Copyright 2002AST Training A.S.T. Training’s Introduction to Driver’s Seat Diagnostics.

Slides:



Advertisements
Similar presentations
Improved Operational Emissions Compliance by the application of Emission Event Recording.
Advertisements

FUEL SYSTEM DIAGNOSIS.
FUEL INJECTION SYSTEMS
Engine Tune-Up By Jonathan Rollins.
Scan Tool Test Procedures
Scan Tool Functional Tests Steve Zack, Jim Wilson, Ross Hayner
Advanced Scan Tool Diagnostics Steve Zack Jim Wilson
COMPUTERS AND INPUT SENSORS. cbc MICROCOMPUTER OPERATION HAPPENS IN STAGES Memory.
87 ONBOARD DIAGNOSIS ONBOARD DIAGNOSIS.
GM PFI Operation and Testing. Overview Operating Modes Starting Clear Flood Run Acceleration Deceleration Battery Voltage Correction Fuel Cutoff.
Chapter 26 Ignition Systems.
Engine Electronic Controlled. Ignition systems THE CONSTANT ENERGY IGNITION SYSTEM DIGITAL (PROGRAMMED) IGNITION SYSTEM DISTRIBUTORLESS IGNITION SYSTEM.
Sherlock Holmes Diagnosis NACAT July, 2010
Using the iOBD2 Scan Tool
ECM Sensors. Air Temperature Sensor Air Flow Meter.
European Troubleshooter 6.2 Content Update. Summary: New Component tests added…. 256 New key & immobiliser procedures added… 202 New ECU pin –out.
CBCJH COMPUTERS AND INPUT SENSORS CHAPTER 8. CBCJH VOLTAGE SIGNALS l ANALOG VOLTAGE SIGNALS –VARIABLE VOLTAGE SIGNAL –COMPUTERS INPUTS ARE USUALLY ANALOG.
5 Gas Analysis Another Rainharbor Production 1997.
© 2015 Cengage Learning. All Rights Reserved. May not be scanned, copied, duplicated, or posted to a publicly accessible website, in whole or in part.
ELECTRONIC FUEL INJECTION COMPONENTS
Electronic and Computer Systems Service
Electronic Fuel Injection
OBJECTIVES After studying Chapter 4, the reader will be able to:
The Whole System. Ford DPFE EGR System 2. Pintle opens 1. vacuum applied 3. EXHAUST GAS FLOWS No Electronics at the Valve.
Engine Performance Systems
© 2015 Cengage Learning. All Rights Reserved. May not be scanned, copied, duplicated, or posted to a publicly accessible website, in whole or in part.
A Step-by-Step Guide to Success
Electronic Fuel Injection Vocabulary 1.Injector (solenoid ) 9.)emission standards 2.Stoichiometric14.7 to 1 3.Throttle body of injection 4.Port injection10.)Types.
No-Code Diagnosis A Step-by-Step Guide to Success Jim Halderman.
GENISYS TECHNICIAN TRAINING Steve Zack - SPX. Scroll to Scan Diagnostics To perform Scan Tool functions scroll to Scan Diagnostics and press Enter Enter.
General Motors OBD II Scan Tool Interface
SCAN TOOLS AND ENGINE PERFORMANCE DIAGNOSIS
Evaporative Emissions Control Systems (EVAP)
Asttraining.com Scan Procedures for Ford EEC-V OBD II Systems.
Engine Management Systems and Calibration
World Leaders in Combustion Management Solutions Module Gas Setup Introduction The Mk7 E.G.A Cell Status Further Information.
Copyright © 2008 General Motors Corporation.
What is OBD? Emission Monitoring System. Where is OBD located? In the PCM.
Engine Diagnostic Tests
Advanced Engine Performance Diagnosis, Fourth Edition James D. Halderman Copyright ©2009 by Pearson Higher Education, Inc. Upper Saddle River, New Jersey.
GENISYS TECHNICIAN TRAINING. Automated System Test (AST)
Input Sensors/Fuel injection
2013 IM Solutions Training Forum Emission Testing Readiness Issues Presented By Scot Manna Top Tech Training Inc.
Confidential | AA-AS/xx | 7/8/2015 | © Robert Bosch GmbH 2015 All rights reserved, also regarding any disposal, exploitation, reproduction, editing, distribution,
KPIT Cummins Confidential - Version 1.0 On- board Diagnostics OBD – II Experience 1.
ECU/EMS. OPERATION PARAMETERS EMS SCHEMATIC SENSOR LIST.
© A.T.T.S. Inc I/M Solutions 2013 Training Ensures A Trouble Free Program "G" Jerry Truglia.
© A.T.T.S. Inc IM Solutions May, Sessions #11: Repair Tech Training 1:30 a.m. – 12:30 p.m. G Truglia What’s Needed To Fix The PO420 & PO171.
AfterSalesTraining R 403 Petrol Engine Management 17 June, 2016 RAVE Welcome to AfterSalesTraining.
Types of Sensors Used in Multi-Point Fuel Injection System
I/M Solutions Sheraton Grand Sacramento Hotel OBD testing in Oregon – ( Data) Gary Beyer, Environmental Engineer Oregon Vehicle Inspection.
Click to edit Master text styles –Second level Third level –Fourth level »Fifth level R 355 Variable Valve Control 18 July 2016 AfterSalesTraining RAVE.
Japan’s proposal for EPPR-16-10
(After the EPPR telephone conference on 11/May/2016)
24 Chapter On-Board Diagnostics and Scan Tools.
Emission Control Diagnosis and Service
SCAN TOOLS AND ENGINE PERFORMANCE DIAGNOSIS
Electronic Fuel Injection
Electronic Automatic Transmissions
Frequently Asked Question How Can You Determine the Companion Cylinder
A Step-by-Step Guide to Success
Engine Performance I & II How I will be covering this material
Failure types, Codes, Clearing codes
CHAPTER 49 On-Board Diagnostics.
Sensors Chapter 17 Lesson 3.
FIGURE 38-1 A funnel is one way to visualize the diagnostic process
Automotive Technology Principles, Diagnosis, and Service
Automotive Technology Principles, Diagnosis, and Service
Automotive Technology Principles, Diagnosis, and Service
Automotive Technology Principles, Diagnosis, and Service
Presentation transcript:

