How to configure Linksys WRT-120N wireless Access-Point(AP) router 1. Your AP router config parameters can be found taped on top of your AP router 4. This port should connect to the internet 2. If you press down the reset button for 5 seconds, it will reset to factory defaults, in which case, you will need to go through this slides to configure it again to be functional. 3. Connect AP’s Ethernet port-1 to your laptop with a Ethernet cable

1. Open a browser, type in URL http://172. 168. 1 1. Open a browser, type in URL http://172.168.1.1, use the admin pwd to login. If you reset to factory defaults, search the user manual for the default admin pwd. 2. Configure the host name and domain name the same as your AP’s name. e.g. ParkmontCR13 3. Configure the static DNS server IP address. It should be provided by your Internet Service Provider. e.g. for AT&T 68.94.156.1 and 68.94.157.1 The rest are the same as defaults. 4. Click “Save Settings”, the AP will reset itself for about 30 seconds

6. Click on the “Wireless” tab, choose “Basic Wireless Settings” sub-tab. 7. Type in the AP’s name as SSID, e.g. ParkmontCR13. The rests are the same as defaults. 8. Click Save Settings

9. Click on the Wireless Security sub-tab 10. Choose “WPA Personal” as Security Mode 11. Enter your AP’s encryption key. 12. Click Save Settings. You’re done. The rests are the same as defaults.