WIRELESS SAW SENSOR DRIVER Fangzhou Chen Joe Tomanelli Rong Jin Xiaoxiao Wang.

Slides:



Advertisements
Similar presentations
Amplifying Signals Breadboarding: from a diagram to an actual working amplifier.
Advertisements

WORK PRINCIPLE AM RADIO RECEIVER Competency : Repairing of Radio Receiver.
Chapter 10 Analog Integrated Circuits The 741 OP-AMP Introduction.
Mechatronics and microprocessor. Outline Introduction System and design of system Control, measurement and feed back system Open and closed loop system.
Launchpad P1.1 attached to touch screen top P1.2 attached to touch screen right.
System Level Design Review P10054 October 9, 2009 Monitoring Device for Human Smoking Behavior.
Signal Conditioning.
Introduction What is an oscilloscope?.
Instrumentation System  A Measuring system is required to compare a quantity with a standard or to provide an output that can be related to the quantity.
Power Consumption Measurement and Clock Synchronization on Low-Power Wireless Sensor Networks Author : Yu-Ping Chen, Quincy Wu 1.
Author : Yu-Ping Chen, Quincy Wu
Transmission Media / Channels. Introduction Provides the connection between the transmitter and receiver. 1.Pair of wires – carry electric signal. 2.Optical.
Jess UEAB 2006 Television Tuner. Jess UEAB 2006 Section of the Tuner VHF Tuner UHF Tuner Automatic Fine Tuning AFT Remote control.
Wireless Data Acquisition System and its application for electrical emission measurement in Substations Supervised by Dr. W.H.Siew Presented by Yu Wang.
Signal Generator Lab Enrico Santi. © 2000 Prentice Hall Inc. Figure 1.6 Typical flowchart for design of electronic systems. Electronics Design.
Using Electricity. Q: WHAT IS A "VAN DE GRAAFF MACHINE"? A: A Van de Graaff machine is a mechanical- electric device which produces extremely high voltage.
NSF Funded Project “Enhancing the Electrical and Computer Engineering Curriculum by Integrating Applications of Wireless Technology” NSF TUES Type 1 Project,
Receivers.
Modern Electronic Communication 9th edition Jeffrey S. Beasley and Gary M. Miller Copyright ©2008 by Pearson Education, Inc. Upper Saddle River, New Jersey.
Nilufa Rahim C2PRISM Fellow Sept. 12, What is Engineering? Engineering is the field of applying Science and Mathematics to develop solutions that.
ECE 4991 Electrical and Electronic Circuits Chapter 8.
ELEKTRONIKOS ĮTAISAI 2007 VGTU Elektronikos Acoustic Wave Electronic Devices 1.Integrated circuits (ICs) were proposed.
Rate in the Electrical System. 1. What is the prime mover in the electric system? - voltage 2. What is electric rate? - amount of charge that flows through.
1 Electronic Circuits MULTI STAGE AMPLIFIERS. 2 Electronic Circuits There are several different multi-stage amp circuits that function as dc-amps. 1)COMPLIMENTARY.
ELECTRONICS PRIMER II.
Current Electricity - Symbols Draw the symbol for each electrical device.
How computers work The CPU & Memory. The parts of a computer.
Spencer/Ghausi, Introduction to Electronic Circuit Design, 1e, ©2003, Pearson Education, Inc. Chapter 1, slide 1 Introduction to Electronic Circuit Design.
EE 445 Course Presentation Power System Protection
Outline Introduction & BackgroundSystem Description & DiagramSpecificationsDesign – Four StagesFuture Development 211/22/2006.
Name Of The College & Dept
Surgical Electrotechnology Presenter:Ren-Yui Chen Adviser:Dr. Yi-Chun Du Date:2014/12/03.
Work Breakdown Schedule. Components Research and find all components  Pressure Sensor  Micro controller  LED Display  Operational Amplifier Order.
Name Of The College & Dept
