure the rear bumper using the four bolts. Two on each side of the chassis. Fasten the fan guard into place using the bolts provided.

Step Nine: Assemble the Duct... First attach the fixed duct, Use 8 of the bolt/nut sets, there will be two larger bolts to attach to the chassis (circled) Second attach the revolving duct Use 6 of the long bolt/nut sets. Last attach the outlet duct using the long bolt going all the through