TARBLASTER TEST RESULTS 14.04.09 Test period67 minutes Total oil sand feed50,64 kg Oil content7,19% Mass of carbon in sand1.519,2 grams Oil evaporated.

Slides:

Advertisements

Similar presentations

Enthalpy of Solution (HSOLN)

Advertisements

Assessment report (Digested) on The Kemco Witman by A Calcium Carbonate Producer who uses the Kemco Witman (2 units) in Japan “Kemco Witman” Centrifugal.

CO 2 Emission per Primary Energy Consumption Unit : 1,000 Tons-CO 2 /KTOE (FEB) Year

GASES Question 2: 1995 B Free Response Park, Sherrie Gangluff, per. ¾ AP Chemistry.

Session 4: Coal statistics United Nations Statistics Division International Workshop on Energy Statistics September 2012, Beijing, China.

APL AUTOMOBIL – PRÜFTECHNIK LANDAU GMBH Industriegebiet Ost Am Hölzel 11 D Landau Germany  Rapid Oil Consumption.

Limiting Reactant.

Moles, volume and density

Enthalpy. Specific Heat Capacity Definition: The HEAT ENERGY required to raise the TEMPERATURE of 1kg of substance by 1 o C. e.g. for water C= 4.18kJ.

HIGHER GRADE CHEMISTRY CALCULATIONS Molar Volume. The molar volume is the volume occupied by one mole of a gas. Worked example 1. In an experiment the.

Learning Module 3: Measuring Metabolic Rate Clark J Cotton.

Chemistry Notes Density. density – the mass of an object per unit volume ex) the density of a substance describes how tightly packed the molecules are.

COS- 2a Define mass, volume, and density. Question What will happen to the coke and diet coke if we place them water? Question What will happen to the.

OIL SHALE – contains Kerogen Tar sands – contain bitumen.

Daltons Law P t = P 1 + P 2 + P 3 +……. Daltons Law P t = P 1 + P 2 + P 3 +……. P t = x 1 p t + x 2 p t + x 3 p t +……. x = mole fraction p = total pressure.

Air, Earth, Fire and Water An Introduction to Environmental Science

60,200,000,000,000,000,000, x

Calculations in Chapter 10. Molar Enthalpy of Fusion Used when melting or freezing = ___energy ____ mol of substance Can be arranged to find any of the.

Mass – The amount of matter contained in an object. Units of mass: gram – g kilogram – kg tonne - t 1000 g = 1 kg 1000 kg = 1 t.

By Jessica, Jemimah and Katie. In society today, our main fuel sources are fossil fuels such as coal, oil and gas. However, these fossil fuels take millions.

Summary of The Mole. Converting from Moles to Number of Particles You Need to Know that: 1 mole = 6 x Particles Questions: 1.How many atoms are.

Stoichiometry II. Solve stoichiometric problems involving moles, mass, and volume, given a balanced chemical reaction. Include: heat of reaction Additional.

2 nd Semester Final Exam Practice Test Questions 30 minutes.

TARBLASTER A TECHNOLOGY FOR ”DRY” RECOVERY OF OIL FROM OIL SHALE WITH

Physical Science Units Review

Energy Problem Solving, LEVEL E Question 1 Question 2 Question 3 Question 4.

TARBLASTER A TECHNOLOGY FOR ”DRY” RECOVERY OF OIL FROM OIL SAND WITH NO WATER CONSUMPTION NO WATER CONSUMPTION EXTRACTION AND UPGRADING OF THE OIL IN ONE.

ICP Energy Resources Introduction 3/1/13. Warmup Explain what you know about how we as a society get energy.

Workshop Session on Solid Fuel Combustion or How I stopped preaching to the CHOIR and learned to love COAL Position paper: Crispin Pemberton Pigott New.

C3 revision April  Substances can be measured in several ways. They can be: ◦ Number of grams ◦ Number of particles ◦ Number of moles I mole is.

Phas e Changes. Solid to Liquid Melting Liquid SolidGas.

Energy Star. How energy star products help the consumer Save money Save energy Reduce carbon footprint.

Water Treatment for the Recycling of Process Rinse Water

Today, we will burn a gummy worm containing 2.1 g of sucrose (C 12 H 22 O 11 ). When one mole of sucrose burns in oxygen gas, it produces carbon dioxide.

Introduction to Geography By Arthur Getis Judith Getis Jerome D. Fellmann.

MOLE CONVERSION WORKSHEET

Relative Formula Mass expressed in grams

3.4Molar Volume Molar Volume The Molar Volume of Gases Multi-Step Conversions Involving the Volume of a Substance Molar Volume and Density.

© Oxford University Press 2011 IP Specific heat capacity of various materials Specific heat capacity of various materials.

SPECIFIC HEAT CAPACITY

Warm-Up (8/21) Classify carbon dioxide (CO 2 ) and oxygen gas (O 2 ). Be specific. Due Tomorrow: Homework #3: P. 28 #6-7 Homework #2: Describing Matter.

030715v1.0GJ Costello GMIT Slide 1 Introduction What’s a tonne of CO 2 ? The Kyoto Protocol is an international agreement to limit greenhouse gas (GHG)

Calculation of Enthalpy Values Using E = c m  T.

A characteristic property is something that is specific to that substance. (i.e. Density, melting point, boiling point) Non-characteristic properties.

Calculations Involving Density Calculating Density from Mass and Volume.

