10/8/2015CST Computer Networks1 IP Routing CST 415

10/8/2015CST Computer Networks2 Topics Problem Definition Packet Delivery Table Driven Routing Next Hop Routing Default and Host Specific Routes Routing Algorithm

10/8/2015CST Computer Networks3 Question… ARP resolves IP addresses to physical addresses. How can a packet be addressed to go to a destination that is not on the same network segment? How can a packet be addressed to go to a destination that is on a “very distant” network?

10/8/2015CST Computer Networks4 Problem Definition The Internet is an abstraction away from the physical network. The IP layer sits on top the MAC/Physical layers. Packets are routed between IP peers. It is these IP peers that make up the Internet.

10/8/2015CST Computer Networks5 Problem Definition Packets need to be routed from the originating host to a router (for Internet based delivery). The router needs to move the packet across to a separate network, possibly of a different technology and conforming to different policies. Networks need to internally route packets using a homogeneous technology.

10/8/2015CST Computer Networks6 Problem Definition – The Players From host to router: Typically static route tables. These tables may be updated dynamically via ICMP. ICMP – Internet Control Messaging Protocol. ICMP allows routers to talk back to host computers for reporting packet transmission problems.

10/8/2015CST Computer Networks7 Problem Definition – The Players From “subnet” router to “subnet” router: Routing tables dynamically updated “at the whim” of the subnet connection controlling router. EGP – Exterior Gateway Protocol BGP – Boundary Gateway Protocol. BGP allows a primary subnet router to negotiate services with other primary subnet routers. BGP allows a router to “hide” the details of it’s network. When we trace a route to a network, but the host cannot be resolved, it is BGP that is protecting the identity of it’s internal networks and nodes.

10/8/2015CST Computer Networks8 Problem Definition – The Players From “internal subnet” router to “internal subnet” router (host computers need not apply): Routing tables dynamically updated based on the routing protocol supported by the internal network. IGP – Interior Gateway Protocol RIP – Routing Information Protocol. OSPF – Open Shortest Path First Protocol. Internal networks will speak either RIP or OSPF. They will not typically speak both. In either case, routing information is exchanged using these protocols.

10/8/2015CST Computer Networks9 Packet Delivery Internet Protocol – Defines unreliable, connectionless delivery of packets. –Unreliable – send it and forget it. –Connectionless – the route of the packet will be defined “on-the-fly” by the network itself (e.g. routers between the source and destination).

10/8/2015CST Computer Networks10 Packet Delivery The physical machines that make up the Internet IP web fall into two categories – Hosts and Routers. Hosts and Routers both must be capable of originating an IP packet. Routers must implement forwarding algorithms. Hosts are not required to forward packets.

10/8/2015CST Computer Networks11 Packet Delivery Two types of packet delivery need to be considered: 1.Direct Delivery – The packet is delivered directly to a peer machine located on the same physical network. 2.Indirect Delivery – The packet is delivered to an intermediary (router). –The intermediary is responsible for passing the packet along to the packets destination. –The intermediary will deliver the packet either directly or indirectly.

10/8/2015CST Computer Networks12 Operations involved in IP routing.

10/8/2015CST Computer Networks13 Packet Delivery The MAC layer will pass the IP packet up to the IP layer (based on the packet type field in the MAC header. The IP layer looks at the IP address and determines the destination of the packet. –The network address of the IP address is inspected. –If the network address is the same as the network address of the router, the packet is delivered directly. –If the network address is different than the address of the router, the packet is delivered indirectly.

10/8/2015CST Computer Networks14 Packet Delivery Question of the day: How does a router know where to send a packet given any particular IP address?

10/8/2015CST Computer Networks15 Table Driven Routing The router contains a table of network address associations (n,r) –n : IP address of the destination network –r : IP address of the next router When a packet arrives at the router, this table is consulted. The packet is sent along to the next router based on the table look-up.

10/8/2015CST Computer Networks16 Next Hop Routing In the IP routing table, keep the associations of network address and router. Only keep router associations for routers that can be reached across a single network connection.

10/8/2015CST Computer Networks17

10/8/2015CST Computer Networks18 Next Hop Routing Only the network address is maintained in the routing table. All traffic destined for a specific network will take the same path. Only the final router along the path can determine if a host actually exist. “To” and “From” paths may not be the same.

10/8/2015CST Computer Networks19 Default Routes Each network is assigned a default router. IP packets destined for networks not in the routing table will be sent to this router.

10/8/2015CST Computer Networks20 Host Specific Routes Allow administrative ability to pre- determine a specific route between two host machines.

10/8/2015CST Computer Networks21 Routing Algorithm The ultimate source and ultimate destination IP addresses are never altered. However, the IP layer selects a new IP address for packet delivery based on the network the packet is ultimately destined for. To send the packet along without changing the ultimate addresses in the packet (see IP packet format) –IP sends the packet to the MAC layer along with the “next hop” destination IP. –The MAC layer forms the physical packet using the “next hop” IP address to look up the physical address.

10/8/2015CST Computer Networks22 Routing Algorithm

10/8/2015CST Computer Networks23 Routing Algorithm (1) The router receives the IP packet from the Link Layer. (2) The router validates the IP header. Note that IP reassembly is not done, except on IP fragments to be queued for local delivery in step (4). (3) The router performs most of the processing of any IP options. Some IP options require additional processing after the routing decision has been made. (4) The router examines the destination IP address of the IP datagram to determine how it should continue to process the IP datagram. There are three possibilities: o The IP datagram is destined for the router, and should be queued for local delivery, doing reassembly if needed. o The IP datagram is not destined for the router, and should be queued for forwarding. o The IP datagram should be queued for forwarding, but (a copy) must also be queued for local delivery.

10/8/2015CST Computer Networks24 Routing Algorithm (5) The forwarder determines the next hop IP address for the packet, usually by looking up the packet's destination in the router's routing table. This procedure also decides which network interface should be used to send the packet. (6) The forwarder verifies that forwarding the packet is permitted. The source and destination addresses should be valid. If the router supports administrative constraints on forwarding, those constraints must be satisfied. (7) The forwarder decrements (by at least one) and checks the packet's TTL. (8) The forwarder performs any IP option processing that could not be completed in step 3. (9) The forwarder performs any necessary IP fragmentation. Since this step occurs after outbound interface selection (step 5), all fragments of the same datagram will be transmitted out the same interface.

10/8/2015CST Computer Networks25 Routing Algorithm (10) The forwarder determines the Link Layer address of the packet's next hop. The mechanisms for doing this are Link Layer- dependent. (11) The forwarder encapsulates the IP datagram (or each of the fragments thereof) in an appropriate Link Layer frame and queues it for output on the interface selected in step 5. (12) The forwarder sends an ICMP redirect if necessary.