Lecture Nine Physics 100 Fall 2012  Review of Labs on Series and Parallel Circuits.
MOBILE SNIFFER WITH PAGING. UNDER THE GUIDENESS OF : Dr. SANTHOSH KULKARNI PROFESSOR.
Presented by Yin Xu Saide Zhu Saide Zhu Lening Wang Lening Wang New York Institute of Technology 2.1 GHz Passive SAW Sensor Driver.
Simulink Simscape by Dr. Amin Danial Asham.
Surface Acoustics Wave Sensors. Outline Introduction Piezoelectricity effect Fabrication of acoustic waves devices Wave propagation modes Bulk Wave sensor.
SDR Architectures Bilal Saqib. Software Execution Procedure in SDR  SDR should be compatible with various hardwares and softwares. 1.
Bar code scanner Department of Computer Engineering, M.S.P.V.L. Polytechnic College, Pavoorchatram.
“Enhancing the Electrical and Computer Engineering Curriculum by Integrating Applications of Wireless Technology” PI: Tao Zhang, Ph.D., (SoECS)PI: Tao.
Bus Seat Sensor Network By: Jason Hady, Michael Stevens, Wyrgy Pamphile.
1. 2 The electrocardiograph (ECG) is an instrument, which records the electrical activity of the heart. Electrical signal from the heart characteristically.
Eeng Chapter4 Transmitters and Receivers  Generalized Transmitters  AM PM Generation  Inphase and Quadrature Generation  Superheterodyne Receiver.
Crystal Oscillator Circuit and Its Working
Chapter 29 Amplifier Applications. Objectives After completing this chapter, you will be able to: –Describe the operation of: —direct coupled amplifiers.
CHOPPER AMPLIFIER Chop means sample.
A Wireless Local Area Network by Raymond Woodward.
Department of Electrical Engineering, National Taiwan University of Science and Technology EURASIP Journal on Wireless Communications and Networking.
Submitted by Revathy k 12mec015 Msc ecs Guide:nandini mam.
Project 3: Development of Wireless Gas Detectors REU Student: Jose Vigil Graduate mentors: Chris Hughes, Xiaochen Wang Faculty Mentor(s): Dr. Hyoung.
Electrical Engineering
Rectifiers, Filters and Regulator
Matthew Storey and Dana Weinstein, Purdue University
Prof. Sajid Naeem (DOES – PC)
MULTISTAGE AMPLIFIERS
C H A P T E R 10 Feedback Microelectronic Circuits, Sixth Edition
LEVEL CONTROL USING ULTRASONIC
INTRODUCTION PRESENTATION: OSCILLOSCOPE..
Design of a Wireless Biological Signal Conditioning System1
Green Energy Management Systems (G.E.M.S)
Project Ambulare Junran Chen, Linh Tran, Branden Youssef
The operational amplifier
Modeling in the Frequency Domain
V.V.Harish Baba ECE – 7 K.Sandeep ECE – 24
Chapter 1 Introduction to Electronics
Design Of Low-Power Wireless Communication System Based On MSP430
V.V.Harish Baba ECE – 7 K.Sandeep ECE – 24
Nanomaterial-based sensors as a volatolomic analytical platform: simplified working mechanisms. Nanomaterial-based sensors as a volatolomic analytical.
Presentation transcript:

WIRELESS SAW SENSOR DRIVER Fangzhou Chen Joe Tomanelli Rong Jin Xiaoxiao Wang

Introduction S A W

Introduction Surface Acoustic Wave

Introduction SAW Sensor Electrical Signal Mechanical Wave

Introduction Structure

Introduction New SAW bio sensors

Introduction Extremely Small SAW sensor

Introduction SAW Sensor Driver Circuit SAW Sensor

Block Diagram

Device Explanation RF Generator: MAX2750EUA+

Device Explanation LaunchPad: LAUNCHXL-F28027:C2000 Piccolo LaunchPad CPU A/D Process

Device Explanation Power Amp. : SE2574L Two-level Amplifying

Device Explanation Circulator: SFC2040A

Conclusion/Summary

Feedback: Privacy Policy Feedback
Do Not Sell My Personal Information
About project: SlidePlayer Terms of Service

© 2024 SlidePlayer.com. Inc. All rights reserved.