Laboratoires & Matériels WiFi stephane.frati@unice.fr

Le matériel de vos TP

Supported OS Windows Operating Systems The Aironet Windows driver disk includes drivers for: Windows 95 and 98 and Windows ME, Windows NT, Windows 2000, Windows XP Windows CE 2.x, 3.x, and 4.x Linux and Macintosh Linux using kernel versions 2.2.x or 2.4.x with Macintosh PowerBooks and PowerMacs using Mac OS 9.x or Mac OS X 10.1 not for use with Macintosh notebooks that have a built-in wireless card (AirPort) Cisco Connection Online (CCO)

1200 Series Access Point Ports Ethernet Port with or w/o power DC Power Console Port The 1200 Access Point has the following ports on the top port panel: Link Light: Lights solid green to indicate that 10BaseT/100BaseT has been configured as the active port. Traffic: Flashes green when an Ethernet packet has been received. Console Port: RJ-45 Console port. (rollover cable) The 1200 Access Point can be powered by it’s DC power port or by power over Ethernet using an optional power injection module, or using another powered Cisco device (patch panel, switch). To communicate with the access point via the console port, use a terminal emulation program (such as HyperTerminal) with the following settings: 9600 Baud 8 Data Bits No Parity 1 Stop Bit Flow Control Xon/Xoff Mode or Default config reinit button Link Traffic

Cisco Aironet 1240AG Series Access Point 802.11a antennas 802.11b/g antennas

Available power modes

Connecting to the Access Point Console port Requires roll-over cable Telnet Requires an IP address Web Browser Preferred connection To set an IP address: Use DHCP Server Use IPSU Set using Console port Console Port Telnet Web Browser As designed, manage Cisco Aironet Access Point using a Web browser. Telnet and Console port menus are much more difficult to utilize. To set an IP address you can either use DHCP or the Cisco Aironet IP Setup utility (IPSU).

Obsolete “Force an IP via DHCP or IPSU” Make sure that the IPSU is installed on your laptop. You must also have a wireless adapter and an RF connection with the access point on which you want to change the IP address. The IPSU is available as a download from the Cisco website. Double-click the IPSU icon on your computer desktop to start IPSU. Make sure Set Parameters is selected in the Function box. In the Device MAC ID field, enter the MAC address as it appears on the label on the bottom of the access point. It should contain six pairs of hexadecimal digits separated by periods or dashes. In the IP Address field, enter the IP address you want to assign to the access point. The IP address should be on the same subnet as the device to which you will connect the access point. In the SSID field, enter the SSID you want to assign to the access point. You cannot set the SSID without also setting the IP address. However, you can set the IP address without setting the SSID. Click Set Parameters. IP address is set on the access point. This is best done through a Ethernet connection.

Important ! Consider the AP as a bridge AP extends wired features to the wireless BVI : Bridge Virtual Interface From which you manage the AP FastEthernet0 is the first interface Dot11Radio0 is the second interface 802.11 is simply another interface on AP

AIR CB20A/CB21AG The Cisco Aironet® 5 GHz 54 Mbps WLAN client adapter is an IEEE 802.11a-compliant CardBus Type II Atheros Chipset MadWifi

AIR PCM352 a PC card with an integrated antenna A PCMCIA card radio module can be inserted into any device equipped with an external Type II or Type III PC card slot Specific Cisco Prism chipset Airo_cs

LED: indicateurs