Eclipse EHX – V-Series Panels Audio Mixer Features / Examples

WHAT IS THE V-SERIES AUDIO MIXER  The V-series panels have an internal Digital Signal Processor, (DSP).  The DSP is used to ►Route panel audio between inputs like the “from Matrix” to the outputs like “to Loudspeaker” at a variable level. ►Condition the Audio sources with band pass equalisation to reduce noises like wind or traffic rumble to make the audio more intelligible. ►Condition the Audio sources with Dynamics like compression to squeeze the microphone peaks into a less dynamic waveform thus increasing perceived loudness at the destination. ►Provide pass-through IFB for local talk over Audio or dim local speakers.

HX- V-SERIES AUDIO MIXER SCREENSHOT Inputs Dynamics EQ Crosspoint level controls Outputs Input levels Output levels

LS A V-SERIES MIXER EXAMPLE 1 Dim local Room Loudspeakers From Matrix o/p port R Loudspeakers wired through the V-Series Audio EXT1 and EXT2 connections From Matrix o/p port L Room Loudspeakers LS B Control under any keys activate DIM local IFB on EXT1 and EXT2.

Binaural listening (Split Ear) From Matrix Main Panel Port From Matrix Aux Panel Port Binaural (stereo) mode Co-Ax cable AES-6-CX card 2x intercom channels from Matrix to Panel over coax Panel requires 5pin XLR headset V-SERIES MIXER EXAMPLE 2

HS 1 from Front XLR and HS 2 from rear auxiliary connector V24LDX4 HX V-Series Panel Programming – Audio Mixer HS 1L HS 2L From Matrix Port To HS earpiece HS1 main volume control HS2 aux volume control Auxiliary audio Connector DB-25 HS mic 1 & 2 To Matrix port HS 1 / HS 2 audio mix to each headset 2x Headset users connected to 1 Panel V-SERIES MIXER EXAMPLE 3

Thank you!