with Barcode Reader :33

with Barcode Reader :33 Selection of barcode reader 1a. Select the button „Configuration“.

with Barcode Reader :33 1b. Click in the area which is coloured green in the drawing. This is the base configuration area.

with Barcode Reader :33 1c. Click the check box „Barcode reader“, so that it is checked. Hint: With „Barcode reader“ checked the „Edit mode“ box within the „Create Order Files“ window is hided. The barcode reader reads the ID and type. Manual input is not necessary.

with Barcode Reader :33 1d. Check the Barcode reader serial port. Hint: In this example the cable is connected with Com Port 2. Click „OK“.

with Barcode Reader :33 Destination Selection Mode 2a. Select in the menu „Edit settings“. In the next screen we distinguish two cases: Case 1: Working with automatic destination assignment. Case 2: Working with manual destination assignment.

with Barcode Reader :33 Case 1: Working with automatic destination assignment: Click the box, so that it is unchecked. Enter the matrix type. WD6216 WP WH12 205MI 854B B B B B B Rack/Wellplate Type on Barcode ( # ) Case 2: Working with manual destination assignment: Click the box, so that it is checked.

with Barcode Reader :33 Start Automation Initializing / Home seeking Reading barcodes Create orders without SampleTrack Verify orders Preparation 3a. Click the green button to start automation.

with Barcode Reader :33 3b. The program asks, if the barcodes should be read. Click „Yes“, if you run the program in a new setting.

with Barcode Reader :33 Case 1: Working with automatic destination assignment The destination checkbox is hided and the destination is defined by program. Case 2: Working with manual destination assignment The destination must be selected.

with Barcode Reader :33 4a. Case 1: Working with automatic destination assignment: Select the source tubes with a lasso operation: Click and hold the left mouse cursor. Draw a rectangle. The marked positions will be shown as orders.

with Barcode Reader :33 Click „Create Orders“. Click „OK“.

with Barcode Reader :33 5. The orders are running.