Circuit Lab. Experiment-1 Int. To Circuit Components Lab. Devices and Voltage Measurement.

Slides:



Advertisements
Similar presentations
Chapter 7 Series-Parallel Circuits. Objectives Analyze series-parallel circuits Analyze loaded voltage dividers Analyze ladder networks Analyze a Wheatstone.
Advertisements

Introduction to Multisim ECE 1020 Professor Ahmadi.
EE188L EE I Laboratory Lab #2 Resistive Circuits.
Component Identification
Interactive Engineering Workshop Eng. Mageda Al-Moubarak Eng. Fadia El-ssa.
Simple Electronics: Ring Oscillator
Circuit Elements Electric circuit is the interconnection of circuit elements ActivePassive Not capable of generating energy e.g. resistor, inductor, capacitor.
Modeling conduction loss SEPIC example MOSFET R on, diode V D Averaged terminal voltages of switch network, including conduction losses:
University of Pennsylvania Basic Electronics Things to be covered: What is electricity Voltage, Current, Resistance Ohm’s Law Capacitors, Inductors Semiconductors.
Switching-Mode Regulators
ESE Lab Computer based Temperature Control Sid Deliwala, ESE Labs.
A Company Selling Technology and not just a Product.
Advanced Analog Circuits Seth Price Department of Chemical Engineering New Mexico Tech Rev. 1/26/15.
© Electronics ECE 1312 Taaruf Nor Farahidah Za’bah Room number : E Phone number : address : 
Electronic Instrumentation Experiment 1 * Part A: Circuit Basics, Equipment, Sound Waves * Part B: Resistors, Circuit Analysis, Voltage Dividers * Part.
Electric Curcuits and Measurements Basic Electrical components and their functions Measurements of electrical circuits characteristics - Multimeter - Oscilloscope.
1 KMUTT: S. Srakaew CPE 221 Introduction What is “Electronics”? Electric circuit Connections of conductive wires and passive devices Electronics circuit.
Blinking LED Lab David Luong Herrick Chang. Recall Capacitor Flash in disposable camera.
Chapter 12 Electronics.
Components, Quantities, and Units
Engineering H192 - Computer Programming Gateway Engineering Education Coalition Lab 4P. 1Winter Quarter Analog Electronics Lab 4.
The George Washington University School of Engineering and Applied Science Department of Electrical and Computer Engineering Circuit Design Verification.
Engineering H192 - Computer Programming Gateway Engineering Education Coalition Lab 2P. 1Winter Quarter Digital Electronics Lab 2.
Lab #5 Overview Activity #1 - Simulation of an Op-Amp inverting amplifier Activity #2 - Build and Test the Op-Amp inverting amplifier Activity #3 - Determining.
Circuit Lab. Experiment-4 Measurement of Time Constant, Rise Time, Step Response of a RC Circuit.
Instrumental Analysis Electrical Components and Circuits.
TA: Chris Reilly Group 5: Benjamin, Ramie, Zachary, Dinal.
Engineering H192 - Computer Programming The Ohio State University Gateway Engineering Education Coalition Lab 3P. 1Winter Quarter Analog Electronics Lab.
Introduction to Circuits – Practical Resources.  Reading resistors ▪
EE Lab Intro ELEC 106 Fundamentals of Electrical Engineering Dr. Ron Hayne.
1 ENGG1015 Tutorial Pro-Project Laboratory and Project 15 Oct (Supplementary notes, may be obsolete, NOT for examination) Learning Objectives  Identify.
Measuring the Current and Voltage of a 820 Ω Resistor Setting for Multimeter = 200 mA DC Measure Voltage in 2 V increments up to 20 V.
AN-NAJAH NATIONAL UNIVERITY DEPARTMENT OF ELECTRICAL ENGINEERING THREE PHASE THYRISTOR BRIDGE CONTROLLED BY MICROPROCESSOR PREPARED BY: NABEEL MASSRI MOUSA.
Forging new generations of engineers
Introduction to Labs By Behzad Malek.  Lab sessions  Lab: Tuesday-Session 1 (CBY B302: 13:30-14:30); Session 2 (CBY B302: 14:30-15:30) (Starts Jan 13.
Department of Electrical Engineering, National Taiwan Ocean University Basic Electronics 2/4/2015 Richard Kuo Assistant Professor.
+ Using Ohm’s Law to Build a Voltage Divider 1. + Learning Objectives Understand and demonstrate the engineering design process Use Ohm's Law as a tool.
ES220 Review.
ECS642U Embedded Systems Simple Electronics William Marsh.
Chapter 1 Introduction to Electronics
Lab instruments ELCT 201 Digital Multimeter Voltage Tester
Capacitor-Resistor Circuits
Syllabus Resistor Inductor Capacitor Voltage and Current Sources
University of Pennsylvania Basic Electronics Things to be covered: What is electricity Voltage, Current, Resistance Ohm’s Law Capacitors, Inductors Semiconductors.
1 Electrical Fundamentals We need some understanding of electrical fundamentals to do the lab exercises. Electric Circuit Consists of: –Power Source: Battery,
Circuit Elements. Objective of Lecture Introduce active circuit elements. Chapter 1.6 Introduce passive circuit elements.
Lab 7 Hints. Activity 1C, 1B Activity 1A Battery or power supply (in previous picture)
LT-Spice - IUCEE – Components Updated March 8, 2016 Copyright LTspiceman.
Praxis I 13 Oct Outline Component & Device Measurement and Instrument Datasheet How to build circuit using breadboard.
Components and their operation. SMART Funded by The National Science Foundation Diode A diode is an semiconductor component that, in general, will pass.
A Requirement for Superposition. Objective of Lecture Introduce the property of linearity Chapter 4.2.
How to Build a Digital Physical System - Lab Lecture 2.
ECE Group Members Samantha Starr BME Arduino Arianna Weinshel BME Sensors, Circuits Eden Woldemichael CE AM Radio Taylor Brooke EE Instrumentation,
Component Identification
Switching-Mode Regulators
Electrical Engineering Lab I
Electrical circuits, power supplies and passive circuit elements
Prototyping with Microcontrollers and Sensors
Chapter 1 Introduction to Electronics
Components, Quantities, and Units
Electrical circuits, power supplies and passive circuit elements
Reverse Engineered PIC-101 DC-DC converter example
Components and Schematics
TEXTBOOK Please be informed that the Electronics textbook will be available from next week at OSCENT, an engineering textbook selling booth arranged by.
Forging new generations of engineers
Electrical Engineering Lab I
Chapter 1 Introduction to Electronics
Electrical Engineering Lab I
Prepared by: Engr. Qurban Ali Memon Incharge of Final project Lab.
Lab Notebook: EECT 121 Evan Wilson
Presentation transcript:

Circuit Lab. Experiment-1 Int. To Circuit Components Lab. Devices and Voltage Measurement

DIGITAL MULTIMETER

ETS-7000 Digital Analog Training System

SFG-2120 FUNCTION GENERATOR

GDS-1102 DIGITAL OSCILLOSCOPE

GPC-3060D DC POWER SUPPLY

Circuit Components Passive –Resistor, capacitor, inductor, diode Active –BJT, JFET, MOSFET, triac, opamp

Resistor ( 

Resistor Reading

= =5600  =5.6 k  Tolerance %5

= =  =100 k  Tolerance %5

5.6 k  +/- % (5/100)=280  Min =5320 Max =5880

Capacitor (F) farad

Electrolytic Capacitors

Inductor (H) henry

Multimeter

Multimeter Connection

Protoboard (Breadboard)

DC Voltage Source ?

Setup circuit-1 V A = V B = V BA = V AB = GND

Setup circuit-2 V A = V B = V BA = V AB = GND 10 k Ohm

Setup circuit-3 V A = V B = V BA = V AB = GND 10 k Ohm 1 k Ohm

Simulation Software Spice based programs –LTSpice –OrCAD –MultiSIM –EWB –Proteus

Feedback: Privacy Policy Feedback
Do Not Sell My Personal Information
About project: SlidePlayer Terms of Service

© 2025 SlidePlayer.com. Inc. All rights reserved.