Copyright 2002AST Training A.S.T. Training’s Introduction to Driver’s Seat Diagnostics.

Copyright 2002AST Training What is Driver’s seat diagnostics? What is drivers seat diagnostics What is needed to perform this Can anyone do this type of testing

Copyright 2002AST Training Equipment Needed Scan tool (s) Lab scope Your intelligence

Copyright 2002AST Training Where to begin Choosing an interface Mastering your scan tool

Copyright 2002AST Training 6 Main Inputs The most important data stream parameters to understand are the following 6 main inputs. Temperature, Load, Demand, O2, Fuel trim and RPM. All systems rely on these!

Copyright 2002AST Training Temperature Coolant temperature Ambient temperature Air charge temperature Barometric pressure

Copyright 2002AST Training RPM Everything centers around this. It take approximately 3 seconds to set a code. This input is used in many PCM strategies.

Copyright 2002AST Training Load MAP MAF Vane Air Flow Vacuum

Copyright 2002AST Training Demand Throttle position sensor.

Copyright 2002AST Training O2 Oxygen sensor Two types Several strategies

Copyright 2002AST Training Fuel Trim Fuel trim Short term Long term Integrator Block learn

Copyright 2002AST Training Knock Test while cranking. Used to retard timing.

Copyright 2002AST Training Synchronization Crank re-learn Set synch

Copyright 2002AST Training EGR Position Learn this value at idle. Look to see if open when commanded off.

Copyright 2002AST Training Future Multi-plexing Re-flashing Variable Valve timing Fuel content analysis Fuel pressure Etc….

Copyright 2002AST Training What other modes? Failure records Freeze frame Mode six Bi-directional tests Multi-plexing

Copyright 2002AST Training Failure Records Pass This Ignition Cycle Since Code Clearing DTC Monitor

Copyright 2002AST Training Freeze Frame Use this to qualify diagnosis process. Use to duplicate driving conditions while fault was present.

Copyright 2002AST Training Mode Six What is mode six ? Where is it located ? Will my tool do it? How can this be useful?

Copyright 2002AST Training Mode Six Real world example showing parameters.

Copyright 2002AST Training Misfire Counters Current Misfires History Misfires Put in Firing order

Copyright 2002AST Training Bi-directional tests Injector control Fuel trim EGR EVAP Ignition Coil Cooling Fans Relays RPM ETC…..

Copyright 2002AST Training Help Menus TSB Connector locations Specifications Schematics/pin- outs

Copyright 2002AST Training Help Menus Code Tips Symptom Tips Prom Re- flashing Yes the Snap-on and OTC can do this.

Copyright 2002AST Training What else is out there P/C programs Graphing

Copyright 2002AST Training Heads up stuff Chrysler Strategies Interpreted data

Copyright 2002AST Training Thank you

Copyright 2002AST Training

Copyright 2002AST Training Notes Page

Copyright 2002AST Training Check out some of our other products. Be sure to visit our web sites at: Sales: asttraining.com Information: asttraining.net