This is NUUO IO Device

Install IO Device IO Card Capture Card IO Box Converter USB RS485 PCI MPEG-4 Series H.264 Series

Open Main Console > Config > Setting > I/O Device 1. Module Setting Enter Module name of device Choose Device model –Refer IO Box or IO Card Set COM Port of device –My computer > manage > Computer management > Device Manage > Ports (COM & LTP) –It’s will show Prolific USB-to-Serial Comm Port (COM3)

Set ID of device –Right Check on Device and choose properties > Port Setting > Check Bits per second (Baud Rate) It will get Baud rate –Use Tool “IOConfig.exe” to get ID information –Input COM port, Baud rate, and set Starting address from “0”. –And click “scan” to search. –The Address “0” will show as below Right Click

2. I/O Device List Show device already installed in system Choose device 3. Device Setting Modify name Set I/O state –N/C : normal Close –N/O : normal Open 4. Digital input Monitor It will become red when signal input 5. Digital output simulation Click to send output signal It will become red