Electronic Systems Support CAN Branch PSU Designed: Bjorn Halgren PH-ESS Responsible:Paul Harwood.

Slides:

Advertisements

Similar presentations

1 S. Lusin, LV Cabling, CERN 06 Apr 06 LV Cabling 06 Apr 06 S. Lusin Fermilab / CERN Cabling from USC to UXC, Power Distribution.

Advertisements

Modular Capacity - Test - System CS

DCS aspects of TDAQ racks in USA15 and SDX1 Y. Ermoline et al. ATLAS Week, CERN, 15 February 2005.

Uli Schäfer, Mainz Univ. / ATLAS L1 Calorimeter Trigger ATLAS L1 Calorimeter Trigger / DCS ATLAS L1 Calorimeter Trigger Overview Signals monitored by DCS.

Status of DCS for TDAQ racks Y. Ermoline et al. ATLAS TDAQ Week, CERN, 27 April 2005.

CR1000s are only one part of a data acquisition system. To get good data, suitable sensors and a reliable data retrieval method are required. A failure.

CR1000s are only one part of a data acquisition system. To get good data, suitable sensors and a reliable data retrieval method are required. A failure.

8/11/2006 FPIX TB meeting L. Perera 1 Pixel Power Supply Response Measurement Lalith Perera - Univ. of Iowa Carlos Florez, Simon Kwan, Charles Newsom,

NEPTUNE Power System Low Voltage Circuit Preliminary Design Review Tim McGinnis Dec 4-5, 2003.

During a mains supply interruption the entire protected network is dependent on the integrity of the UPS battery as a secondary source of energy. A potential.

Module 2: Hardware and Terminology

The Potential Divider Electricity Lesson 10. Learning Objectives To know what a potential divider is. To derive and know how to use the potential divider.

Electrical & Control CM40 Daresbury Laboratory. CM40 Electrical Infrastructure Update RRM2 Latest Latest on Installation Progress Rack Allocations Racks.

Infrastructure for LHCb Upgrade workshop – MUON detector Infrastructure for LHCB Upgrade workshop: MUON power, electronics, cable Muon upgrade in a nutshell.

SCADA and Telemetry Presented By:.

A* candidate for the power supply Wiener MPOD-LV crate w/ remote control only (except for local on/off switch) Type “EC LV” Front or rear connections (reverse.

CMS ECAL End Cap EDR Meeting CERN 28 Nov. to 29 Nov 2000 A.B.Lodge - RAL 1 ECAL End Cap CMS ECAL End Cap Engineering Design Review. EDR meeting held 28.

Low Voltage Power Requirement of TOF FEEs. Maximum tray. Low Noise:  Periodic and Random Distortion (PARD) < few mV RMS Floating.

Identifying SLC 500™ System Components. SLC 500 System Options  The SLC 500 line of processors comprises both fixed and modular processor styles.:

EPICS Insertion Device Control System Pete Owens EPICS Collaboration Meeting June 2003 Control System for a Helical Undulator Pete Owens Daresbury Laboratory.

1 Low Voltage Power Supplies for ALICE TB L.Jirden u Recall: u target devices & possible solutions u Outstanding actions.

JPV, TB of Nov.15 th, ‘Rack Status‘ Jean-Pierre Vanuxem, PH-AIS.

Summary DCS Workshop - L.Jirdén1 Summary of DCS Workshop 28/29 May 01 u Aim of workshop u Program u Summary of presentations u Conclusion.

GENPRO Electrics & Electronics. . Switch Mode Power Supply-Output : 100A / 60 V-6KW GENPRO Electrics & Electronics.

Electronic Systems Support LHC Crates 2005 Paul Harwood PH Electronic Systems Support Group (PH-ESS) Meeting Sept 1, 2004.

Saverio Minutoli INFN Genova 1 1 T1 Electronic status Electronics Cards involved: Anode Front End Card Cathode Front End Card Read-Out Control card VFAT.

LKr Calorimeter Control and monitoring R. Fantechi 19/02/2010 R. Fantechi.

