Physical States for Bits. Black Box Representations.

Slides:



Advertisements
Similar presentations
Digital CMOS Logic Circuits
Advertisements

Chapter 10 Digital CMOS Logic Circuits
CMOS Logic Circuits.
Digital Logic & Design Dr. Waseem Ikram Lecture 06
Ch 3. Digital Circuits 3.1 Logic Signals and Gates (When N=1, 2 states)
Digital Electronics Logic Families TTL and CMOS.
Elettronica T A.A Digital Integrated Circuits © Prentice Hall 2003 Inverter CMOS INVERTER.
Logic Families and Their Characteristics
S. Reda EN160 SP’08 Design and Implementation of VLSI Systems (EN01600) Lecture 19: Combinational Circuit Design (1/3) Prof. Sherief Reda Division of Engineering,
Electrical and Timing Characteristics of Standard Logic Gates (Lecture #2) ECE 331 – Digital System Design.
ISLAMIC UNIVERSITY OF GAZA Faculty of Engineering Computer Engineering Department EELE3321: Digital Electronics Course Asst. Prof. Mohammed Alhanjouri.
Microelectronic Circuits, Sixth Edition Sedra/Smith Copyright © 2010 by Oxford University Press, Inc. C H A P T E R 13 CMOS Digital Logic Circuits.
CMOS gates Electrical characteristics and timing TTL gates
EE 365 Introduction, Logic Circuits. Digital Logic Binary system -- 0 & 1, LOW & HIGH, negated and asserted. Basic building blocks -- AND, OR, NOT.
EE365 Adv. Digital Circuit Design Clarkson University Lecture #4
Lecture #24 Gates to circuits
Fig Operation of the enhancement NMOS transistor as vDS is increased
Physical States for Bits. Black Box Representations.
EE365 Adv. Digital Circuit Design Clarkson University Lecture #5
3.3 CMOS Logic 1. CMOS Logic Levels NextReturn Logic levels for typical CMOS Logic circuits. Logic 1 (HIGH) Logic 0 (LOW) Undefined Logic level 5.0V 3.5V.
© 2000 Prentice Hall Inc. Figure 6.1 AND operation.
Digital CMOS Logic Circuits
ECEN 248: INTRODUCTION TO DIGITAL SYSTEMS DESIGN Lecture 5 Dr. Shi Dept. of Electrical and Computer Engineering.
CIS 6001 Gates Gates are the building blocks for digital circuits Conventions used is high voltage = 1 and ground = 0 Inverter and NOT Gate are two terms.
Microelectronic Circuits - Fourth Edition Sedra/Smith 0 Fig Switching times of the BJT in the simple inverter circuit of (a) when the input v 1 has.
Logic Families Introduction.
UNIT – V CMOS LOGIC: CMOS logic levels, MOS transistors, Basic CMOS Inverter, NAND and NOR gates, CMOS AND-OR-INVERT and OR-AND-INVERT gates, Implementation.
EET 252 Unit 2 Integrated Circuit Technologies
Digital logic families
CSET 4650 Field Programmable Logic Devices
EET 1131 Unit 9 Logic Families
Chapter 10 Digital Integrated Circuits
Logic Families and Their Characteristics
Chapter 7 Complementary MOS (CMOS) Logic Design
1 Delay Estimation Most digital designs have multiple data paths some of which are not critical. The critical path is defined as the path the offers the.
Digital Design: Principles and Practices
Electrical Characteristics of Logic Gates Dr. Ashraf Armoush © 2010 Dr. Ashraf Armoush.
EGRE 427 Advanced Digital Design Figures from Application-Specific Integrated Circuits, Michael John Sebastian Smith, Addison Wesley, 1997 Chapter 2 CMOS.
Microelectronic Circuits, Sixth Edition Sedra/Smith Copyright © 2010 by Oxford University Press, Inc. C H A P T E R 14 Advanced MOS and Bipolar Logic Circuits.
Chapter 07 Electronic Analysis of CMOS Logic Gates
16-1 McGraw-Hill Copyright © 2001 by the McGraw-Hill Companies, Inc. All rights reserved. Chapter Sixteen MOSFET Digital Circuits.
Chapter 4 Logic Families.
Microelectronic Circuits - Fourth Edition Sedra/Smith 0 PowerPoint Overheads to Accompany Sedra/Smith Microelectronic Circuits 4/e ©1999 Oxford University.
1.0 INTRODUCTION  Characteristics of the active electronic components that determine the internal construction and operation of electronic circuitry.
CS/EE 3700 : Fundamentals of Digital System Design
Figure 3.1 Logic values as voltage levels Figure 3.2 NMOS transistor as a switch DrainSource x = "low"x = "high" (a) A simple switch controlled by the.
IC Logic Families Wen-Hung Liao, Ph.D.
Linear Delay Model In general the propagation delay of a gate can be written as: d = f + p –p is the delay due to intrinsic capacitance. –f is the effort.
VLSI Design Lecture 5: Logic Gates Mohammad Arjomand CE Department Sharif Univ. of Tech. Adapted with modifications from Wayne Wolf’s lecture notes.
Please see “portrait orientation” PowerPoint file for Appendix A Figure A.1. Light switch example.
CMOS Logic.  The CMOS Logic uses a combination of p-type and n-type Metal-Oxide-Semiconductor Field Effect Transistors (MOSFETs) to implement logic gates.
Chapter 3 How transistors operate and form simple switches
1. Digital cmos.2 10/15 Figure 10.1 Digital IC technologies and logic-circuit families. Digital IC Technologies CMOS & Pass Transistor Logic dominate.
Introduction to Electronic Circuit Design
Solid-State Devices & Circuits
Chapter 6 Copyright © 2004 The McGraw-Hill Companies, Inc. All rights reserved. High-Speed CMOS Logic Design.
CMOS Logic Gates. NMOS transistor acts as a switch 2 When gate voltage is 0 V No channel is formed current does not flow easily “open switch” When gate.
EE Electronics Circuit Design Digital Logic Gates 14.2nMOS Logic Families 14.3Dynamic MOS Logic Families 14.4CMOS Logic Families 14.5TTL Logic.
ECE DIGITAL LOGIC LECTURE 5: BINARY LOGIC AND DIGITAL LOGIC GATES Assistant Prof. Fareena Saqib Florida Institute of Technology Fall 2016, 01/28/2016.
Physical Properties of Logic Devices Technician Series Created Mar
Circuit Delay Performance Estimation Most digital designs have multiple signal paths and the slowest one of these paths is called the critical path Timing.
Chapter 33 Basic Logic Gates. Objectives After completing this chapter, you will be able to: –Identify and explain the function of the basic logic gates.
Electrical Characteristics of Logic Gates
EI205 Lecture 3 Dianguang Ma Fall, 2008.
KS4 Electricity – Electronic systems
KS4 Electricity – Electronic systems
Waveforms & Timing Diagrams
KS4 Electricity – Electronic systems
Digital Logic Experiment
Department of Electronics
Presentation transcript:

Physical States for Bits

Black Box Representations

Truth Tables

Basic Logic Gates

NAND and NOR gates

Sum of Products Circuits

Timing Diagrams

Logic Levels for CMOS

The concept of voltage- controlled resistance

nMOS transistor

pMOS transistor

Now we put together nMOS and pMOS transistors to create an inverter

Switch Model for CMOS inverter

Logical operation of CMOS inverter

Explanation of 2-input CMOS NAND gate

Switch Model for NAND realized in CMOS

Explanation of CMOS NOR

CMOS NAND with 3 inputs

Example of realization of large NAND gates in CMOS

Buffers realized in CMOS

AND gate in CMOS

AND-OR-INVERT gate in CMOS

CMOS OR-AND-INVERT

Data Sheets and how to use them

Test Circuits and Waveforms

Input-Output Characteristics

Logic Levels and Noise Margins for CMOS logic family

Resistive Models of Inverters

Resistive model for CMOS LOW output with resistive load

Black Box Representations Resistive model for CMOS HIGH output with resistive load

Circuit defintions to calculate currents

Output loading specifications

Estimating sink and source currents

CMOS inverters with nonideal input voltages

Black Box Representations CMOS inverter with load and nonideal 1.5 voltage input

Black Box Representations CMOS inverter with load and nonideal 3.5 voltage input

What to do with non-used inputs?

Transition times

How to analyze transition times for CMOS output?

Model of HIGH-to-LOW transition

Fall time

Model of a CMOS Low-to-High Transition

Rise time for a LOW-to-HIGH transition of a CMOS Output

Propagation Delays for a CMOS inverter

Worst-Case Timing using logic-level boundary points

Ground bounce in an IC with eight inverters and one ground pin

CMOS transition gate

Two-input multiplexer using CMOS transmission gates

Schmitt-Trigger Inverter

Operation with slowly changing inputs

CMOS three-state buffers

Open-Drain CMOS NAND

Open-Drain CMOS NAND gate driving a load

Rising and Falling transitions of an open-drain CMOS output

Driving a LED with an open- drain output

Driving a LED with standard CMOS output

Eight Open-Drain Outputs driving a bus

Wired-AND function on three open-drain NAND-gate outputs

Two CMOS outputs trying to maintain opposite values on the same line

Black Box Representations Four open-drain outputs driving two inputs in the LOW state

Four open-drain outputs driving two inputs in the HIGH state

Input and output levels for CMOS devices using a 5V supply

Transfer characteristics of HC and HCT circuits

Speed and power characteristics of CMOS families operating at 5V

Input specifications for CMOS families with V CC between 4.5 V and 5.5V

Black Box Representations

ECL 2-input OR/NOR

Problems for quizzes

Black Box Representations