Resistance to Frequency Converter Amol Mupid Andrew Ricketts.

Slides:

Advertisements

Similar presentations

A Stabilization Technique for Phase-Locked Frequency Synthesizers Tai-Cheng Lee and Behzad Razavi IEEE Journal of Solid-State Circuits, Vol. 38, June 2003.

Advertisements

Basic Electronics Ninth Edition Grob Schultz

Designing Sequential Logic Circuits

Design And Analysis of an improved version of triangle-to-sine wave conversion.

Oscillators with LC Feedback Circuits

Low-Noise Trans-impedance Amplifiers (TIAs) for Communication System Jie Zou Faculty Advisor: Dr. Kamran Entesari, Graduate Advisor: Sarmad Musa Department.

1 High Speed Fully Integrated On-Chip DC/DC Power Converter By Prabal Upadhyaya Sponsor: National Aeronautics and Space Administration.

8 Bits Gray Code Converter By: Dawei Kou Flora Wu Linda Htay.

Punjab EDUSAT Society (PES) Contact info: Phone: Oct,

Principles of Electronic Communication Systems

Chapter 6 FM Circuits.

 Distortion – the alteration of the original shape of a waveform.  Function of distortion analyzer: measuring the extent of distortion (the o/p differs.

Oscillators 2. LC Oscillators.

Oscillator Circuits. Outline Oscillators – Inverter-Based Oscillator – Introduction of Phase Noise Simulation – LC-Tank Based Oscillator Laplace Analysis.

ALL-DIGITAL PLL (ADPLL)

A Dynamic GHz-Band Switching Technique for RF CMOS VCO

Theoretical Analysis of Low Phase Noise Design of CMOS VCO Yao-Huang Kao; Meng-Ting Hsu; Microwave and Wireless Components Letters, IEEE [see also IEEE.

General Licensing Class G7A – G7C Practical Circuits Your organization and dates here.

Presented By Dwarakaprasad Ramamoorthy An Optimized Integrated QVCO for Use in a Clock Generator for a New Globally Asynchronous, Locally Synchronous (GALS)

Parallel LC Resonant Circuit Consider the following parallel LC circuit: –Treating as a voltage divider, we have: –Calculate the (complex) impedance Z.

Phase-Locked Loop Design S emiconducto r S imulation L aboratory Phase-locked loops: Building blocks in receivers and other communication electronics Main.

1 CMOS Temperature Sensor with Ring Oscillator for Mobile DRAM Self-refresh Control IEEE International Symposium on Circuits and Systems, Chan-Kyung.

Slide: 1International Conference on Electronics, Circuits, and Systems 2010 Department of Electrical and Computer Engineering University of New Mexico.

1 Process-Variation Tolerant Design Techniques for Multiphase Clock Generation Manohar Nagaraju +, Wei Wu*, Cameron Charles # + University of Washington,

Characterization of 1.2GHz Phase Locked Loops and Voltage Controlled Oscillators in a Total Dose Radiation Environment Martin Vandepas, Kerem Ok, Anantha.

1 Quarterly Technical Report 1 for Pittsburgh Digital Greenhouse Kyusun Choi The Pennsylvania State University Computer Science and Engineering Department.

 Lab assistants are: Dilara YALÇIN–Kami ÇEVİK  Labs are divided into two sections (same as course sections). Verify your section as soon as possible.

Zero Crossing Detector

Digital to Analog Converter for High Fidelity Audio Applications Matt Smith Alfred Wanga CSE598A.

S. -L. Jang, Senior Member, IEEE, S. -H. Huang, C. -F. Lee, and M. -H

Low Voltage Low Power constant - g m Rail to Rail CMOS Op-Amp with Overlapped Transition Regions ECEN /3/02 Vishwas Ganesan.

MSICT – RF Communication SoC POWER OPTIMIZED LC VCO & MIXER CO-DESIGN Daniel Götz, Milosz Sroka June 20th, 2006.

Jean-Marie Bussat – October 16, FPPA2000 Bias generator.

A New RF CMOS Gilbert Mixer With Improved Noise Figure and Linearity Yoon, J.; Kim, H.; Park, C.; Yang, J.; Song, H.; Lee, S.; Kim, B.; Microwave Theory.

McGraw-Hill © 2008 The McGraw-Hill Companies, Inc. All rights reserved. Principles of Electronic Communication Systems FM Circuits.

1 A Frequency Synthesizer Using Two Different Delay Feedbacks 班級：積體所碩一學生：林欣緯指導教授：林志明教授 Circuits and Systems, ISCAS IEEE International Symposium.

A GHz Fourth-Harmonic Voltage-Controlled Oscillator in 130nm SiGe BiCMOS Technology Yang Lin and David E. Kotecki Electrical and Computer Engineering.