14 Sep 2005DAQ - Paul Dauncey1 Tech Board: DAQ/Online Status Paul Dauncey Imperial College London.

15/12/10FV 1 Common DCS hardware. General ideas Centralized system: o Common computers. Detector dedicated computers (with detector participation) only.

February 17-18, 2010 R&D ERL Bob Lambiase R&D ERL Power Supplies Bob Lambiase February 17-18, 2010 Power Supplies.

CMS ECAL End Cap Meeting CERN 19 June to 23 June 2000 A.B.Lodge - RAL 1 ECAL End Cap High Voltage Cards and 2000 Electrical/Thermal Model. Progress on.

DCS T0 DCS Answers to DCS Commissioning and Installation related questions ALICE week T.Karavicheva and the T0 team T0 DCS Answers to.

TPC/TRD DCS meeting, GSI, 27 Sep 2002Børge Svane Nielsen, NBI1 TPC laser system controls adjustable mirrors Laser Controls, Power, Cooling DCS: 1/ Laser.

LNL 1 SLOW CONTROLS FOR CMS DRIFT TUBE CHAMBERS M. Bellato, L. Castellani INFN Sezione di Padova.

André Augustinus 17 June 2002 Technology Overview What is out there to fulfil our requirements? (with thanks to Tarek)

Status of Global Trigger Global Muon Trigger Sept 2001 Vienna CMS-group presented by A.Taurok.

André Augustinus 6 October 2005 Cabling, Interlocks, Racks Some remarks.

The 3 parts of an electronic system are :

FP420 Low voltage supply Henning E. Larsen, INFN and Risoe 19. May 2006.

Electronic Systems Support Demonstrator Racks Rack coordination meeting 12 October 2004.

MSS2 HARDWARE ASSEMBLY  FROM LAURENT DERONT. FORMAT STANDARD 6U CRATE  1 ST BACKPLANE INTERFACE CONNECTOR DB37 (Front side) TO DIN (Back Side) 1.

Status of the Remote HV System 10 June 2015 TileCal week, upgrade session Roméo Bonnefoy, Romain Madar and François Vazeille ● Summary of performances.

LKR Working group Introduction R. Fantechi October 27 th, 2009.

André Augustinus 16 June 2003 DCS Workshop General Purpose Monitor.

Low Voltage Workshop, CMS Electronics Week CERN, 8 June 2010 W. Lustermann, ETH Zurich EB + EE LV systemOPFC MonitoringEB HV systemEE HV system.

Alice MTR DCS F.Jouve 15 th DCS workshop CERN 13/03/2006 UX-A,B,D Detector PVSS II Detector Ethernet Database(s) OPC client DIM client 1672 Detector ?

Endcap Signal Feedthrough Overview Endcap Signal Feedthroughs are constructed and tested in Victoria by Victoria and TRIUMF staff. Each feedthrough unit.

Fifth CMS Electronics Week EASY: a new SY1527-based Embedded Assembly SYstem May 7th, 2003 CAEN SpA.

Rev Server blade enclosure overview Power backplane Signal backplane Management module Reset Bottom.

What’s NEWONE ? Areas of Business Product Lines Share the Vision.

DCS Workshop, CERN MARCH ACORDE (Alice Cosmic ray detector) 60 scintillator modules (120 HV channels) Each module will have two scintillator counters.

NA62 straw tracker DCS Straw tracker overview Bulk power supply Power supply distribution and monitoring LV + monitoring HV Temperature monitoring Gas.

ATLAS DCS ELMB PRR, CERN, March 2002Fernando Varela ELMB Networks CAN/CANopen Interoperability of the ELMB Usage of the ELMB in ATLAS ELMB Networks Full.

Infrastructure for LHCb Upgrade workshop – MUON detector Infrastructure for LHCB Upgrade workshop: MUON power, electronics Muon upgrade in a nutshell LV.

Status of the DCS Richard Brenner (Uppsala University) " Structure of the DCS " Cabling of DCS sensors " Interlock " Status and near future plans.

Potential Dividers and their application as sensors Electricity Lesson 9.

