Using LTPPBind to Select Crack-Sealing Materials Typical specifications for crack-sealing materials include sealant property evaluations at high, moderate,

Slides:

Advertisements

Similar presentations

TxACOL Workshop Texas Asphalt Concrete Overlay Design and Analysis System P1 Project Director: Dr. Dar-Hao Chen TTI Research Team: Sheng Hu,

Advertisements

From… Maintenance Technical Advisory Guide (MTAG) Chapter 1 Introduction.

POLYPATCH. PolyPatch: What is it? Hot-applied, pourable, self- adhesive patching material Hot-applied, pourable, self- adhesive patching material has.

1 Preserving Municipality Roadways Federal = 3% State = 20% Local = 77% 94% of paved roads have an Asphalt surface FHWA Source: Stephen R. Mueller,

Fatigue Characterization of Asphalt Binders with the Linear Amplitude Sweep (LAS) Cassie Hintz, Raul Velasquez, Hassan Tabatabaee, Hussain Bahia.

Chelsea Hanson  (Advisor: Eshan V. Dave  Department of Civil Engineering, University of Minnesota Duluth INTRODUCTION.

Development and Application of the Asphalt Mix Performance Tester Ramon Bonaquist, Ph.D., P.E Advanced Asphalt Technologies, LLC.

Asphalt Rubber Asphalt Concrete Friction Course Overlay as a Pavement Preservation Strategy K. Kaloush, K. Biligiri, M. Rodezno, M. Belshe Arizona State.

Pavement Design CE 453 Lecture 28.

Crack Treatment Sponsored by: Minnesota LTAP Center Presented by: Michael Marti, P.E. SRF Consulting Group, Inc. Dan Wegman, P.E. SemMaterials.

TURNER-FAIRBANK HIGHWAY RESEARCH CENTER AASHTO STANDING COMMITTEE ON HIGHWAYS Briefing on the Long-Term Pavement Performance Program Cheryl Allen Richter,

From… Maintenance Technical Advisory Guide (MTAG) Chapter 1 Introduction.

New Technologies Land on Airport Pavements Rocky Mountain Asphalt Conference February 18-20, 2009.

To receive your free valentines voice you have to connect your TomTom device to the TomTom HOME Desktop software:

Session 3-6 HMA Overlays.

From… Maintenance Technical Advisory Guide (MTAG) Chapter 4 Joint Resealing and Crack Sealing.

Understanding Crack Sealing Materials and Specification Requirements Prepared for 36 th Annual Rocky Mountain Asphalt Conference and Equipment Show Denver,

GUIDELINES AN INTRODUCTION TO: Evaluation TECHNICAL

AN INTRODUCTION TO: from the leading resource for education and information in the repair industry... TECHNICAL GUIDELINE S Guideline for Design, Installation,

Section 8.3 – Systems of Linear Equations - Determinants Using Determinants to Solve Systems of Equations A determinant is a value that is obtained from.

Rigid Pavement Design Deficiencies

AN INTRODUCTION TO: from the leading resource for education and information in the repair industry... TECHNICAL GUIDELINE S Guideline for Selecting Grouts.

TAM ETG Webinar #3 Network Life Cycle Analysis Part 1: Introduction and Overview Wednesday, July 8,

NSTS For Regulators. Agenda 1.NSTS Release Summary 2.Functionality/Enhancements 3.Scenarios/Demo 2.

LTPP Program Presented to the ACPA Professors Workshop Skokie, IL June 19, 2008 Long-Term Pavement Performance Program.

National Highway Institute Federal Highway Administration

PAVEMENT MAINTENANCE 1 Part 3: Potholes and Cracks Idaho Roads Scholar Program.

Chapter 3 Framework for Treatment Selection From… Maintenance Technical Advisory Guide (MTAG)

Enforcement: Reports & Queries FMCSA Portal CSA Phase II Release, Month Year v1.2.

LTPP Lessons Learned: Kansas SPS-2 July 17, 2013 Abilene, KS Gabe Cimini Database Manager, LTPP NRSC.

ODOT. Taking Care of What We Have. Asset Management, Life Cycle Analysis : A Three-Pronged Approach September 9th, 2015 Andrew Williams, Ohio DOT.

LTPP Lessons Learned: Delaware SPS-2 Wednesday April 9, 2014 SPS-2 Tech Day, Dover, DE Gabe Cimini Project Manager, LTPP North Atlantic Regional Support.

Mass Highway Department (MHD) Design Process Anticipate possible use of MHD funds Anticipate possible use of MHD funds New Design Guide for Project Development.

Grants.gov Application Process. Grants.gov 5-Step Process Accessing and submitting an application for an announcement (opportunity) through Grants.gov.

LTPP – Case Studies in Performance Data Mining Transportation Data Palooza – Processing Data Track May 9, 2013 US DOT HQ, Washington, D.C. Yan (Jane) Jiang,

MODULE 3-2 Crack Sealing. Learning Objectives  Describe the primary sealant types  Describe the major factors that affect performance  Describe conditions.

Comparison of Pavement Distresses Monitored by LTPP and State Agencies.

Using LTPP Data in Evaluating the Effectiveness of Pavement Smoothness.

Fog Seals and Rejuvenating Seal Subtask Group Progress Report CO-Chairs John Fox - Caltrans Bob McCrea-Industry A PPTG Partnering Accomplishment April.

MODULE 3-3 Patching With Bituminous Mixtures. Learning Objectives  Describe the conditions that require patching  Distinguish between hot-, cold-, and.

