Mar 30, 2011 – Workshop Seafloor geodesy – the need to respond to an imminent challenge Peter La Femina, Dept. of Geosciences, Penn State, USA Christoph.

Slides:



Advertisements
Similar presentations
Location and Damage from EQ. Where EQ Occur  Most EQ occur at plate boundaries  More EQ occur at transform faults than at other plate boundaries  Most.
Advertisements

Scientists divide the Earth
9.2 & 9.3 Plate Tectonics.
Plate Tectonics & how plates work. Transform boundary also called a conservative boundary Two tectonic plates slide past one another Convection currents.
1 Lab 506 ONLINE LESSON. 2 If viewing this lesson in Powerpoint Use down or up arrows to navigate.
Chapter 7 Plate Tectonics
Trench When two plates of oceanic crust collide, one plate sinks beneath the other. One of the plates is pushed beneath the deep-sea trench down toward.
Types of Plate Boundaries
The Deep Oceans. Take-Away Points 1.The earth has two kinds of crust 2.Continents have thick, light, granitic crust, Oceans have thin, dense, basaltic.
Features of the Ocean Floor
Warm Up 2/6/09 What technology do scientists use to measure ocean depth? a. sonar c. rope b. submersible d. laser Differences in ocean-surface height.
CHAPTER 2 Internal Structure of Earth and Plate Tectonics
PLATE TECTONICS Chapter 7 – Inside the Restless Earth
Plate Tectonics Objective(s): SWBAT describe the layers of the Earth. SWBAT describe the plate tectonics theory including, how plate tectonics operating.
1.3 Notes Plates Move Apart.
Chapter 14.2 Ocean Floor Features.
Bathymetry of the Ocean Floor The ocean floor is mapped by SONAR. (Sound navigation and ranging) Depth = (time x 1500 m/sec)/2 (round trip) At 25 degrees.
Section 4 Sea-Floor Spreading
1.___crust and the uppermost part of the mantle (Layers of the Earth) 2. ___plate boundary that plates slide past one another (plate boundaries) 3.___layer.
Plate tectonics II The oceans are where most of the action takes place.
Lumberton High Sci Vis II V  The surface of the Earth is broken into large pieces of earth called plates.  These plates float over an inner molten.
Geologic hazards & space geodesy part 1: Introduction.
CHAPTER 5: Earth dynamics
Introduction to Geology Summer HSSP 2007 Einat Lev & Christy Till Dept. of Earth, Atmospheric, and Planetary Sciences MIT Einat Lev & Christy Till Dept.
Obj: What is the Theory of Plate Tectonics? Copy the following questions in your notebook: TABLE 1 (7)- What is a mid ocean ridge? TABLE 2 (8)-What is.
Evidence for Plate Tectonics Seafloor mapping using sonar initiated during World War II provided evidence of drifting continents This caused scientists.
Seafloor Spreading 5.4 p
Lecture #1 Section 14.1 & Section 14.1 Earth is a Dynamic Planet A Layered Sphere – Core - interior composed of dense, intensely hot metal, mostly.
Plate Tectonics Seafloor Spreading. Plate Tectonics 4 – Name the four main layers of the earth from inside to outer most layer. 3 – Name the three physical.
Mid-Ocean Ridges JdFR MAR CIR EPR SWIR PAR SEIR Thuan Chau, Yao Yao.
Theory of Plate Tectonics. Power of Plate Motion Chilean Earthquake Chile Quake Poses Possible Hawaii Tsunami Threat Major Earthquake in Hati 2010.
III. Layers of the Earth. IV. Plate Boundaries.
Test Review. The hypothesis that continents slowly move across Earth’s surface.
 The theory of plate tectonics explains the formation, movements, and subduction of the earth’s plates. ◦ What is a plate?  A section of lithosphere.
CH 14.1 The Ocean Floor Oceanography – the study…
Plate Tectonics A Brief Overview. The Earth’s Plates
Plate Tectonics Earth Science. Continental Drift Alfred Wegener proposed the idea of continental drift in Looking at the continents, it is possible.
Plate Tectonics.
Section 4: Sea-Floor Spreading
Development of Sea Floor Spreading DSDP 1950,s. SONAR.
Ch. 20 The Ocean Basins Ch Features of the Ocean Floor.
19 Chapter 19 Oceanography. The Blue Planet 19.1 The Seafloor  Nearly 71 percent of Earth’s surface is covered by the global ocean.  Oceanography is.
Plate Tectonics Plate tectonics is the theory that explains why and how continents move and is the study of the formation of features in the earth’s crust.
Plate Boundaries. Types of Crust Continental Crust Less dense granite Oceanic Crust More dense basalt.
Forces that Shape the Earth
(Modified from) Chapter 2 Plate Tectonics and the Ocean Floor Essentials of Oceanography 7 th Edition.
Types of Plate Boundaries After completing this section, students will identify that the Earth is made of geologic plates (Standard PI-041) and investigate.
The Theory of Plate Tectonics The Earth’s crust is broken up into plates which move around on top of the mantle **Driven by convection currents**
Plate Tectonics. Theory of Plate Tectonics Meaning – “plate structure” Developed – 1960’s (50 years after Wegener) The Earth is divided into approximately.
Plate Tectonics Guilford County Sci Vis V Theory of Plate Tectonics  The surface of the Earth is broken into large pieces of earth called plates.
 Lithosphere is broken into huge plates and float on the asthenosphere. How Plates Move.
Falcon Focus Rank the four main layers of the earth from least dense to most dense. What causes the plate tectonics to move?
Earth’s interior. Geologist have used evidence to learn about the Earth’s interior: Direct evidence and indirect evidence. Geologist have used evidence.
Ge 277- ‘Active tectonics of the Eastern Mediterranee’ – Regional active deformation from geodesy and seismicity – Regional tectonics in the context of.
Earth’s Plate Boundaries Tectonic cycle: Involves creation and destruction of the solid outer layer of Earth, the lithosphere # of Plates? Active Areas?
Major Geological Events
a. Hypothesized that all the continents were once joined together in a single landmass and have since drifted apart. b. This theory is called continental.
Crustal Features and plate boundaries
The Ocean Basins Physical Oceanography. Plate Tectonics Results in Sea Floor Features.
Measuring bathymetry Ocean depths and topography of ocean floor
Theory of plate tectonics
Continental Rift Valley
Plate Tectonics Evolution of the Earth.
Section 3: Plate Boundaries
Plate tectonics vocabulary review
The Deep Oceans.
Ocean Floor.
8th Grade Dynamic Earth (Mod E) U4L2: Plate Tectonics
Plate Tectonics.
Warm Up 2/6/07 Name Earth’s four main ocean basins.
Presentation transcript:

Mar 30, 2011 – Workshop Seafloor geodesy – the need to respond to an imminent challenge Peter La Femina, Dept. of Geosciences, Penn State, USA Christoph Waldmann, Achim Kopf Center of Marine Environmental Sciences, MARUM, Germany

Most seismic and volcanic activity on Earth occurs underwater. This includes approximately 60,000 km of mid-ocean spreading ridges, where oceanic plates grow by volcano-tectonic processes, and associated transform faults. The most actively deforming portions of the world’s 55,000 km of subduction zones are covered by water Substantial seafloor deformation is also associated with submarine land-sliding, hydrocarbon extraction, and CO2 injection into submarine reservoirs. The Challenges in Seafloor Geodesy

Despite the progress that has been made over the past three decades, seafloor geodesy is only slowly beginning to transition from demonstration projects to comprehensive monitoring systems. We expect that the development of more advanced and lower-cost seafloor geodetic systems will lead to more comprehensive monitoring of a wide range of submarine deformation processes and the hazards and resources they reveal. Bürgmann, Chadwell, Seafloor Geodesy, Annu. Rev. Earth Planet. Sci :509–34 The Challenges in Seafloor Geodesy

GPS-A using kinematic GPS positioning of a ship or buoy to precisely determine the location of a transponder array on the seafloor in a global reference frame. The Challenges in Seafloor Geodesy - Technology Required precision – cm Current precision - ~ m

In Europe, Canada, and the USA there are a number of groups active in this field to investigate: Triggering effects of Tsunami events Impact of landslides Impact of human intervention/impacts on the deep sea, i.e., deep sea hydrocarbon extraction and mining activities. A closer exchange between working groups across the Atlantic is needed to target specific regions and make results intercomparable. The transatlantic perspective

Develop a transatlantic marine geodesy working group or organize workshops to: Narrow down the requirements on seafloor geodesy based on existing knowledge & technologies Carry out a systematic inter-comparison of methods Explore alternative approaches (laser ranging) Suggest a concept that allows for verification of methods and validation of results Synchronize with terrestrial techniques and projects The suggested approach