Equipment Use In Occupancies  A receptacle shall not be grouped or ganged in enclosures with other receptacles unless they are so arranged so that voltage.

Slides:



Advertisements
Similar presentations
New Mexico FFA Agricultural Mechanics Career Development Event Electric Power.
Advertisements

Master Examination Practice Drill # O 1. Given: Two (2) rigid metal conduits (RMC) are to support a weatherproof 18 cu. In. device box, with threaded.
Master Examination Practice Drill # Ted “Smitty” Smith.
DAY 4 CHAPTER 3 CONDUCTOR SIZES,TYPES, ETC.. Continuous Load. A load where the maximum current is expected to continue for 3 hours or more. Continuous.
Master Examination Practice Drill # O Where a hotel has a stationary electric sign installed inside a decorative fountain, the sign shall be at.
AGENDA INTRODUCTION CELLS AND COMPONENTS PV PERFORMANCE PV APPLICATIONS CODES AND STANDARDS EMERGENCY RESPONSE.
Master Examination Practice Drill # (16) O 1. In commercial and industrial establishments, all 15- and 20- ampere, single-phase, 125 volt receptacles.
2014 CHANGES TWO MINUTE DRILL COPYRIGHT TED “SMITTY” SMITH ©2014.
By Carlin Bright. Electricity The flow of electrons in a conductor.
©Ted “Smitty” Smith This speed drill focuses on calculations that will be required for the journeyman and masters examination. The question slide.
Copyright 2005 Ted "Smitty" Smith Two Minute Drill Number Three Improving your skill in code Look Up Increasing Speed Drill.
Two Minute Drill Number 32- Journeyman Improving your skill in code Look Up Increasing Speed Drill Copyright 2008 Ted "Smitty" Smith.
Copyright 2008 Ted "Smitty" Smith Two Minute Drill Number 25- Residential Improving your skill in code Look Up Increasing Speed Drill.
©Ted “Smitty” Smith  This speed drill is designed to help you practice calculations. The slides will transition in three and one half minutes instead.
Two Minute Drill #8 Copyright 2005 Ted "Smitty" Smith Practice Code Look Up.
Two Minute Drill Number 26- Residential Improving your skill in code Look Up Increasing Speed Drill Copyright 2008 Ted "Smitty" Smith.
Two Minute Drill #9 Copyright 2005 Ted "Smitty" Smith.
COMMERCIAL ELECTRICAL (Chapter 11)
Two Minute Drill #10 Copyright 2005 Ted "Smitty" Smith.
Two Minute Drill Number 27- Residential Improving your skill in code Look Up Increasing Speed Drill Copyright 2008 Ted "Smitty" Smith.
Calculation Speed Drill # NEC
Smitty’s Speed Drills 2008 Code Drills Health Care Facilities (C) Copyright 2008 Ted "Smitty" Smith1.
Copyright 2005 Ted "Smitty" Smith Practice Code Look Up Two Minute Drill #6.
Copyright 2008 Ted "Smitty" Smith.  Left click on the presentation ICON located at the bottom of the slide directory to the left of the this slide. 
©Ted “Smitty” Smith This speed drill focuses on subjects that will be required for the journeyman and masters examination arranged by chapter of.
Two Minute Drill Number 23- Residential Improving your skill in code Look Up Increasing Speed Drill Copyright 2008 Ted "Smitty" Smith.
Two Minute Drill Number 31- Residential Improving your skill in code Look Up Increasing Speed Drill Copyright 2008 Ted "Smitty" Smith.
Two Minute Drill Number 22- Residential Improving your skill in code Look Up Increasing Speed Drill Copyright 2008 Ted "Smitty" Smith.
Improving your skill in code Look Up Increasing Speed Drill Copyright 2008 Ted "Smitty" Smith Two Minute Drill Number 24- Residential.
2008 Code Drills (C) Copyright 2008 Ted "Smitty" Smith 1 Smitty’s Speed Drills.
Ag. Mechanics for Beginning Teachers
Copyright 2008 Ted "Smitty" Smith Two Minute Drill Number 21- Residential Improving your skill in code Look Up Increasing Speed Drill.
ELECTRICAL WIRING WIRING BASICS Written by Bobby Joslin
P RACTICE C ODE L OOK U P Two Minute Drill #7 Copyright 2005 Ted "Smitty" Smith.
Smitty’s Two Minute Drill Grounding
Smitty’s Two Minute Drill Grounding
Agricultural Science Career Development Event Electric Power
Advanced Calculations Drill 1 for the 2011 NEC
License Examination Practice Drill
Special-Purpose Outlets— Electric Heating, Air Conditioning
Chapter 12 Branch Circuits and Feeders. Chapter 12 Branch Circuits and Feeders.
2011 Changes Two Minute Drill
Smitty’s Two Minute Drills
Smitty’s Two Minute Drill Overcurrent Protection
Smitty’s Two Minute Drill Mixed Content -05
Smitty’s Two Minute Drill #9: Special Occupancies
Practice Code Look Up Two Minute Drill #7
Conductors and Cables 2017 NEC
Ampacity Calculations and Overcurrent Protection 1
Calculation Speed Drill #1
AGENDA INTRODUCTION CELLS AND COMPONENTS PV PERFORMANCE
Calculations: Transformers and Service Conductor Calculations
Smitty’s Two Minute Drill #1: Feeders and Branch Circuits
Smitty’s Two Minute Drill Photovoltaic Systems
Overcurrent Protection— Fuses and Circuit Breakers
2014 Changes Two Minute Drill
Two Minute Drill Number 29- Conductors and Raceways
AGENDA INTRODUCTION CELLS AND COMPONENTS PV PERFORMANCE
Smitty’s Two Minute Drill Grounding and Bonding
2008 Code Drills Health Care Facilities
Smitty’s Two Minute Drill Services, Feeders, and Branch Circuits 1
Smitty’s Two Minute Drill Varied Number 7
Smitty’s Two Minute Drill The BIG 5 Drill 1
Two Minute Drill – Residential 2
Calculations Review Drill
Calculation Speed Drill Varied-1
Varied Calculations Drill 2
Presentation transcript:

Equipment Use In Occupancies

 A receptacle shall not be grouped or ganged in enclosures with other receptacles unless they are so arranged so that voltage between adjacent devices does not exceed __________________ volts unless they are installed in enclosures equipped with identified, securely installed barriers between adjacent devices.

 300 Volts  (G)

 Flexible, fine-stranded cables used in PV systems shall be terminated only with terminals, lugs, devices or connectors that are ____________________________.

 Identified and listed for such use  (F)

 A disconnecting means shall be provided for all ungrounded conductors derived from a stationary battery system over __________ volts.

 30 volts  480.5

 A clearly labeled emergency shutoff or control switch for the purpose of stopping the motors that provide power to the recirculation system and jet system shall be installed at a point readily accessible to the users and not less than _________ feet away if a spa is installed in other than a single family dwelling.

 5 feet 

 A 125V, 20 ampere rated receptacle installed in an agricultural livestock holding area which has an equipotential plane installed shall not require GFCI protection.  True  False

 (G)(1)

 A transformer insulated with a dielectric fluid indentified as nonflammable shall be permitted to be installed indoors or outdoors. Such transformers shall be installed in a vault if installed indoors and rated over ____________________ volts.

 volts 

 An electric radiant heating panel installed in poured concrete shall not exceed a rating of ___________ watts per square foot.

 33 watts per square foot  (A)

 The attachment plug cap for the power supply to a mobile home shall be a 3-pole, 4- wire, grounding type, rated _________ amperes if the mobile home is supplied with a power supply cord.

 50 amperes  (A)

 In one and two family dwellings, PV source circuits and PV output circuits that do not include lampholders, fixtures, or receptacles shall be permitted to have a maximum PV system voltage of ______________ volts.