By Larry Galehouse, Director, National Center for Pavement Preservation and Jim Sorenson, Team Leader, FHWA Office of Asset Management by Larry Galehouse,

1 COMPARISON OF MPD VALUES FROM HIGH- SPEED LASER MEASUREMENTS WITH MPD FROM TWO STATIONARY DEVICES Rohan Perera, PhD, PE Soil and Materials Engineers,

Using Reflective Crack Interlayer-

CRACK SEAL SUBTASK GROUP Kelly McClain – CalTrans Co-chair Jim Chehovits – Crafco, Industry Co- Chair Wally Smith – Deery Corporation Steve Escobar - Apart.

Performance-Based Assessments in eDoctrina A teacher’s guide to accessing exam rubrics and entering performance-based exam results into eDoctrina.

Road Pavement Forum May 2006 Technical Guideline: The use of Modified Bituminous Binders in Road Construction (TG 1: 2001)

After receiving the confirmation , use the link and Login Id provided to retrieve your password.

Road Pavement Forum May 2006 REVISION Technical Guideline: The use of Modified Bituminous Binders in Road Construction (TG 1: 2001)

Using LTPP Data to Develop Spring Load Restrictions.

ORDINANCE # Authorizing $372,760 for traffic signal interconnect at 47 th Street and Emanuel Cleaver II Boulevard Start of project End of project.

UAE University E-book Access. Visit: & click the desired coursehttp://tinyurl.com/o3hvaky.

National Highway Institute 5-1 REV-2, JAN 2006 EQUIPMENT FACTORS AFFECTING INERTIAL PROFILER MEASUREMENTS BLOCK 5.

Design and Rehabilitation Strategies for Sustainable Concrete Pavements H. Thomas Yu Federal Highway Administration Office of Pavement Technology.

2013 Roads and Sidewalk Capital Programs Roads and Parks Maintenance Department Development & Infrastructure Division December 2, 2013.

Road Investment Decision Framework

STRONG NEIGHBORHOOD INITIATIVE Public Works Department January 30, 2007 Agenda item 8.01.

CITY OF BELLEVILLE ROAD IMPROVEMENTS PROGRAM

AdisInsight User Guide July 2015

Update from FHWA Emulsion Task Force

ACTIVATE SHORTCUT KEYS ON AN HP LAPTOP’S KEYBOARD.

Presenters: Sumon Roy1 and Badrul Ahsan1

Standard Operating Procedure

2018 Pavement Workshop May 23-24, 2018

GUIDELINES AN INTRODUCTION TO: Material Selection TECHNICAL

Crack Sealing Seminar.

Encounters: Forensic Evaluations Training Slideshow

Planning for Institutional Effectiveness PIE Planning & Resources

Pavement Structural Analysis

NRRA Pavement Workshop 2019

ACEC Designer Training

Presentation transcript:

Using LTPPBind to Select Crack-Sealing Materials Typical specifications for crack-sealing materials include sealant property evaluations at high, moderate, and low temperatures. The evaluations provide information on materials characteristics at those temperatures. Using LTPPBind, sealant properties at anticipated high and low temperatures can be evaluated or compared.

Obtain LTPPBind and LTPP Section data from the Long Term Pavement Performance (LTPP) program using LTPP InfoPave, by the following steps.. Using LTPPBind to Select Crack-Sealing Materials

Crack-Sealing Materials: Step 1...Crack-Sealing Materials: Step 1... Register or Sign in.

Crack-Sealing Materials: Step 2...Crack-Sealing Materials: Step 2... Go to: Tools Go to: LTPPBlind Download and Install

Locate which sections pertain to your study. Use filters to narrow search parameters. Crack-Sealing Materials: Step 3...Crack-Sealing Materials: Step 3...

Click desired section Crack-Sealing Materials: Step 3...Crack-Sealing Materials: Step 3... Click “Go To...”

Click “Section Summary Report” Crack-Sealing Materials: Step 3...Crack-Sealing Materials: Step 3...

Retrieve GPS coordinates and traffic data Crack-Sealing Materials: Step 4...Crack-Sealing Materials: Step 4...

LTPPBind Open LTPPBind Click “Select Sections”and “Coordinate” Crack-Sealing Materials: Step 5...Crack-Sealing Materials: Step 5...

LTPPBind Enter GPS coordinates from LTPP InfoPave Click “Apply” Crack-Sealing Materials: Step 5...Crack-Sealing Materials: Step 5...

LTPPBind Click “Report” Click “PG Binder Selection” Crack-Sealing Materials: Step 6...Crack-Sealing Materials: Step 6...

Determine high and low temperatures and save data for reference. Crack-Sealing Materials: Step 6...Crack-Sealing Materials: Step 6...

Reference a local/available sealant manufacture to select the appropriate sealant. Follow the guidelines provided. Crack-Sealing Materials: Step 7...Crack-Sealing Materials: Step 7...

An improved understanding of pavement temperatures and corresponding material properties helps highway agencies determine the sealant materials and installation methods that provide the best results. Using LTPPBind to design and select crack-sealing treatments will help improve pavement performance, ensure longer-lasting treatments, reduce repairs, and decrease life-cycle costs. Using LTPPBind to Select Crack-Sealing Materials

Questions?

References 1.Antonio Nieves. Using LTPPBind to Improve Crack Sealing in Asphalt Concrete Pavements. FHWA-RD , HRDI- 013/12-03(X00)E, December Crafco Inc., Sealant Selection Guide. 3.Long Term Pavement Performance. LTPP InfoPave.