Can you name the Tools ?

S-10 Drum Brake

Removal of return spring

#1, Adjuster lever 1

Guide plate # 2 2

Remove Hold down Springs, The short one goes with adjuster lever

Remove adjuster lever and return spring, note pivot bushing# 3 3

Note position of parking brake strut rod and anti –rattle spring #4 4

Strut for parking brake with the anti rattle spring Note curve and wide end on strut

Note alignment of parking brake lever

Remove hold down from short shoe

Remove shoesas aunit careful of the adjuster spring # 5 5

Remove adjuster #6 with out stretching of spring #5 6 5

A clean layout will help you with assembly

Removal of parking brake lever from cable

Inspect wheel cylinder for leaks and free movement of pistons

Note wear on backing plate and lube with proper brake grease

Reassemble Clean, No grease or dirt on hands or brake friction material!

Place holdown pin in pivot bushing to hold adjuster lever in place

With care not to stretch spring attach primary shoe with adjuster spring

Attach primary shoe with care not to stretch adjuster spring

Hold Down spring

Hold pin from rear and turn in with a half twist of tool to lock Spring

Narrow slot goes towards primary shoe

Tool is not needed to place the adjuster rod

Replace return springs with care not to over stretch

Insert adjuster return spring with small end up. Note position of adjuster #7 7

Almost perfect!

Replace primary return spring and note guide plate clearance

Inspect what you expect!!!

Use a safety Set tool to pre adjust shoes

Set measurement to drum first

Replace drum and check for noise and shoe adjustment

Thanks to the Morning Zoo Crew Leaders, Andy and Tim