 600 Volts  (C)

 In a Class I, Zone 0 hazardous location threaded entries into explosion proof or flame proof equipment by rigid metallic conduit shall be made up with at least ____________ threads fully engaged.

 Five threads  (E)

 When flexible cords are installed in an ambient temperature in excess of ________ degrees Fahrenheit, the ampacity of the conductors of the cord shall be derated.

 86 degree F  400.5(A)

 Panelboards equipped with snap switches rated at 30 amperes or less shall have a maximum overcurrent protection of _____________ amperes.

 200 amperes  (A)

 Fixed outdoor electric deicing and snow- melting equipment shall be considered as a ____________________ load.

 Continuous  426.4

 The maximum length of an extra hard usage type, 12 AWG flexible cord that will provide interconnection of partitions for office furniture shall be __________ feet.

 2 feet  (3)

 The minimum length of flexible cord used to provide power to a cord and plug connected, permanently installed trash compactor in a single family dwelling is ______________.

 3 feet  (B)(2)(2)

STOP End of Timed Drill The drill slides will now be repeated without the timer. Left click on the presentation to advance to the next slide.

 A receptacle shall not be grouped or ganged in enclosures with other receptacles unless they are so arranged so that voltage between adjacent devices does not exceed __________________ volts unless they are installed in enclosures equipped with identified, securely installed barriers between adjacent devices.

 300 Volts  (G)

 Flexible, fine-stranded cables used in PV systems shall be terminated only with terminals, lugs, devices or connectors that are ____________________________.

 Identified and listed for such use  (F)

 A disconnecting means shall be provided for all ungrounded conductors derived from a stationary battery system over __________ volts.

 30 volts  480.5

 A clearly labeled emergency shutoff or control switch for the purpose of stopping the motors that provide power to the recirculation system and jet system shall be installed at a point readily accessible to the users and not less than _________ feet away if a spa is installed in other than a single family dwelling.

 5 feet 

 A 125V, 20 ampere rated receptacle installed in an agricultural livestock holding area which has an equipotential plane installed shall not require GFCI protection.  True  False

 (G)(1)

 A transformer insulated with a dielectric fluid indentified as nonflammable shall be permitted to be installed indoors or outdoors. Such transformers shall be installed in a vault if installed indoors and rated over ____________________ volts.

 volts 

 An electric radiant heating panel installed in poured concrete shall not exceed a rating of ___________ watts per square foot.

 33 watts per square foot  (A)

 The attachment plug cap for the power supply to a mobile home shall be a 3-pole, 4- wire, grounding type, rated _________ amperes if the mobile home is supplied with a power supply cord.

 50 amperes  (A)

 In one and two family dwellings, PV source circuits and PV output circuits that do not include lampholders, fixtures, or receptacles shall be permitted to have a maximum PV system voltage of ______________ volts.

 600 Volts  (C)

 In a Class I, Zone 0 hazardous location threaded entries into explosion proof or flame proof equipment by rigid metallic conduit shall be made up with at least ____________ threads fully engaged.

 Five threads  (E)

 When flexible cords are installed in an ambient temperature in excess of ________ degrees Fahrenheit, the ampacity of the conductors of the cord shall be derated.

 86 degree F  400.5(A)

 Panelboards equipped with snap switches rated at 30 amperes or less shall have a maximum overcurrent protection of _____________ amperes.

 200 amperes  (A)

 Fixed outdoor electric deicing and snow- melting equipment shall be considered as a ____________________ load.

 Continuous  426.4

 The maximum length of an extra hard usage type, 12 AWG flexible cord that will provide interconnection of partitions for office furniture shall be __________ feet.

 2 feet  (3)

 The minimum length of flexible cord used to provide power to a cord and plug connected, permanently installed trash compactor in a single family dwelling is ______________.

 3 feet  (B)(2)(2)