4 Amp Load.500 Hard Line Cable SPSM 2 P/S Setup Configuration RF Signal Supplied by RG-6 RF Signal To TV via RG-6 Remove Central Fuse Move 20A fuse from.

Slides:

Advertisements

Similar presentations

Parallel Circuits 8 Note Boxes. Quick Review The electrons that move to make electricity come mostly from the wires in the circuit, not the battery. Metals.

Advertisements

20.3 Electric Circuits Ms. Kammerer.

1 Troubleshooting. 2 Introduction This section provides you with the necessary skills to effectively troubleshoot the DIRECTV System.

Super Beast- Three-Phase WYE Application

AP Electricity Quiz Review

An Introduction to EV Wiring By Charlton Jones Gateway EV Washington, MO.

Circuits Energy & Environment. Simple Circuit G -ve +ve Wire Lamp Switch Fuse Battery Power Source Safety Device Controlling Device Purpose Connect circuit.

ECE 201 Circuit Theory I1 General Solution for Natural and Step Responses of RL and RC Circuits Final Value Initial Value Time Constant Determine the initial.

Vex 1.0 © 2006 Carnegie Mellon Robotics Academy Inc. Test Bed Assembly.

ECE 201 Circuit Theory I1 Step Response of an RC Circuit + v C (t) - i(t) Close the switch at t = 0 Write KCL at the top node Allow for the possibility.

Parallel Circuit electricity has more than one path to follow total amps are equal to the sum of the individual amps total watts are equal to the sum of.

Capacitive Charging, Discharging, and Simple Waveshaping Circuits

Copyright © 2007 Heathkit Company, Inc. All Rights Reserved PC Fundamentals Presentation 2 – The Power Supply.

1 Electronic Circuits COMMON EMITTER CIRCUITS. 2 Electronic Circuits AMPLIFIERS CAN BE CLASSIFIED AS EITHER: VOLTAGE AMPS POWER AMPS AMPLIFIERS CAN BE.

Ohm’s Law Review. Division Review 15 ÷ ÷ ÷ 2.3.

Computer… An electronic machine Monitor Mouse Printer (Inkjet) Key Board Cabinet UPS PPT

Electricity Foundations of Physics. Electricity The movement of charge from one place to another Requires energy to move the charge Also requires conductors.

Current and Resistance

ELECTRICITY Summary Notes. 1.R EVISION OF PS E LECTRICITY ( A ) When drawing components in an electric circuit, SYMBOLS are used componentsymbolenergy.

1 Exercise 1 Computer Hardware. 2 Objectives for Exercise 1 When you complete this exercise, you will be able to:

Circuit Design Magic of Electrons © 2011 Project Lead The Way, Inc.

Circuit Lab. Experiment-4 Measurement of Time Constant, Rise Time, Step Response of a RC Circuit.

RF Signal Cables W. Udo Schröder, 2011 Principles Meas/Electronics 2 RG59/U coaxial cable (BNC) Stiffer than RG58 75 Ohm impedance Dual shielded cable:

Mains electricity Revise the following Direct and alternating current 3-pin plugs and electrical cable Safety – fuses and earth wire Period and frequency.

FSS Review 18th August Opto-isolator:Opto-isolator: Top 4 frequency bits set by DIP switchTop 4 frequency bits set by DIP switch FPGA controls bits.

Electricity Jeopardy Circuits 1 Circuits 2 Electric Current OhmExtra Q $100 Q $200 Q $300 Q $400 Q $500 Q $100 Q $200 Q $300 Q $400 Q $500 Final Jeopardy.

Presentation of the DriveLab Board Opal-RT Real-time institute 2009.

UNIT V STUDY GUIDE Electricity & Magnetism

Electric Circuits Series and Parallel Circuits. Circuit Diagrams An electric circuit is a complete path through which charge can flow Circuit diagrams.

Name here 52 pts. Voltage (volts)Current(amps)Resistance(ohms) Use game to fill in the blanks Screenshot symbol 10 pts.

Physics 2225: Working With Electronic Equipment Purpose  Learn how to use basic electronic equipment: Digital multi meter Oscilloscope Function generator.

Complex Circuits Notes Series Circuit + Parallel Circuit = Complex Circuit.

The 13 Amp PLUG Fuse Insulating Casing Live Wire Neutral Cable grip Flexible Copper conductors Earth.

Power Plant Construction and QA/QC Section 4.4 – In-Plant Electrical Distribution Engineering Technology Division.

Inverter power supply symptoms can be typically broken down into the following categories: 1. All Outputs Normal: 2. All Outputs Dead (no output): 3.

SAMPLE AND HOLD CIRCUIT. CIRCUIT CONSTRUCTION The circuit samples the input and holds the last sample until the input sampled again. The circuit has an.

Electricity Notes 5 Electric Power – the rate at which _______________________ the rate at which _____________________ is converted into another form of.

The following pages contain a number of architectural designs that can be applied to a broadband network. The application of the SPSM in a network is limited.

Electrical Circuits Making Electricity Useful Circuit Diagrams Electrical circuits can be shown in diagrams using symbols: 9.0V.

