S7C3 – Switch Configuration 2900 vs 4000

Wiring the Switch Switch to Switch Ethernet ports – crossover Access or Trunk Port –Default is Access Port –Trunk port requires encapsulation type Speed, Duplex method –Must match If not, blocked port denoted by orange light

Basic Configuration Basic configuration of the switch including: Clearing a configuration Setting a password Naming the switch Configuring the switch for remote access Identifying individual ports Defining link speed Defining line mode on a switch

IOS Features Important IOS features such as: Command line recall Using the help feature Show commands Password recovery Verifying connectivity Saving the configuration Backup and restoration of a configuration using a TFTP server

4000 Configuration Clear config all Reset Set password cisco Set logout 20 Set hostname SanSwitch Set interface sc0 1 n.n.n.n s.s.s.s bc address Set IP route n.n.n.n Set port speed 2/3 100 –Show commands Show module

2900 Configuration Clear start Delete vlan.dat Reload Hostname AL2900

Recalling Commands 2900 –Same as router CTRL+P or UP arrow key 4000 –^aaa^bbb recalls previous command & substitutes –!n aaarecalls command n and appends aaa –!! Repeats previous command –!nrepeats command n in the buffer

Help 2900 –Same as router Show ? 4000 –Set system ? Set system name Set system baud

Show commands 2900 –Same as router 4000 Console> (enable)show module

Time Outs 2900 –(config-line)# exec-timeout –Console > (enable) set logout 20

Transferring Files – TFTP Server 2900 –Same as router 4000 –Write net Provide IP address of remote host Configuration file name is cat –Configure network Provide OP address of remote host Configuration file name is cat