■ Instruction Manual Thank you for purchasing this product. You are requested to use right, reading this instruction manual before use. Microwave Motion Activator (Automatic Door Sensor) SpecificationTypeSpecificationType POWER SUPPLYAC/DC 9V ~ AC/DC24V POWER CONSUMTION : STANDBY / OPERATION / MAINS FREQUENCY50 ~ 60Hz FREQUENCY10.525GHz etc.RELATIVE HUMIDITY0 ~ 95 % FUNCTION INDICATION LEDMOUNTING STYLEWALL TIME DELAY/hold TIMEREAL TIME / 0.5 SECMOUNTING HEIGHT2.0M ~ 2.50M RANGE (Level 1 ~ Level 4) 0.0M ∼ 1.6M DIMENTION(W*H*D)140 * 63 * 43mm OPERATING TEMP- 25'C ~ +60'CWEIGHT120g DETECTION ANGLE 40' ~ 160' COVER COLORSILVER or BLACK ■ Specification This sensor is a Microwave automatic door sensor applied Doppler radar principle. Please supply a voltage of AC/DC 9V ~ AC/DC 24V. It is possible to use in any circumstances and has few wrong operation. (It is reliable as it's not detected by shaking any paper or newspaper.) The detecting method is able to be setting as 4 level. When forward, it is setting as following : Sensitivity Level 2. ■ About Product: ■ Attentions for Installation. * The use of this product is the indoor. * This sensor has to be fixed not to sway. * Any fluorescent material must not to be in the detecting zone of this sensor. * Any mobile or vibratile object must not to be in the detecting zone of this sensor. * And, in case you dismantle product cover, please use screwdriver and grooves on the both sides to dismantle. If you don’t use those to dismantle by force, it may cause any damage on the product. ■ Installation Method. When make a hole in the wall for installation, to prevent an accident previously, Please confirm if there is not electric wire of other machineries in and around. At first, open the box and please confirm the accessories. Step 1 : please fasten a paper for installation on a position to install and please make holes with diameter of 3.5mm, a hole of wire with diameter of 10mm, in the indicated position of the paper. Step 2 : please remove the cover with screwdriver. Step 3 : please fasten the sensor body on the wall with the inner screw. DNA-200S (Accessories) 1. 2 screws for fixing. 2. A flexible cord with length of 1.5m. 3. A instruction manual. 4. A Installation Paper. ■ Opening the Sensor Cover ■ Establishment location of sensor.

Step 4 : please connect a wire of the body of sensor and a wire of automatic door system. The yellow wire is for output, gray is for power. The wire for power has not polarity(+,-). Step 5 : please set in moderation according to circumstances as below setting method. Step 6 : please fasten the connected wire on the body and unite the cover with body. Please set right for general operation of this product. All settings are adjusted by the ‘DIP Switch’. * Setting method of the sensitivity and detecting distance. * A sensing distance can have some difference(+/- 20cm) according to a moving object. ■ The Detecting Range: Dnet Co.,Ltd. Homepage : Tel: ,3544 Fax: ■ Description of the Sensor ■ Setting Method. Yellow(COM) Yellow(N/O) Grey (AC/DC)