ATLAS DCS ELMB PRR, March 4th 2002, H.J.Burckhart1 Embedded Local Monitor Board ELMB  Context  Aim  Requirements  Add-ons  Our aims of PRR.

22/03/11FV 1 NA62 DCS CAN bus lines. Short reminder General properties of CAN bus o Up to 64 nodes on one bus o Different devices need different buses.

D. EliaALICE week / DCS workshop - Sept 20, SPD Power Supply System DCS status Domenico Elia INFN Bari.

Cables Ian Crotty 8 May 2012 Cables for the RE4 Upscope in CMS News. The HV cables are in the Integration DB (INB/904) The Hv order is confirmed. Need.

New digital readout of HFRAMDON neutron counters Proposal Version 2.

André Augustinus 13 June 2005 User Requirements, interlocks, cabling, racks, etc. Some remarks.

1 DCS Meeting, CERN (vydio), Jun 25th 2013, A. Cotta Ramusino for INFN and Dip. Fisica FE Preliminary DCS technical specifications (v1.0) for the Gigatracker.

Requested hardware for Clermont-Ferrand in the test beam 2015 September 23 Roméo Bonnefoy and François Vazeille This material is provided by LPC and Collaboration:

FTK infrastructures and DCS 02/12/20101FTK Initial Design Review - A. Lanza  Crates  Single rack layout  Cabling  Rack placement  DSS  DCS.

Status of the CERN ATCA specification and tender

LKr status R. Fantechi.

Calorimeter Mu2e Development electronics Front-end Review

TTC System Status May 2007 System overview Production Status

Model Output Current Battery Life BATPSU VDC 2A 1.2Ah BATPSU VDC 2.3Ah

Presentation transcript:

Electronic Systems Support CAN Branch PSU Designed: Bjorn Halgren PH-ESS Responsible:Paul Harwood

16 June 2004 CAN Branch PSU 2 What is it? A 6U crate, containing Power supply modules (up to 8) CAN patch modules (up to 4) Control & monitoring (ELMB) Capacity Maximum of 16 isolated branches Each branch powering up to 32 CAN devices (depending on load)

16 June 2004 CAN Branch PSU 3 What does it do for you? Provides the required CAN supply voltages Provides a convenient method of ‘patching’ the CAN bus into the cabling to the remote devices Connects directly to a Kvaser interface Provides; via a CAN interface (DCS) Monitoring (current, voltage) of each CAN bus branch. ON/OFF control of each branch.

16 June 2004 CAN Branch PSU 4 Crate Details 6U x 160mm Contains ELMB for monitoring & control

16 June 2004 CAN Branch PSU 5 Power Supply Module 2 CAN branches Each branch electrically isolated 12V, 2A CAN bus supply 12V, 3A Digital + Analogue supply

16 June 2004 CAN Branch PSU 6 Patch Module 4 CAN branches Fitted to rear of crate, patches power & CAN bus together Takes 4 CAN inputs, or 1 25way connector from Kvaser interface

16 June 2004 CAN Branch PSU 7 Current Status Current activities Electrical, Thermal & Operational testing about to commence Building of 5 pre-production units to satisfy immediate requirements 5 crates, 20 PSU modules, 10 patch modules This gives 5 half populated crates (8 branches), or an alternate combination

16 June 2004 CAN Branch PSU 8 What will it cost? Costs are currently only estimates Final unit costs will depend on production quantities and the final production contractor Estimates shown below should be close, but could vary in either direction

16 June 2004 CAN Branch PSU 9 Current Actions Fix quantities required ALICE: ? ATLAS: CMS: ? LHCb: 3-6 Search for a suitable contractor to build and supply the production units (price enquiry) Complete the testing, including EMC, environmental etc. Review production aspects of the design, to improve cost, safety, reliability etc.

16 June 2004 CAN Branch PSU 10 Future Support PH-ESS will Procure Against advance payments As for VME crates, TTC equipment, VMEbus SBCs Test Provide second-line support Repair First-line support (spares) with experiments