Specific Heat Capacity. Specific Heat Capacity (kJ/kg/°C) The specific heat is the amount of heat (measured in kJ) per unit mass (measured in Kg) required.

Experiments in respiration, RQ and alternative substrates.

Date of download: 6/25/2016 Copyright © ASME. All rights reserved. From: Prospects for Biofuels: A Review J. Thermal Sci. Eng. Appl. 2013;5(2):

Density of a Gas at STP Lesson # 4. 1.Calculate the density of N 2 at STP. Assume that you have 1 mole of N L 28.0 g =1.25 g/L litre grams Density=

Properties of Matter. What is Matter Anything that has mass and takes up space.

© Oxford University Press IP1.3.4 Specific latent heat Specific latent heat.

The Water Boiling Test (WBT)

The Water Boiling Test (WBT)

TYPES OF MILK USED FOR CHEESEMAKING

From: Prospects for Biofuels: A Review

Radu Zmeureanu Demba Ndiaye Michel Bernier

A physical property of matter

Outline Energy demand and prices Reserves and new sources of energy supply.

Density of a Gas at STP Lesson # 4.

Understanding Density

MATH UNIT #7 Measurement

Assumption: in a water / HC mixture, mass fraction is the same as volume fraction. Example 1: 99 kg HC (density 700 kg/m3) and 1 kg H2O (density 1000 kg/m3).

Density of a Gas at STP Lesson # 4.

5.1 Vector and Scalar Quantities

Aim: Full House Grid: 9 Grid Play: Calculate & cross it off

Conversions The universally accepted system of measurement is the SI System, the System Internationale d’Unites, or the International System, also known.

Simple machines.

Energy – M & M’s Energy.

What is the specific heat capacity of the metal?

Presentation transcript:

TARBLASTER TEST RESULTS Test period67 minutes Total oil sand feed50,64 kg Oil content7,19% Mass of carbon in sand1.519,2 grams Oil evaporated off2,12 litres Oil collected2,13 litres Yield by mass95,45% of evaporated mass of oil Yield by volume100,48% of evaporated volume of oil Energy in gas from combustor kJ Energy consumption25,66% of total HC in sand Energy in coke kJ

TARBLASTER TEST RESULTS Test period60 minutes Total oil sand feed46,259 kg Oil content5,5 % Mass of carbon in sand1.619,1 grams Oil evaporated off0,942 litres Oil collected0,881 litres Yield by mass88,9 % of evaporated mass of oil Yield by volume93,5 % of evaporated volume of oil Energy in gas from combustor kJ Energy consumption27% of total HC in sand Energy in coke kJ

TARBLASTER TEST RESULTS Test period40 minutes Total oil sand feed34,438 kg Oil content4,11 % Mass of carbon in sand344,38 grams Oil evaporated off1,416 litres Oil collected1,15 litres Yield by mass77,17 % of evaporated mass of oil Yield by volume81,24 % of evaporated volume of oil

TARBLASTER TEST RESULTS Test period40 minutes Total oil sand feed34,438 kg Oil content4,11 % Mass of carbon in sand344,38 grams Oil evaporated off1,416 litres Oil collected1,15 litres Yield by mass77,17 % of evaporated mass of oil Yield by volume81,24 % of evaporated volume of oil

TARBLASTER TEST RESULTS Test period60 minutes Total oil sand feed51,205 kg Oil content6,98 % Mass of carbon in sand1.536,15 grams Oil evaporated off2,039 litres Oil collected1,049 litres Yield by mass90,79 % of evaporated mass of oil Yield by volume95,57 % of evaporated volume of oil Energy in gas from combustor kJ Energy consumption15,62 % of total HC in sand Energy in coke kJ

TARBLASTER TEST RESULTS Test period60 minutes Total oil sand feed56,119 kg Oil content6,0 % Mass of carbon in sand1.964,2 grams Oil evaporated off1,401 litres Oil collected1,385 litres Yield by mass93,92 % of evaporated mass of oil Yield by volume98,86 % of evaporated volume of oil Energy in gas from combustor kJ Energy consumption15,62 % of total HC in sand Energy in coke kJ

TARBLASTER TEST RESULTS ESTONIAN OIL SHALE Test period55 minutes Total oil sand feed33,348 kg Mass of carbon in sand Oil evaporated off4 % of mass of shale Oil collected1,41 litres

TARBLASTER TEST RESULTS Test period45 minutes Total oil sand feed32,528kg Oil content6,3 % Mass of carbon in sand650,6 grams Oil evaporated off1,3917 litres Oil collected1,464 litres Yield by mass99,93 % of evaporated mass of oil Yield by volume105,19 % of evaporated volume of oil Energy in gas from combustor kJ Energy consumption20,51 % of total HC in sand Energy in coke kJ

TARBLASTER TEST RESULTS Test period100 minutes Total oil sand feed63,71kg Oil content7,2 % Mass of carbon in sand1.274,2 grams Oil evaporated off3,289 litres Oil collected3,445 litres Yield by mass99,51 % of evaporated mass of oil Yield by volume104,75 % of evaporated volume of oil Energy in gas from combustor kJ Energy consumption20,38 % of total HC in sand Energy in coke kJ

TARBLASTER GAS ANALYSIS H2S AND SO2

TARBLASTER GAS ANALYSIS

COMPARISON PRESENT PRODUCTION AND TARBLASTER PRODUCTION

PRESENT OIL SAND EMISSION 1,1 mill. bbl/day TARBLASTER EMISSION 1,1 mill. bbl/day