Technician License Course Chapter 2 Radio and Electronics Fundamentals Equipment Definitions Hour-1.

Slides:



Advertisements
Similar presentations
Amateur Radio Technician Class Element 2 Course Presentation
Advertisements

Amateur Radio Technician Class Element 2 Course Presentation ELEMENT 2 SUBELEMENTS T1 - FCC Rules, station license responsibilities T2 - Control operator.
Amateur Radio Technician Class Element 2 Course Presentation
Amateur Radio Technician Class Element 2 Course Presentation
Technician License Course Chapter 3 Operating Station Equipment Repeater Operation and Data Modes.
AMATEUR RADIO TRAINING
Technician License Class
SUBELEMENT T4 [2 Exam Questions - 2 Groups] Amateur radio practices and station setup.
Technician Licensing Class Supplement T4, Questions Only Amateur Radio Practices 2 Exam Questions, 2 Groups.
Technician License Course Chapter 3 Types of Radios and Radio Circuits Module 7.
Circuit Analysis and Troubleshooting A Six Step Procedure Created by Jimmie Fouts Houston County Career Academy for.
Technician License Course Chapter 3 Types of Radios and Radio Circuits Module 7.
Technician License Course Chapter 3 Operating Station Equipment Transmitters, Receivers and Transceivers.
Technician License Course Chapter 2 Radio and Electronics Fundamentals
Technician License Course Chapter 3 Electricity, Components and Circuits Lesson Plan Module 6.
Technician License Course Chapter 3 Lesson Plan Module 7 – Types of Radio Circuits.
Electricity, Electronics And Ham Radio “Kopertroniks” By Nick Guydosh 4/12/07.
Basic Radio Set-Ups and Operations Compare Book Chapter 2 sections 2.4 and 2.5.
The Communication Concepts Model: A Look into the Cellular Phone Voice Call By: Brianna Person.
TELECOMMUNICATIONS –Communication over a long distance; deals with devices used to transmit and receive messages over a distance. –Examples: Telegraph.
Technician License Course Chapter 5 Amateur Radio Equipment Lesson Plan Module 12: Power Supplies and Batteries & RF Interference (RFI)
Introduction to Data communication
Technician License Course Chapter 5 Amateur Radio Equipment Lesson Plan Module 12: Power Supplies and Batteries & RF Interference (RFI)
COMMUNICATION GADGETS
Technician License Course Chapter 5 Operating Station Equipment Lesson Plan Module 11: Transmitters, Receivers and Transceivers.
Technician License Course Chapter 2 Lesson Plan Module 2 – Radio Signals and Waves.
Technician License Course Chapter 3 Types of Radios and Radio Circuits Module 7 Presented by: The Brookhaven National Laboratory Amateur Radio Club Instructor:
NIS – PHYSICAL SCIENCE Lecture 65 Radio Communication Ozgur Unal 1.
Technician License Course Chapter 4 Lesson Plan Module 9 – Antenna Fundamentals, Feed Lines & SWR.
Technician License Course Chapter 2 Radio and Electronics Fundamentals
Technician License Course Chapter 2 Lesson Plan Module 3 – Modulation and Bandwidth.
Technician License Course Chapter 2 Lesson Plan Module 2 – Radio Signals and Waves.
Technician License Course Chapter 2 Lesson Plan Module 3 – Radio Equipment Basics.
Hi-Landers Ham Class Instructed by Rich Bugarin W6EC.
Ham Radio Technician Class Licensing Course Chapter 1 Lesson Plan Module 1 – Welcome to Amateur Radio.
Radio Merit Badge Boy Scouts of America
TELECOMMUNICATION. Communication over a long distance.
Technician Licensing Class Your First Radio Valid July 1, 2014 Through June 30, 2018.
Technician License Course Chapter 3 Operating Station Equipment Power Supplies and Batteries Handheld Transceivers RF Interference (RFI)
Technician License Course Chapter 2 Lesson Plan Module 3 – Radio Equipment Basics.
Clint Miller KCØJUO and Paul Cowley KB7VML Story County ARES January 16 th, 2016.
Your First Ham Radio Station PARC 03-Mar-2016 Jim Hicks.
Radio Equipment. Review: On the Transmitter Side The purpose of radio communications is to transfer information from one point to another. The information.
Establishing & Equipping a Station  VHF or UHF station  HF station.
Senior Science Information Systems
AMATEUR RADIO TRAINING Transmitters & Receivers Release: v1.21 hamtrain.co.uk.
Radio Communication SL/HL – Option F.1. Radio communication includes any form of communication that uses radio (EM) waves to transfer information –TV,
Equipment Definitions
Basic Electricity Circuits
AMATEUR RADIO TRAINING
AMATEUR RADIO TRAINING
Technician License Course Module Ten Operating Station Equipment
Technician Licensing Class
Technician Licensing Class
Technician License Course Chapter 2
Technician Licensing Class
Technician Licensing Class
Technician Licensing Class
Technician Licensing Class
Radio Frequency Interference
Circuit Analysis and Troubleshooting
ELECTROMAGNETIC WAVES Radio Communication
A. Talk louder into the microphone B. Let the transceiver cool off
A. Linearity B. Sensitivity C. Selectivity
A. The output power might be too high
What must be considered to determine the minimum current capacity needed for a transceiver power supply? A. Efficiency of the transmitter at full power.
Roanoke Valley Amateur Radio Club
Technician License Course Chapter 3
Unit 5: Evolution of Technology in Science Topic: Wave Transmissions
Presentation transcript:

Technician License Course Chapter 2 Radio and Electronics Fundamentals Equipment Definitions Hour-1

Basic Station Organization Station Equipment –Receiver –Transmitter –Antenna –Power Supply Accessory Station Equipment Repeaters

What Happens During Radio Communication? Transmitting (sending a signal): –Information (voice, data, video, commands, etc.) is converted to electronic form. –The information in electronic form is attached or embedded on a radio wave (a carrier). –The radio wave is sent out from the station antenna into space.

What Happens During Radio Communication? Receiving end: –The radio wave (carrier) with the information is intercepted by the receiving station antenna. –The receiver extracts the information from the carrier wave. –The information is then presented to the user in a format that can be understood (sound, picture, words on a computer screen, response to a command).

What Happens During Radio Communication? This sounds pretty simple, but it in reality is pretty complex. This complexity is one thing that makes ham radio fun…learning all about how radios work. Don’t be intimidated. You will be required to only know the basics, but you can learn as much about the “art and science” of radio as you want.

The Basic Radio Station

The Receiver and Controls Main tuning dial for received frequency (or channel) selection. Frequency display. Volume control. Other accessory controls for mode (kind of information to process), filters (to mitigate interference), etc.

The Transmitter and Controls Main tuning dial for transmitted frequency (or channel) selection. Frequency display. Power control (transmitted signal strength). Other accessory controls for mode (kind of information to process), etc.

The Transceiver You will notice that many of the controls of the transmitter and receiver are the same. Most modern transmitters and receivers are combined in one unit – called a transceiver. –Saves space –Cost less Many common electronic circuits are shared in the transceiver.

Transceiver Controls Some are physical knobs that you manually adjust. Some are controlled by computer and you control the settings with keypad entries that program a computer in the transceiver.

Antenna The antenna exposes your station to the world. –Facilitates the radiation of your signal into space (electromagnetic radiation). –Intercepts someone else’s signal. Most times the transmitting and receiving antenna are the same antenna. Connected to your station by a connecting wire called a feed line.

Transmit/Receive (TR) Switch If the station antenna is shared between the transmitter and receiver, the TR switch allows the antenna to be switched to the transmitter when sending and to the receiver when receiving. –In a transceiver, this TR switch is inside the unit and requires no attention by the operator.

Power Supply Your radio station needs some sort of power to operate. –Battery –Household current converted to proper voltage –Alternative sources

Power Supply Most modern radios operate on 12 volts direct current (dc). –A power supply converts household current to the type of current and the correct voltage to operate your station. –Could be internal, might be external. You are probably familiar with common “wall- wart” power supplies.

Basic Station Accessories Human interface accessories: –Microphones –Speakers –Earphones –Computer –Morse code key –TV camera –Etc. Station performance accessories: –Antenna tuner –SWR meter (antenna match checker) –Amplifier –Antenna rotator (turning antenna) –Filters –Etc.

Accessory Equipment

Special Stations You Will Use (Repeaters) Repeaters are automated stations located at high places that receive and then retransmit your signal – simultaneously. –Dramatically improves range. The basic components of a repeater are the same as your station: receiver, transmitter, antenna and power supply.

Repeaters But, repeaters are transmitting and receiving at the same time using the same antenna. This requires a very high quality and specialized filter to prevent the transmitted signal from overpowering the receiver. This specialized filter is called a duplexer.

Repeater