LIQUEFACTION FAILURE OF FOUNDATION - STRUCTURE COLLAPSE.

Slides:



Advertisements
Similar presentations
Actions and Retrofit of Post Earthquake-Damaged Bridges
Advertisements

Seismology and Earthquake Engineering :Introduction Lecture 3
Educational Resource Library
SUB-STRUCTURE foundations.
Chp12- Footings.
Wenchuan Earthquake The Geology Problem and Engineering Solution Yuan Chen Shuopu Chen Wei Liang.
Liquefaction, Kobe Earthquake Matt Greaves, Tom Baker.
Loma Prieta Earthquake Mourad Amouri Nicolas Rodriguez.
Performance-based Evaluation of the Seismic Response of Bridges with Foundations Designed to Uplift Marios Panagiotou Assistant Professor, University of.
Earthquake induced LIQUEFACTION by Jimmy McLauchlan Peat Nicholas Case study: Mexico City, 1985.
SEISMIC ANALYSIS Stability of a slope can be affected by seismicity in two ways: earthquake and blasting. These seismic motions are capable of inducing.
During the semester Introductions Basics of earthquakes History and Recording Damaging Earthquakes and Understanding seismic exposure Undertaking loss.
Damage Illustrations. Potential Bridge Damage Bridge Component / DamagePossible Cause Approach Slab or Pavement  Raised, lowered, cracked, or buckled.
SOIL, GEOTECHNICAL ENGINEERING AND FOUNDATION ENGINEERING
CE 515 Railroad Engineering
REINFORCED EARTH STRUCTURES CONCEPT BASICS OF DESIGN CASE STUDIES.
FOUNDATION.
Analyses of tunnel stability under dynamic loads Behdeen Oraee; Navid Hosseini; Kazem Oraee 1.
Introduction Motivations: There are hundreds of miles of retaining wall systems that exist in western United States Their routine design for static applications.
Earthquakes Chapter 6 February 2012 This topic will shake you up.
Liquefaction Analysis For a Single Piled Foundation By Dr. Lu Chihwei Moh and Associates, Inc. Date: 11/3/2003.
CARIBBEAN STUDIES Hazards in the Caribbean. Earthquakes Earthquakes are caused by sudden release of slowly accumulated strain energy along a fault in.
Slop Stabilization Pertemuan
1 Natural Disasters Earthquakes & Their Damages. 2 San Francisco M = 7.8; 3,000 killed.
Bridge Engineering (5) Substructure – Abutments and Piers
MAE CENTER RESEARCH SUCCESS WITH DOTs Past and Future Neil M. Hawkins - Professor Emeritus University of Illinois MAE Center Annual Meeting With.
TOPICS COVERED Building Configuration Response of Concrete Buildings
Feasibility Level Evaluation of Seismic Stability for Remedy Selection Senda Ozkan, Tetra Tech Inc. Gary Braun, Tetra Tech Inc.
Seismic Retrofitting of Bridges Donald Kirkcaldie Seismic Retrofitting of Bridges Donald Kirkcaldie.
Earthquake Resistant Design Philosophy and Approach in New Zealand Donald Kirkcaldie Earthquake Resistant Design Philosophy and Approach in New Zealand.
Definition LANDSLIDES
University of Palestine
LESSONS FROM PAST NOTABLE EARTHQUAKES. Part IV Walter Hays, Global Alliance for Disaster Reduction, Vienna, Virginia, USA.
Liquefaction Liquefaction occurs where ground water is near the surface in soils composed of sands and silts. The soil temporarily loses strength and behaves.
How Bridges Respond to Loads
Overview of the “Recommended LRFD Seismic Design Specifications for Highway Bridges” Ian M. Friedland, P.E. Bridge Technology Engineer Federal Highway.
Retaining Walls I. *Introduction
Foundation Loads Dead Load Live Load Wind Load
BASICS OF DYNAMICS AND ASEISMIC DESIGN
1 Natural Disasters Mass Wasting: Landslides
SOIL MECHANICS AND FOUNDATION ENGINEERING-II (CE 311)
Vulnerable Structural Elements
Understand foundation design and construction
GLE/CEE 330: Soil Mechanics Introduction to Foundation Engineering
Building Construction
INTRODUCTION Due to Industrial revolution metro cities are getting very thickly populated and availability of land goes on decreasing. Due to which multistory.
Development of Seismic Design Approach for Freestanding Freight Railroad Embankment Comprised of Lightweight Cellular Concrete Cell-Crete Corp. Steven.
REINFORCED EARTH STRUCTURES
Review of Indian Seismic Codes
SHEET PILE Analysis & Applications
Oregon DOT Integral Abutment Design Criteria
SLOPES GUILLERMO, MIRA ROELLA MANABAT, JAYZAM LLOYD VIERNES, ARAY
Seismic Waves Large strain energy released during an earthquake
SOIL, GEOTECHNICAL ENGINEERING AND FOUNDATION ENGINEERING
Seismic Design Impact to
Plate movement Earthquake = sudden release of energy in the Earth’s crust that creates seismic waves. They are measured by the Richter Scale,
Construction Examples in Japan High Capacity Micropile
BRIDGES MOST IMPORTANT GEOTECHNICAL EFFECT- LIQUEFACTION
“Base isolation and Seismic Consideration in Civil Engineering”..
GOALS For the classification of cracks in the wet and hardened concrete. To diagnose cracks in concrete structures and determine their types.
Arch205 Materials and building construction 1 foundation
4th Annual Construction Law Summit
Arch205 building construction foundation
Effect of Earthquake on Fire Protection Systems
DO NOW Pick up notes and Review #32..
Earthquake resistant buildings
Liquefaction Kevin Carr Compression Dilation
Shear Strength of Soil.
SEISMIC BEHAVIOR OF MICROPILE SYSTEMS
Post Seismic Bridge Inspection
Presentation transcript:

LIQUEFACTION FAILURE OF FOUNDATION - STRUCTURE COLLAPSE

CLASSIFICATION FLOW LIQUEFACTIONCYCLIC MOBILITY Static shear stress exceeds shear strength of liquefied soil. Static shear stress are slightly less than liquefied shear strength,but static +dynamic stresses are greater than shear strength of liquefied soil.

The risk to public safety. 2. The importance of the structure (lifeline, economic recovery, military). 3. The cost of the structure (capital investment and future replacement costs). 4. The cost of mitigation measures. The policy further specifies that, “All bridges should be evaluated for liquefaction and lateral spread potential and the possible effects of these conditions on the structure.” Consideration is given to the magnitude of the anticipated lateral soil deformation, the influence of piles on embankment deformations, and tolerable deformation limits of the structures under consideration. Close coordination between the geotechnical engineer and the bridge design engineer is required.

LIQUEFACTION-INDUCED BRIDGE DAMAGE Lateral soil deformations (lateral spreading) have proven to be the most pervasive type of liquefaction- induced ground failure (Youd 1993). Lateral spreading involves the movement of relatively intact soil blocks on a layer of liquefied soil toward a free face or incised channel. These blocks are transported down-slope or in the direction of a channel by both dynamic and gravitational forces. The amount of lateral displacement typically ranges from a few centimeters to several meters and can cause significant damage to engineered structures.

EFFECTS ON BRIDGE  GROUND FAILURE  LATERAL DISPLACEMENT  SETTLEMENT  ABUTMENTS ARE VULNERABLE TO SEISMIC DAMAGE

SOIL LIQUEFACTION  LOSS OF BEARING CAPACITY  LATERAL MOVEMENT OF SUBSTRUCTURE  DISLODGEMENT OF SUPER STRUCTURE

LARGE SCALE DEVELOPMENT - SEISMIC RISK 60% INDIA’S LAND HIGH SEISMIC ZONE EARTHQUAKE DAMAGE TO STRUCTURE AFFECT SOCIAL & FINANCIAL STATUS LOSS OF MANY LIVES

For most bridges at river crossings subjected to medium- to high-intensity earthquake motions - liquefaction primary cause reduced stability of earth structures increased active pressures on abutments loss of soil strength and the seismic inertia of the backfill loss of passive soil resistance

impacts from liquefaction Lateral ground displacements have been extremely damaging to bridge foundations and abutments. 2. Movement of foundation elements may create large shear forces and bending moments at connections and compressional forces in the superstructure. Subsidence and increased lateral earth pressures can also lead to deleterious consequences for bridge foundations. Waterfront retaining structures, especially in areas of reclaimed land, can experience large settlements and lateral earth pressures adjacent to bridge foundations. These movements lead to the rotation and translation of bridge abutments and increased lateral forces on pile foundations. 5. A number of failure modes may occur in pile foundations, depending on the conditions of fixity, pile reinforcement and ductility. Generally, if concrete piles were well embedded in the pile caps, shear or flexural cracks occurred at pile heads, often leading to failure; if steel pipe piles were fixed tightly in the pile caps, failure was at the connection or pile cap; or if the pile heads were loosely connected to the pile caps, they either rotated or were detached.

PILE FAILURE