1 The Combined Margin Approach: Issues and Options Michael Lazarus, SEI/Tellus World Bank Power Sector Workshop Caesar Park Hotel, Buenos Aires December 8, 2004

2 Overview of Presentation  The problem  The options  The combined margin approach –Underlying rationale and practical considerations –Strengths and weaknesses  Next steps and new directions

3 What’s the problem?  Power sector projects and CERs depend on an unknowable counterfactual baseline  CERs = MWh project x (tCO2/MWh baseline - tCO2/MWh project )  Baseline methodologies should balance –Accuracy –Feasibility (cost and data availability) –Transparency –Consistency (over time and space) –Credibility  Standardize or proliferate?  Rely on simple or complex models?

4 A CDM electricity project might affect:  The choice and/or timing of new power plants (or life extension of existing ones), i.e. the build margin, and/or  The operation of existing power plants, i.e. the operating margin,  Depending on –Context: excess capacity, suppressed demand, fixed investments –Project characteristics: peak vs. baseload, load-following vs. resource-driven (firm vs. non-firm) –Market behavior: plans, intuition, and time-scale of interest (short- term vs. long-term) –Project size: Cumulative effects of small projects, delay vs. displace new capacity additions

5 Simplified representation

6 Potential impact of a small CDM project The maroon area shown above may represent delayed (i.e. avoided) new generation capacity.

7 What are the methodological options… …assuming that a CDM project has a mix of build and operating margin effects?  Use a model capable of reflecting all effects –full simulation or optimization models (not just dispatch)  Use models or algorithms to estimate each effect separately, and then combine them: –E.g. consolidated/small-scale CDM methodology, “CERUPT” methodology, consolidated CDM (ACM0002)  Decide which effect predominates and ignore the other

8 ACM0002 combined margin approach Calculate a baseline emission factor EFy as the weighted average of the Operating Margin emission factor (EF_OMy ) and the Build Margin emission factor (EF_BMy,): EFy = (wOM * EF_OMy) + (wBM * EF_BMy) where the weights wOM and wBM, by default, are 50% (i.e., wOM = wBM = 0.5)

9 OM and BM methods CDM Consolidated methodology (ACM002) currently contains:  4 options for calculating the operating margin: –Simple OM: Weighted-average emission rate excluding low-operating cost and must-run power plants –Simple Adjusted OM: Including some must-run/low-cost resources (e.g. hydro) where they dominate a grid –Dispatch data analysis OM –Average OM

10 And 1 option for calculating the build margin: …the generation-weighted average emission factor of a sample of power plants m, as follows, EF_BMy =  FUEL USE * EMISSION COEFF/GENERATION where the sample group m consists of either the 5 most recent or the most recent 20% of power plants built or under construction, whichever group’s average annual generation is greater (in MWh);  Option of ex ante or ex post analysis for either OM or BM

11 Combined margin results: CERUPT example Note CERUPT (2002) methodology shown here differs from ACM0002

12 Potential applications of the combined margin method  Zero or near-zero emission sources –renewable energy –energy efficiency? –several AMs and ACM0002  Lower-emission sources –Combined heat-and-power –New natural gas plants? –Added production from plant upgrade or repowering?  Uncertainties or errors have a much larger relative impact on lower-emission sources –Difference between project and baseline emission rates (tCO2/MWh) may be quite small

13 What are its strengths and weaknesses?  Strengths –Relative simplicity and feasibility: low-cost, manageable data and skill requirements –Incorporation of both OM and BM effects –Consistent and comparable across regions and projects –Relatively transparent and credible: data verifiable  Weaknesses/challenges –Applicability to larger investments, lower-emission (e.g. natural gas) projects –Justification of OM/BM weights (50/50 or other) –Dependence on lumpy, historical data for build margin –Application of dispatch analysis –Reflection of local market and operational conditions

14 Next steps and new directions  Enhancing the consolidated CDM methodology –More forward-looking, less volatile build margin methods –Weighting the operating and build margins based on project, context, and other factors –Standardized methods to fill “data gaps” –Applying/extending dispatch analysis and hydro-based system methods  Developing other methods –Model-based methodologies that are transparent and credible  Cross-country, cross-context comparisons  Complementary mechanisms to support low-GHG power sector investments and strategies?

15 SummarySummary  Combined margin is an umbrella term for any method that accounts for a project’s effects on both what is built and what operates in the future.  Simplified CM approaches can balance many competing objectives (accuracy, feasibility, consistency, transparency, credibility)  Considerable scope for improvement and new approaches

16 EXTRA SLIDES FOLLOW

17 Electricity Imports in ACM0002 For the purpose of determining the Operating Margin (OM) emission factor, as described below, use one of the following options to determine the CO2 emission factor(s) for net electricity imports (COEFi,j,imports) from a connected electricity system within the same host country(ies): (a) 0 tCO2/MWh, or (b) the emission factor(s) of the specific power plant(s) from which electricity is imported, if and only if the specific plants are clearly known, or (c) the average emission rate of the exporting grid, if and only if net imports do not exceed 20% of total generation in the project electricity system, or (d) the emission factor of the exporting grid, determined as described in steps 1,2 and 3 below, if net imports exceed 20% of the total generation in the project electricity system. For imports from connected electricity system located in another country, the emission factor is 0 tons CO2 per MWh.

18

19

20 Simple, adjusted OM (hydro-dominated)

21 Historical build margin (US) Capacity additions, recent and projected,–United States

22 GWh/h 0 5,000 10,000 15,000 20,000 25,000 30,000 Nuclear Geotérmica Eólica Carbón Ciclo Combinado Dual Vapor Hidráulica Turbogás DomingoLunesMartesMiércolesJuevesViernesSábado Example of weekly dispatch 5 al 12 de diciembre de 1999

23

24