Comments on HO decision and initiation ( ) IEEE Presentation Submission Template (Rev. 9) Document Number: IEEE C80216m-10_0765 Date Submitted: Source: Whai-En Chen, Shih-Yuan Cheng, Yu-Chan Lin National Ilan University Shiann-Tsong Sheu, Chih-Cheng Yang National Central University Kanchei(Ken) Loa, Yi-Ting Lin, Tsung-Yu Tsai, Youn-Tai Lee, Chun-Yen Hsu, Chiu-Wen Chen Institute for Information Industry Yang-Han Lee, Yih Guang Jan Tamkang University * Venue: IEEE Session#68, San Diego, California, USA. Re: IEEE /0011, “IEEE Working Group Sponsor Ballot”, on P802.16m/D6 Base Contribution: This is base contribution. Purpose: To be discussed and adopted by TGm for m SB. Notice: This document does not represent the agreed views of the IEEE Working Group or any of its subgroups. It represents only the views of the participants listed in the “Source(s)” field above. It is offered as a basis for discussion. It is not binding on the contributor(s), who reserve(s) the right to add, amend or withdraw material contained herein. Release: The contributor grants a free, irrevocable license to the IEEE to incorporate material contained in this contribution, and any modifications thereof, in the creation of an IEEE Standards publication; to copyright in the IEEE’s name any IEEE Standards publication even though it may include portions of this contribution; and at the IEEE’s sole discretion to permit others to reproduce in whole or in part the resulting IEEE Standards publication. The contributor also acknowledges and accepts that this contribution may be made public by IEEE Patent Policy: The contributor is familiar with the IEEE-SA Patent Policy and Procedures: and. Further information is located at and. ://standards.ieee.org/board/pat
Introduction Page 282 line 24 section “HO decision and initiation” states “The AMS shall not perform HO to a cell with Cell Bar bit=1 in its S-SFH. The “Cell Bar” bit, when set, indicates that an AMS should not perform network entry or re-entry to this cell.” The procedure should be clarified when the Cell Bar bit is set. 2
Proposed Text [Modify the following text in page 282 line 24 section “HO decision and initiation”] The AMS shall not perform HO to a cell with Cell Bar bit=1 in its S-SFH. The “Cell Bar” bit, when set, indicates that an AMS should shall not perform network entry or re-entry to this cell. 3