CCNA1 v3 Module 5 v3 CCNA 1 Module 5 JEOPARDY K. Martin Galo Valencia.

Slides:



Advertisements
Similar presentations
© 2000, Cisco Systems, Inc. 3-1 Chapter 3 Assembling and Cabling Cisco Devices.
Advertisements

IST 201 Chapter 5. LAN Technologies Ethernet – most widely used technology in LANS In 1970, developed and implemented by: Digital Intel Xerox IEEE
CSC 450/550 Part 3: The Medium Access Control Sublayer More Contents on the Engineering Side of Ethernet.
ETHERNET By:- Introduced By:- Saleh Al-Ghamdi Abdullah Al-Yabis Uthman Al-Amoudi King Fahd University of Petroleum & Minerals College.
Networks & telecommunications Part 2 July 2, 2012.
Module 5 Cabling LANs and WANs.
Network Hardware. Computer Center, CS, NCTU 2 Network Performance Issues  Three major factors Selection of high-quality hardware Reasonable network design.
WXES2106 Network Technology Semester /2005 Chapter 2 Networking Media CCNA1: Module 3, 4 and 5.
CCNA 1 v3.1 Module 5 Review.
1 © 2004, Cisco Systems, Inc. All rights reserved. CCNA 2 v3.1 Module 1 WANs and Routers.
Physical Implementations Many physical implementations carry traffic across the WAN Needs vary, depending on the: – distance of the equipment from the.
Network Devices By Scott Burden & Linnea Wong Hubs Intelligent hubs have console ports, to allow monitoring of the hubs status and port activity. Passive.
Physical media Coaxial Twisted pair Fiber optic 1.
Basic Parts of a Network for beginners. Network Interface Cards A network interface card (NIC) is a circuit board or card that is installed in a computer.
Transceivers | Media Converters | Optic Cables © FluxLight 2015 EXPANDING FIBER OPTIC NETWORKS WITH SFP TRANSCEIVERS.
CCNA Semester I Unit 5 – Cabling LANs and WANS Karl WickSUNY Ulster.
CABLING LANs & WANs Module 5 Semester I.
LAN Wiring & Physical Interfaces Lecture 6. Network Interfaces Every device has some form of a network interfaces. A PC has a Network Interface Card (NIC).
Oct-03 ©Cisco Systems CCNA Semester 1 Version 3 Comp11 Mod5 – St. Lawrence College – Cornwall Campus, ON, Canada – Clark slide 1 Cisco Systems CCNA Version.
Semester 1 Module 5 Cabling LANs and WANs. Ethernet Standards.
1 Cisco CCNA Semester 1 Chapter 5 v3.0 Presented by: Terren L. Bichard Cabling LANS and WANS.
Chapter 2: Physical Layer
CISCO NETWORKING ACADEMY PROGRAM (CNAP)
Network Devices.
1 © 2003, Cisco Systems, Inc. All rights reserved. CCNA 2 Module 1 WANs and Routers.
Topologies The structure of the network –Physical topology Actual layout of the media –Logical topology How the hosts access the media.
1 © 2003, Cisco Systems, Inc. All rights reserved. CCNA 2 v3.0 Module 1 WANs and Routers.
1 © 2003, Cisco Systems, Inc. All rights reserved. CCNA 2 v3.0 Module 1 WANs and Routers.
IT Essentials 1 Chapter 8 JEOPADY RouterModesWANEncapsulationWANServicesRouterBasicsRouterCommands RouterModesWANEncapsulationWANServicesRouterBasicsRouterCommands.
Cisco 1 - Networking Basics Perrine. J Page 110/11/2015 Chapter 5 Which of the following is an 802.3u specification? 1.10BASE-F 2.10BASE-T 3.100BASE-TX.
Modern Ethernet Chapter 6. Contents Define the characteristics, cabling, and connectors used in 10BaseT and 10BaseFL Explain how to connect multiple Ethernet.
1 © 2004, Cisco Systems, Inc. All rights reserved. CCNA 1 v3.1 Module 5 Cabling LANs and WANs.
1 © 2004, Cisco Systems, Inc. All rights reserved. CCNA 1 v3.1 Module 5 Cabling LANs and WANs.
CCNA 1 v3.0 Module 5 Cabling LANs and WANs. Purpose of This PowerPoint This PowerPoint primarily consists of the Target Indicators (TIs) of this module.
1 © 2003, Cisco Systems, Inc. All rights reserved. CCNA 1 v3.0 Module 5 Cabling LANs and WANs.
1 © 2004, Cisco Systems, Inc. All rights reserved. CCNA 1 v3.1 Module 5 Cabling LANs and WANs.
CT1303 LAN LECTURE 15.
1 Version 3.0 Module 5 Cabling LANs and WANs. 2 Version 3.0 LAN Physical Layer Various symbols are used to represent media types. Each computer network.
Copyright CCNA 1 Chapter 4, Part 2 Cabling LANs and WANs By Your Name.
CCNA 2 Week 1 Routers and WANs. Copyright © 2005 University of Bolton Welcome Back! CCNA 2 deals with routed networks You will learn how to configure.
Fundamentals Of LAN and WAN Chapter 4 powered by DJ.
DCN286 Introduction to Data Communication Technology Session 6.
Planning and Cabling Networks
CCNA1 v3 Module 5 v3 CCNA 1 Module 5 JEOPARDY S Dow.
Topology, refers to the physical and logical diagrams which summarize network connections and information flow.
NET 324 D Networks and Communication Department Lec1 : Network Devices.
In a client/server arrangement, network services are located on a dedicated server. The server is a central computer that is continuously available to.
Discovery 2 Internetworking Module 3 JEOPARDY K. Martin.
Ethernet media and connector requirements 10BASE210BASE510BASE-T100BASE-TX100BASE-FX Media50-ohm coaxial (Thinne t) 50-ohm coaxial (Thicknet) EIA/TIA.
CCNA1 v3 Module 3 v3 CCNA 1 Module 3 JEOPARDY S Dow.
01_NF_Ch10 - Planning and Cabling Networks KT Lo.
Introduction to Computer Networking Connecting to a Router M Clements.
1 © 2003, Cisco Systems, Inc. All rights reserved. CCNA 1 v3.0 Module 5 Cabling LANs and WANs.
1 Pertemuan 2 Routers. Discussion Topics Introduction to WANs Router physical characteristics Router external connections Management port connections.
1 Pertemuan 12 Cabeling WANs. Discussion Topics WAN physical layer WAN serial connections Routers and serial connections Routers and ISDN BRI connections.
Network Components and terms. Hub is a device for connection multiple ethernet devices together and making then act as a single network segment.
This courseware is copyrighted © 2016 gtslearning. No part of this courseware or any training material supplied by gtslearning International Limited to.
© 2006 Cisco Systems, Inc. All rights reserved.Cisco PublicITE I Chapter 6 1 Cisco Routers.
Lecture 2 unit 1.
Assembling and Cabling Devices. Physical Data Link (MAC layer) LAN Physical Layer Implementations Ethernet 100baseTX 10BaseT Base510Base2 100baseFX.
LECTURE 11 NET301 11/16/2015Lect IEEE LAN STANDARDS Ethernet LAN (by Xerox): Topology: Bus Transmission Media: Thick Coaxial Cable. Signal: Digital.
Network Hardware.
Network Hardware.
CCNA 1 v3.1 Module 5 Cabling LANs and WANs
CCNA 1 v3 JEOPARDY Module 3 CCNA1 v3 Module 3 S Dow.
Module 5 Cabling LANs and WANs
Network Hardware.
CCNA 2 v3.1 Module 1 WANs and Routers
CCNA 1 v3 JEOPARDY Module 3 CCNA1 v3 Module 3 K. Martin.
Cisco Routers Presented By Dr. Waleed Alseat Mutah University.
Presentation transcript:

CCNA1 v3 Module 5 v3 CCNA 1 Module 5 JEOPARDY K. Martin Galo Valencia

CCNA1 v3 Module Acronyms Cable Type Cable Type IEEE Media & Media & Connectors Equipment WAN Connections ► ► ► F i n a l J e o p a r d y ◄ ◄ ◄

CCNA1 v3 Module 5 Question BNC Acronyms 100 A: What is a British Naval Connector ? CCNA1 v3 Module 5

\\ Question A: What is an Attachment Unit Interface ? AUI CCNA1 v3 Module 5 Acronyms

CCNA1 v3 Module 5 Question A: What is a Digital Subscriber Line? DSL CCNA1 v3 Module 5 Acronyms 300

CCNA1 v3 Module 5 Question A: What is Data Terminal Equipment? DTE CCNA1 v3 Module 5 Acronyms 400

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is Data Communications Equipment? DCE Acronyms 500

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is a Crossover cable? Switch to Switch Cable Type

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is a Straight-through cable? Switch to Router Cable Type 200

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is a Straight-through cable? Switch to PC Cable Type 300

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is a Crossover cable? Switch to Hub Cable Type 400

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is a Rollover cable? Terminal (Serial Com) to Console Cable Type 500

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is Fast Ethernet? 802.3u IEEE 100

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is Gigabit Ethernet over UTP? 802.3ab IEEE 200

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is Gigabit Ethernet over Fiber? 802.3z IEEE 300

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is Wireless Local Area Networks at 5GHz frequency? a IEEE 400

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is the Local Area Networks 2.4GHz frequency? b IEEE 500

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is 100BaseTX? This Ethernet standard uses an RJ-45 connector, Cat5 cable, and can extend a maximum of 100 meters Media & Connectors 100

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is 100BaseFX? This Ethernet standard uses either an ST or SC connector, 62.5/125 multimode fiber, and can extend a maximum of 400 meters Media & Connectors 200

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is 10Base2? This Ethernet standard uses a BNC connector, coaxial cable, and can extend a maximum of 185 meters Media & Connectors 300

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is 1000BaseSX? This Ethernet standard uses an SC connector; data can travel 275 meters over 62.5µ micro multimode fiber Media & Connectors 400

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is 1000BaseLX? This Ethernet standard uses an SC connector; data can travel up to 10km using 9µ single-mode fiber Media & Connectors 500

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is a Passive Hub? This device allows sharing of a physical media and does not require any electrical power Equipment 100

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is a Repeater? This device, usually with two ports, receives a signal, regenerates it, and passes it on Equipment 200

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is a Bridge? This device, with a limited number of ports, divides LANs into smaller segments Equipment 300

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is a Switch? This device learns forwarding information from the computers attached to it and forwards data only to the port requiring the data Equipment 400

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is an Intelligent Hub? A multi-port repeater with diagnostic capabilities Equipment 500

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is an RJ-45 connector? The type of connector used for ISDN BRI services WAN Connections 100

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is a Serial connection? This type of connection is used to support WAN services WAN Connections 200

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is an RJ-11 connector? The type of connector used for DSL services WAN Connections 300

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is an F-connector? The type of connector used for cable modem services WAN Connections 400

CCNA1 v3 Module 5 Question CCNA1 v3 Module 5 A: What is an NT1? This device is used as an intermediate device between the ISDN service provider and a router WAN Connections 500

CCNA1 v3 Module 5 Question A: What is a Client/Server network environment? This type of network environment exists when multiple computers all access one specialized computer containing web pages Final Jeopardy CCNA1 v3 Module