Insulation for Heating and Plumbing SH/Armaflex. 2 Grey FEF material for heating and plumbing: standard tubes and self-adhesive tubes with tangential.

Slides:

Advertisements

Similar presentations

Energy efficiency for gas-fired and oil-fired domestic heating and hot water systems Session 6: Identify requirements of the minimum standards for the.

Advertisements

Arma-Chek R Covering Systems STANDARD FEF PRODUCTS.

HEATING AND PLUMBING FEF

Low Smoke Emission Products:

Armaflex Solutions For Cooling, Refrigeration

Product Presentation Armaflex ® Rail SD © Armacell Enterprise GmbH VENTILATION Armaflex Duct Systems.

ARMAFLEX XG STANDARD FEF PRODUCTS STANDARD FEF PRODUCTS

Home Insulation By: Jeff Krise. Introduction Analyze the rate of heat transfer from the attic to the interior of the home. Based on summer average temperatures.

AWG 36, 0.2 A 0.3 mm Heat Shrink Tubing t = 0.38 mm Silicone Coating t = 0.2 mm D = 3 mm Shielding: Copper Tape AWG 26, 2.2A 0.6 mm AWG 26, 2.2A 0.6 mm.

Aluminum/Titanium Comparison Aluminum alloy Titanium Alloy Property7075-T6 (ww-T-700) drawn tubing7075-T6; 7075-T651Grade 5 Ti6Al4V% Different SourceCasing.xlsMatweb.

Water heater P L Solar Thermal Systems Flat plate type.

Armaflex Solutions For Heating and Plumbing. Heating and Plumbing 2 Insulation main target: Limit heat losses (energy savings) Noise control Condensation.

SERVICE CENTER FACILITIES.

ARMAFLEX Ultima SPECIAL FEF PRODUCTS

Coverings Systems Range Arma-Chek. Covering Systems 2 Main target: provide UV protection and increase the insulation life expectancy reduce risk of CUI.

Nonrenewable energy is energy that comes from the ground and is not replaced in a relatively short amount of time. Fossil fuels are the main category.

1. Supporting a veneer. 2. Fleece for Veneer in fleece backing laminating machine. 3. Fleece for Veneer in Press. 4. Finger jointing tape. 5. Fleece-Gauze.

2-d Insulation Analysis of Clamp / Vacuum Vessel Insulation crushing

Polymers Poly-vinyl Chloride (PVC). What is PVC? PVC is a plastic material usually formed in lengths of tubing, and various junctions, (elbows, extensions,

Armaflex Solutions High Temperature and Solar Installations.

Design of Recuperative Heat Exchanger Presented by -- Jinying Zhu.

Structural and Thermal Calculation for Recuperative Heat Exchanger Recuperative Heat Exchanger Presented by -- Jinying Zhu.

Solar Ovens By: Juan Gomez Perry Francois-Edwards Luis Perez.

Chapter 4.4 Notes Resistance in Thermal Systems. In fluid systems, resistance opposes the flow of Fluid. In thermal systems, resistance opposes the flow.

Product Presentation Armaflex ® Rail SD © Armacell Enterprise GmbH VENTILATION Armaflex Duct Systems.

Heat Transfer Equations. Fouling Layers of dirt, particles, biological growth, etc. effect resistance to heat transfer We cannot predict fouling factors.

Evaluation of Modular Coil Cooldown Time with Thicker Insulation and Comparison of Original and Proposed Insulation Design H.M. Fan PPPL January 15, 2003.

Evaluation of Modular Coil Cooldown Time with Thicker Insulation and Comparison of Original and Proposed Insulation Design H.M. Fan PPPL January 14, 2003.

HEAT TRANSFER-CONDUCTION CONVECTION AND RADIATION.

HEATING AND PLUMBING PEF

Thermal Energy Transfer In Cans Of Water Created By Mason P & Anthony G.

Spacing of Cu clamp = 10” Clamp plate width = 2.5”, thickness = 0.375” Thickness of conductor insulation = 0.03” Thickness of coil ground wrap = 0.03”

Warm Up Monday 12/9/13 Today: Vocabulary: Insulators and Conductors for Fido Heat vs. Temp Review Sheet Record in Agenda: Heat Transfer Review Sheet (due.

Thermal Analysis Assumptions: Body Temperature (Environment) is 37˚C Heat distribution on outside of device will be modeled via FEA Heat transfer method.

Exercises for Q1. Insulated copper tube A thin walled 10 mm copper tube is used to transport a low-temperature refrigerant with a temperature that is.

Thermal and Chemical Energy. Thermal Energy Thermal Energy Thermal energy is kinetic energy because molecules are in motion. Temperature Temperature =

Energy Transfer Methods of energy Transfer Three ways energy is transferred: 1. Conduction- occurs between objects in direct contact. a. Objects.

