Heat Exchanger Coating Technology By Adisak Mananas : Henkel (Thailand) Ltd.Eastern of Thailand.

Objective To enhance maintenance techniques ,solve the Corrosion of Heat-Exchanger Part Applying identifies product solutions and techniques learn in Loctite Heat Exchanger Coating technology To take our large portfolio of products now available in the Henkel Loctite range and demonstrate how we can offer cost saving solutions to our customers

Objective to improve. To stop the corrosion at tube sheet and cover of Heat exchanger. To increase the part life of Heat Exchanger To reduce the Maintenance Cost for replace the new one To take our large portfolio of products now available in the Henkel Loctite range and demonstrate how we can offer cost saving solutions to our customers

Cause Of Problems Corrosion To take our large portfolio of products now available in the Henkel Loctite range and demonstrate how we can offer cost saving solutions to our customers

Solution to improve Surface preparation by Blasting SA 2.5 (Best Practice) To surface cleanliness. To surface roughness at least 75 micron. To make sure , the composite to stay fixed in place onto the substrate in order to perform at its design specification. To take our large portfolio of products now available in the Henkel Loctite range and demonstrate how we can offer cost saving solutions to our customers

Solution to improve [Cont.] Using Composite products to : Coating the tube sheet and cover by “ Nordbak Brushable Ceramic ( 98732 ) To take our large portfolio of products now available in the Henkel Loctite range and demonstrate how we can offer cost saving solutions to our customers

Product Selection To solve the worn surface and corrosion problem Product : Nordbak Brush-able Ceramic Grey/White To take our large portfolio of products now available in the Henkel Loctite range and demonstrate how we can offer cost saving solutions to our customers

Benefit of our solutions Coating is wide range application in any rotating machine I.e. screw conveyor, blower etc. Improve reliability and service life for existing machine and can apply to new equipment also. Minimize repairing time. Reasonable cost and lower cost when comparing to upgrade equipment material. Smooth surface so easy to clean, inspect and repair. Many application for chemical resistance and abrasion. Able to service in high pressure and high temperature condition. To take our large portfolio of products now available in the Henkel Loctite range and demonstrate how we can offer cost saving solutions to our customers