Readout electronics for the MUV detectors R. Fantechi 28/3/2012

MUV1&2 electronics – Not the real expert, however… Use LAV electronics + TDCB Cables coming in the back of EB24 Patch panels taken/refurbished from NA48 LAV type of cables TEL62 crate common with MUV3 Standard readout firmware

MUV3 electronics Cables – HV Reuse AKL cables: enough and of right lengths, 16 cables/bunch with SHV connectors Need some work: cut in half, free the conductors, put together the internal connectors of two cables into one Radiall 32 pin connector for the CAEN boards Estimated length: between 8 and 12 m, depending on which sector HV power supplies rack on the floor of ECN3 – Signal Going to the EB (see later) Estimated max length 20 m, effective length to be determined 296 RG58 cables. BNC at both ends, to be prepared AKL patch panel available Constant fraction discriminators – Reuse of the old AKL CFD 288 channels available Few more boards should be produced, however not urgently – The existing boards have been checked to have all the channels ok with a basic go-nogo test Indeed using two counter and their coincidence and moving one of the two cables from one channel to another Outputs are ECL

MUV3 Electronics Level adapters – Needed to convert from ECL, flat cable connector to LVDS, TDCB connector Relatively simple boards, only take care of line impedance and to have all the channels with connections of the same length To be built in Mainz, elaborating a first design by Gianluca and myself Implementation in VME 6U, needs one 6U crate, which will be useful also for choke/error OR board

ECL/LVDS translator “TRAM” (TRAnslator for Muon veto) Implement controlled Z lines and all tracks of the same length

MUV3 Electronics TDCB and TEL62 – 1 TEL62 and 3 TDCB needed – Firmware to be developed Readout of hit times is available Work needed for trigger primitive generation – Pieces under development possibly available from CHOD and LAV

Electronics layout EB24EB23 EB23 doesn’t have heat exchanger: good to pass 300 cables from the back CFD crate Cable patch panel Level adapter crate TEL 62 crate MUV1 and 2 patch panels to be installed in the back of EB24