VARCO PRUDEN’S Self Curbing Day Lighting Solution PrisMAX SL for SSR & HWR Roof’s

PrisMAX SL GUIDES There are many versions of PrisMAX SL Installation Guides. It is important to review the guide that is sent with the “For Construction Package” before installation. Before installation, contact Varco Pruden if guide is lost or missing. This Presentation show the Basic installation on SSR. Installation on HWR is similar, but many parts will be different.

PrisMAX SL MODEL

PrisMAX SL DIVERTER Current Model Lens has top mounted screws vs side installed.

PrisMAX SL CROSS SECTION

BE SAFE!

TOOLS Note: A Rivet Tool for a 9/32” Olympic Rivet will be required for installing side rail rivets.

PARTS

BEGIN Locating the PrisMAX Unit Cutting the Rib

Locating the PrisMAX Unit Cutting Access Hole Preparing Diverter

Sealing the Closures

Preparing the Support Plate and the diverter

Preparing the Support Plate and the diverter (cont.)

Installing the Support Plate and the diverter

Installing the Side Rails

Multiple Units

Installing Side Rails

Upper Diverter Closure

Lower Diverter Closure & Cutting Access Hole

Lower Diverter Closure & Cutting Access Hole

Cutting The Roof Panels

Insulation

Foam Tape

Insulation Trim

Accessories

Tape When Accessories Are Used

Preparing for Lens

Attaching the Lens THE END of PrisMAX Installation

Installation of the “PrisMAX SL” Locate and make your cut

Installation of the “PrisMAX SL” Cut the roof panel for stiffener plate

Installation of the “PrisMAX SL” Locate and install plugs on stiffener plate

Installation of the “PrisMAX SL” Install Stiffener Plate

Installation of the “PrisMAX SL” Install Diverter

Installation of the “PrisMAX SL” Install Front Diverter

Installation of the “PrisMAX SL” Measure and Install Lower Closure

Installation of the “PrisMAX SL” Cut out panel inside rail

Installation of the “PrisMAX SL” Panel cut out

Installation of the “PrisMAX SL” Pull the fiberglass Insulation out

Installation of the “PrisMAX SL” Cut the facing

Installation of the “PrisMAX SL” Facing on side of rail

Installation of the “PrisMAX SL” Facing on side of rail with Foam Retaining Rod

Installation of the “PrisMAX SL” New Trim Kits

Installed “PrisMAX SL” Trim Kits

Installation of the “PrisMAX SL” Install first 10’-0” Lowside Unit for “multi-unit” systems

Installed “PrisMAX SL”

“PrisMAX SL”