© 2007 Pearson Prentice Hall This work is protected by United States copyright laws and is provided solely for the use of instructors in teaching their courses and assessing student learning. Dissemination or sale of any part of this work (including on the World Wide Web) will destroy the integrity of the work and is not permitted. The work and materials from it should never be made available to students except by instructors using the accompanying text in their classes. All recipients of this work are expected to abide by these restrictions and to honor the intended pedagogical purposes and the needs of other instructors who rely on these materials. Lecture Outlines Chapter 17 College Physics, 6 th Edition Wilson / Buffa / Lou

Chapter 17 Electric Current and Resistance

Units of Chapter 17 Batteries and Direct Current Current and Drift Velocity Resistance and Ohm’s Law Electric Power

17.1 Batteries and Direct Current Electric current is the flow of electric charge. A battery is a source of electric energy—it converts chemical energy into electric energy.

17.1 Batteries and Direct Current In a complete circuit, electrons flow from the negative electrode to the positive one. The positive electrode is called the anode; the negative electrode is the cathode. A battery provides a constant source of voltage—it maintains a constant potential difference between its terminals.

17.1 Batteries and Direct Current The potential difference between the battery terminals when the battery is not connected to anything is called the electromotive force, emf.

17.1 Batteries and Direct Current The actual terminal voltage of the battery is always less than the emf, due to internal resistance. Usually the difference is very small.

17.1 Batteries and Direct Current When batteries are connected in series, the total voltage is the sum of the individual voltages.

17.1 Batteries and Direct Current When batteries of equal voltage are connected in parallel, the total voltage does not change; each battery supplies part of the total current.

17.1 Batteries and Direct Current

17.2 Current and Drift Velocity Current is the time rate of flow of charge. SI unit of current: the ampere, A

17.2 Current and Drift Velocity Historically, the direction of current has been taken to be from positive to negative; this is opposite to the way electrons flow. However, this seldom matters.

17.2 Current and Drift Velocity Electrons do not flow like water in a pipe. In the absence of voltage, they move randomly at high speeds, due to their temperature. When a voltage is applied, a very small drift velocity is added to the thermal motion, typically around 1 mm/s; this is enough to yield the observed current.

17.3 Resistance and Ohm’s Law If there is a potential difference across a conductor, how much current flows? The ratio between the voltage and the current is called the resistance. SI unit of resistance: the ohm, Ω

17.3 Resistance and Ohm’s Law An ohmic material is one whose resistance is constant.

17.3 Resistance and Ohm’s Law Ohm’s law is valid only for ohmic materials: The resistance of a particular object depends on its length, cross- sectional area, material, and temperature.

17.3 Resistance and Ohm’s Law As expected, the resistance is proportional to the length and inversely proportional to the cross-sectional area (why?): The constant ρ is called the resistivity, and is characteristic of the material.

17.3 Resistance and Ohm’s Law In this table, you can easily see the differences between the resistivities of conductors, semiconductors, and insulators.

17.3 Resistance and Ohm’s Law For many materials, the temperature dependence of the resistivity is approximately linear, as long as the temperature change is not too large. The constant α is called the temperature coefficient of resistivity. Some values of α are listed in the table on the previous page.

17.3 Resistance and Ohm’s Law Some materials exhibit a curious phenomenon: at a very low temperature called the critical temperature, their resistivity drops abruptly to zero. These are called superconductors; they have a number of unique properties. They are impractical for everyday home use, however, as they must be cooled to cryogenic temperatures.

17.4 Electric Power Power, as usual, is the rate at which work is done. For work done by electricity: Rewriting, For ohmic materials, we can write:

17.4 Electric Power So, where does this power go? It is changed to heat in resistive materials.

17.4 Electric Power Electric appliances are rated in watts, assuming standard household voltage.

17.4 Electric Power

The electric company typically bills us for kilowatt-hours (kWh), a unit of energy. We can reduce our energy usage by buying efficient appliances.

Review of Chapter 17 A battery produces emf; positive terminal is the anode, negative is the cathode. emf is measured in volts; it is the number of joules the battery supplies per coulomb of charge. An electric current can exist only in a complete circuit. Resistance:

Review of Chapter 17 Ohm’s law is obeyed if the resistance is constant: The resistance of an object depends on its length, cross-sectional area, and resistivity.

Review of Chapter 17 Power is the rate at which work is done.