Topcat with Access Technology

Features In-ceiling audio system Plenum rated Full-range audio Hybrid speaker solution Rich sound for multi-media Wireless audio integration Direct connection to AC mains Optional DC extension cable Scalable Access Platform – easily add Flexcat pods Standard 5 year warranty

Easy Installation Mounting bracket for hard surface solutions No interference with other classroom technologies Drop out is eliminated Audio-in connection for wired integration Excellent for standard classrooms of up to 1600 sq ft, 12 ft high ceilings Automatic power down after 2 hours of inactivity Features Continued

Install in center of listening area, if ceiling mounted Install in middle of longest wall, if wall mounted Mount at approximately 6 to 8 ft high Features Continued

Components Microphones Topcat Optional Flexcat Pods

Microphones + Media Connector FLEXMIKE Small, light weight Line level audio input Headphone output (FC only) Volume control Adjustable magnetic lanyard SHAREMIKE Line level audio input MEDIA CONNECTOR 4 audio inputs 2 audio outputs Master microphone volume Tone control USB power

TCA Accessories Ceiling/Wall Mounting Bracket Clean Installation Fits all classroom designs TCMB Partner Cost $100 US

Additional Accessories PageFirst Sensor Clip with Cable DC Extension Cable

Maximum Configuration 2 Microphones + 2 Remotes Topcat Media Connector + 6 Pods

TCMB Installation Select mounting location, typically 6’ to 8’ feet AFF Remove ‘T’ bar brackets on 3 sides, leaving the woofer end bracket in place (removing this will affect audio quality) Drill template included with bracket Mark and drill pilot holes for long sections of bracket Secure the long panels to wall or ceiling using appropriate anchors Open TCA cover and remove the PS brick. Restrap velcro strips to enclose the AC plug. Connect the power supply to the DC port on the TCA end panel Using the provided velcro strips, affix the PS brick to the side of the TCA Secure excess cable into the large cavity of mounting bracket.

TCMB Installation continued Slide TCA into the long panels facing down/outward Position it so that the power jack is on the same side as the J-box Ensure the J-box does not come in contact with TCA Install large end cap over the J-box allowing conduit or raceway to pass through the conduit hole Secure end cap with provided M3 x 8 phillips washer-head screws Align the TCA so that the screw holes of the T-bar bracket align with the screw holes on the long sides of the mounting bracket Secure the mounting bracket to the TCA using the four provided 10 x 1.5” phillips panhead tapping screws (2 on each of the long sides.) Install smaller end cap and secure with the provided M3 x 8 phillips washer head screws.

Questions?