Installing SME Version 5 –1)Set the computer to boot from the CDRom by changing the BIOS setting. –2)Startup the computer with the CD in the CD drive –3)Type "accept" (without quotes) at the [boot:] prompt. –4)Press Enter –5)Wait…. For the "Welcome to the e-smith server and gateway" message and the "Service LINK License Agreement"

Install – Cont. –6)Tab to the "ACCEPT" choice and press Enter –7)Select (up/down arrow) "Install using Single Hard Drive (tab to choice) –8)Tab to "OK" and press Enter –9)Type "proceed" at the prompt –10)Tab to the "OK" choice and press Enter –11)Wait…. (for formatting, file transfer, etc.)

Install –Cont. –12)When prompted to create a Boot Diskette, insert a diskette in the drive and type press Enter to select "Yes" –13)Press Enter to select "OK" –14)Press Enter and be ready to eject the CD. –15)Remove the CD while the system is shutting down. –16)Remove the boot floppy. –17)Wait… for the reboot process to complete.

Configuring the SME5 Server –1)When prompted for the admin password, type in a password, press Enter –2)Retype the password, press Enter –3)Tab to "Yes" press Enter –4)Enter a valid IP Address from your local network for the domain name. –5)Tab to "next" and press Enter

Configure –Cont. –6)Type in a server name (i.e. SME5, e-smith, etc.) tab to "Next", press Enter –7)Confirm that your Ethernet card has been detected. Press Enter to select. – 8)Enter the IP Address you used for the domain name. –9)Tab to "Next" and press Enter

Configure –Cont. –10)Enter the subnet mask for your network ( ___) –11)Tab to "Next" and press Enter –12)Operation Mode: arrow down to option 3 (Server Only), tab to "Next", Press Enter –13)Gateway: Enter your gateway IP address (router, Ethernet port, firewall, etc.) –14)Tab to "Next" press Enter

Configure –Cont. –15)DHCP: OFF - Arrow down to OFF, tab to "Next" press Enter –16)DNS: Leave blank, tab to "Next" press Enter –17)Proxy: NO - tab to "Next" press Enter –18)Status to e-smith: NO press Enter –19)Console: Login arrow down to login, tab to "Next" press Enter

Configure – Cont. –20)Notify by , press Enter –21)Activate Configuration: YES press Enter –22)Wait….. for reboot. –23)Login: "admin" Enter –24)Your password Enter –25)Arrow down to "Test Internet Access" press Enter

Configure –Cont. –26)Wait for "Success" or "Unsuccessful" message. –27)IF unsuccessful, check ethernet connection, card acceptability, IP gateway, IP of server. –28)Arrow down to Shutdown and select shutdown. –29)Power off.

UpDating the SME5 Server (Currently, skip the next 2 slides for SME v5.1.2) Through a web browser enter your “IP address/server-manager” in the URL address space and press enter. – /server-manager Login as “admin” Enter your server password

Updating –Cont. Scroll down to “Administration” and click on the selection “Blades” Click “install” on the supported Blades –(You should install each supported Blade) Click “yes” to the license agreements Wait for completion message. –It will take a few minutes, be patient and only click once.