A Tail Current-Shaping Technique to Reduce Phase Noise in LC VCOs 指導教授 : 林志明教授學生 : 劉彥均 IEEE 2005CUSTOM INTEGRATED CIRCUITS CONFERENCE Babak Soltanian.

A Wide-Input-Range 8 bit Cyclic TDC Reportor : Zhu kunkun.

Resistance to Frequency Converter Amol Mupid Andrew Ricketts.

Integrated VLSI Systems EEN4196 Title: 4-bit Parallel Full Adder.

Digital Microfluidics Control System II P Previous state - The previous control system is not self contained and uses a class AB amplifier which.

1 PD Loop Filter 1/N Ref VCO Phase- Locked Loop LO.

G7 - Practical Circuits 1 G7 - PRACTICAL CIRCUITS [3 exam question - 3 groups] G7A - Power supplies; schematic symbols G7B - Digital circuits; amplifiers.

1.0 LINEAR DC POWER SUPPLY The importance of DC Power Supply Circuit For electronic circuits made up of transistors and/or ICs, this power source.

1 The Link-On-Chip (LOC) Project at SMU 1.Overview. 2.Status 3.Current work on LOCs6. 4.Plan and summary Jingbo Ye Department of Physics SMU Dallas, Texas.

CommunicationElectronics Principles & Applications Chapter 5 Frequency Modulation Circuits.

EE141 Project: 32x32 SRAM Abhinav Gupta, Glen Wong Optimization goals: Balance between area and performance Minimize area without sacrificing performance.

Amplitude Modulation Circuits

Automatic Gain Control Circuit for Quartz Crystals By – Abhijat Goyal Saliya Subasinghe.

CSE598A Analog Mixed Signal CMOS Chip Design FM Mixer CMOS Realization (Final Presentation) Zhang Yi.

Guide Presented by Mr.M Cheenya V.Abhinav Kumar 11E31A0422 Asst.Professor K.Shiva Kumar 11E31A0423 K.Rajashekhar 11E31A0424 K.Chaithanya Sree 11E31A0428.

Low Power, High-Throughput AD Converters

Digital to Analog Converter for High-Fidelity Audio Applications Matt Smith Alfred Wanga CSE598A.

Varactor Diode or Varicap Diode Working and Applications.

Principles of Electronic Communication Systems. Chapter 6 FM Circuits.

Switched-mode power supply charger

Varactor Diode or Varicap Diode Working and Applications

LOAD CUTOFF SWITCH UPON OVER VOLTAGE OR UNDER VOLTAGE

EE434 Jason Adams Mike Dierickx

Signal Generators Term 8.

CSE598A Analog Mixed Signal CMOS Chip Design

Hugo França-Santos - CERN

EE 597G/CSE 578A Final Project

Ali Fard M¨alardalen University, Dept

A Novel 1. 5V CMFB CMOS Down-Conversion Mixer Design for IEEE 802

Vibration Energy Harvesting Circuit to Power Wireless Sensor Nodes

General Licensing Class

Which of the following devices or circuits changes an alternating current into a varying direct current signal? A. Transformer B. Rectifier C. Amplifier.

Presentation transcript:

Resistance to Frequency Converter Amol Mupid Andrew Ricketts

Outline Original design Component parts Roadblock Modified design Buffer optimization Design specification Conclusion

400  Chemiresistive Sensors RsRs R s : resistance of nanowire C : concentration of the gas A,α : constants that change with type of gas and temperature 350

Original design D CLK Q Qbar Rs V out R4 R1 R2 R3 C R5

Original design components Diode Spice simulation …but layout issues insurmountable

Original design components Zener Diode More simulations possible …but layout even more challenging

Modified design Key point is that what is desired is a way to control oscillations based on input voltage Voltage Controlled Oscillator (VCO) Buffer added to output to ensure rapid rise and fall of output square wave

VCO design LC tank oscillators Good phase noise with low power but tuning range is relatively low Output frequency may fall out of range due to process variations Spiral inductors occupy a lot of area, high cost and low yield issues. Ring oscillators Easy integration, high yield, low cost. Less chip area In-phase outputs

Single delay cell

Schematic of rectified VCO

Buffer optimization Initial single stage buffer Moved output close to binary Had difficulty clamping small swings about origin Double stage buffer Delay increase inconsequential Greatly improved clamping range

Layout of complete design

Transistor sizing Core area X162.6 = 7,926(um^2) TransistorWidth (um)Length (um) Mb Mp1,Mp Mp3,Mp Mn1,Mn MpInv MnInv6.00.6

Voltage dependant output periodicity

Power dissipation ( mW)

Resistance We want the Vcontrol be to be in between operable range => Rs*VDD/ (Rs+ R) has to be in between 3.3V and 5V Rs R Vcontrol

Conclusion The change in the sensor resistance can be detected in “ns” range and converted to square wave pulses This completely eliminates the need of ADC, huge potential resource savings. Successfully overcame practical design issues and produced desired results.

Thank You Questions??