TUTORIAL 1 7/3/2016.

Page 1 Lift/sliding door system PremiDoor 88 Pirmasens, February 2013.

The reading is 7.38 mm. The reading is 7.72 mm.

CHATS-AS 2011clam1 Integrated analysis of quench propagation in a system of magnetically coupled solenoids CHATS-AS 2011 Claudio Marinucci, Luca Bottura,

Beattie Passive: A new era for construction Bringing Passivhaus standards into everyday construction with the Beattie Passive patented certified continuously.

June Isolkenaf Mechanic Proprieties type Thickness Density Tract.streng. Elong. Dimens.Stability mm. Kg/m3 KPa % at - 25°C + 70 °C UNI.

The 3 Types of Heat Transfer

Soft Magnetic Business Unit

14-6 Heat Transfer: Conduction

Presentation by James and Hina

Axion Relics Thermal – mechanical simulation for a flange UHV 114/63 1D with copper gasket

Simulated thermal performance of triple vacuum glazing

Quiz Review Describe energy Describe work

WELCOME TO AEROLAM INSULATIONS.

Fire Extinguisher Sales & Service

Vocabulary Week 4.

TYPE YOUR TITLE HERE First Author1, Second Author2, Third Author3

Baseline (Aiming for 4): Relate the

Gyproc thermaline pir Keeping the warmth within; creating energy efficient homes.

PolyIsocyanuRate PIR stands for: What is PIR?

Comparison of heat loss with a wetsuit vs. without

Tests on a dummy facet of PIX upgrade using CO2 cooling

ProtectWALL 2CR Specification data HETEROGENEOUS VINYL

فلوشیپ اخلاق زیست پزشکی استادیار دانشگاه علوم پزشکی ایران

PRODUCT IDENTIFICATION STANDARD ACE FOAM SIZE (±1 TOLERANCE VALUE)

Data from MAS GCALOR with phojet min-bias events in ATLAS detector

Forms of Energy Unit 3 Part 2 Vocabulary.

Conduction Conduction is Touchin!.

ENERGY TRANSFORMATIONS Thermal Energy & Heat (P )

Complete chart for 18 minutes

$30-40k Green Energy Retrofitter

Presentation transcript:

Insulation for Heating and Plumbing SH/Armaflex

2 Grey FEF material for heating and plumbing: standard tubes and self-adhesive tubes with tangential cut sheets, selfadhesive sheets tapes Built in antlimicrobial MICROBAN protection Max. Temperature + 110°C SH/Armaflex – Insulation for Heating and Plumbing

SH/Armaflex – Heating and Plumbing 3 -Certify to fullfill LEED requirements, low VOC emissions Hospitals, Schools, Offices

SH/Armaflex insulation for heating and plumbing 4 Low thermal conductivity, ensures energy savings Thermal conductivity at temp. 40°C [W/(m·K)] Tubes SH 10x12 up to SH10x60 Other Tubes All Sheets 0,0360,040

SH/Armaflex – Insulation for Heating and Plumbing 5 Classified according to EN Tested acc. To EN (SBI) and EN ISO EuroClass Reaction to Fire Tubes ≤ 45mm Sheets 10mm B L -s3,d0C-s3,d0 Tubes > 45mmSheets 20 C L -s3,d0D-s3,d0 Tapes B-s3,d0

SH/Armaflex Product Range 6 Tubes 2m sticks OD mm 9-11 mm13 mm19 mm24 mm In.thickn Product code In.thickn Product code In.thickn Product code mm 1211SH-10x SH-10x015 SH-19x015SH-24x SH-10x018 SH-19x018SH-24x SH-10x022 SH-19x022SH-24x SH-10x028 SH-19x028SH-24x02836SH-36x SH-10x035 SH-19x035SH-24x03536SH-36x SH-10x042 SH-19x042SH-24x042 46SH-46x SH-10x048 SH-19x048SH-24x048 46SH-46x SH-10x054 SH-19x054 32SH-32x SH-10x060 SH-19x060 32SH-32x06050SH-50x SH-10x SH-10x076SH-13x076SH-19x076 44SH-44x07650SH-50x SH-10x089SH-13x089SH-19x089 52SH-52x SH-10x0108SH-13x SH-10x0114SH-13x0114SH-19x SH-62x0114

SH/Armaflex Product Range 7 SH/Armaflex Tubes 2m coils SH/Armaflex Sheets SH/Armaflex Tape 3 mm CodeLength mWidth mm SH-TAPE1550 Insulation thicknessCode 10SH SH OD mmInsulation thickness 10 mm 15SH-10x015E 18SH-10x018E 22SH-10x022E 28SH-10x028E

8 Thank you