U3e-L3 1.Why are the + and – symbols unnecessary when drawing the power source in an electric schematic? 2.A ______ circuit occurs when the positive terminal.

WELCOME BACK! Agenda: 1. New Vocabulary 2. #throwbackthursday: Questions of the Day: # Circuit Design Homework: None Thursday, March 3, 2016 Objective:

Electrical signaldigital signal Actuators and acting.

SeaPerch Electrical System. Electrical System Overview Assemble the control box. Make the Cat5 connector. Wire the motors to the tether. Wire the control.

P2 - Physics Mains Electricity

Series Circuit What is a Series Circuit? Series Circuit Series Circuit – all parts are connected in a single loop (only one path).

Chapter 6.3 Notes Electrical Power. Voltage causes charges to move in circuits. This movement creates work. How fast the charge does work is called Power.

Basic Electricity END. 2 3 Cable and wire construction 1. Single core wire. 2. Single core multi-strand wire. 3.Two core multi-strand wire.

Power Supply. 2 Power Supply w/Line Conditioner The power supply is the heart of the Millenium System. It can support between 15 DCD boards (power for.

5.8 Circuits:  A circuit is made up of a power supply, connecting wires & various components that allow current to leave a power source, travel through.

WARM UP Draw a picture of a SERIES Circuit. Show a battery, a switch, and a light bulb in your drawing. Draw a picture of a PARALLEL Circuit. Show a battery,

You build the following circuits

SeaPerch Electrical System

Engineering Technology Division

Aim: How is a Series Circuit different from a Parallel Circuit?

Do Now: Why does current not come from a battery? Explain.

Chassis Power Regulator Board

University of Wisconsin-Madison / SSEC

The Ideal Op Amp Inverting and non-Inverting configurations

Author: Mike McCurry & Garrett Swindell

Using DMMs Part 2.

The Ideal Op Amp Inverting and non-Inverting configurations

Circuits & Switches An electrical current will only flow if there is a complete pathway through which the electrons can move. This pathway is called an.

P2 - Physics Mains Electricity.

Electric Circuits.

Electric Circuits.

LOAD CONTROLLERS & LOADS.

SeaPerch Electrical System

Presented by: HJ Arnett Industries, LLC

Presentation transcript:

4 Amp Load.500 Hard Line Cable SPSM 2 P/S Setup Configuration RF Signal Supplied by RG-6 RF Signal To TV via RG-6 Remove Central Fuse Move 20A fuse from spare location to fused location 1 Short Test PPT Final

4 Amp Load.500 Hard Line Cable SPSM 4 P/S Setup Configuration RF Signal Supplied by RG-6 RF Signal To TV via RG-6 Remove Central Fuse 2 Short Test PPT Final

.500 Hard Line Cable SPSM 4 P/S Setup Configuration Short Circuit RF Signal Supplied by RG-6 RF Signal To TV via RG-6 150’ – 22 Volts – 15 Amp Draw On P/S 3 75’ – 20 Volts – 15 Amp Draw On P/S 3 36’ – 18 Volts – 15 Amp Draw On P/S 3 18’ – 12 Volts – 15 Amp Draw On P/S 3 Remove Central Fuse Wrap braid around center conductor to create short. 20 Amp Fuse 20 Amp Fuse Location used to measure voltage 3 Short Test PPT Final

.500 Hard Line Cable SPSM 4 P/S Setup Configuration Short Circuit RF Signal Supplied by RG-6 RF Signal To TV via RG-6 With Mother Board Removed Created Short using Barrel Connector and Paper Clip, voltage was measured at this location. This yielded the 0 Volts Remove Central Fuse 4 Short Test PPT Final

.500 Hard Line Cable SPSM 2 P/S Setup Configuration Short Circuit RF Signal Supplied by RG-6 RF Signal To TV via RG-6 This yielded the 0 Volts Remove Central Fuse Move 20A fuse from spare location to fused location Remove Central Fuse With Mother Board Removed Created Short using Barrel Connector and Paper Clip, voltage was measured at this location. 5 Short Test PPT Final

.500 Hard Line Cable SPSM 2 P/S Short Circuit Applied Initial RF Signal Supplied by RG-6 RF Signal To TV via RG-6 This yielded the 0 Volts Short Applied Measured amp draw cycled between 1 to 2 Amps Measured amp draw 26 Amps Measured Voltage 87.8 Volts Switch would cycle Measured Voltage 0.0 Volts With Mother Board Removed Created Short using Barrel Connector and Paper Clip, voltage was measured at this location. 6 Short Test PPT Final

.500 Hard Line Cable SPSM 2 P/S Short Circuit Applied After 15 to 30 seconds RF Signal Supplied by RG-6 RF Signal To TV via RG-6 This yielded the 0 Volts measured at pin connector. Short Applied Measured amp draw 15 Amps constant Measured amp draw 15 Amps Measured Voltage 87.8 Volts Cycle of switch would stop Fuse would blow here next to applied short With Mother Board Removed Created Short using Barrel Connector and Paper Clip, voltage was measured at this location. 7 Short Test PPT Final