Internal Energy (U): A measure of energy at a macroscopic level due to the molecular translation, vibration, rotation (an Extensive Property). Internal.

Slides:



Advertisements
Similar presentations
ME 200 L39 Vapor Compression Cycle Read 10
Advertisements

EGR 334 Thermodynamics Chapter 6: Sections 9-10
Department of Mechanical Engineering ME 322 – Mechanical Engineering Thermodynamics Lecture 18 Introduction to 2 nd Law and Entropy.
Chapter 7 Entropy (Continue).
Refrigeration and Heat Pump Systems
Refrigeration Cycles Chapter 11.
EGR 334 Thermodynamics Chapter 5: Sections 10-11
Advanced Thermodynamics Note 4 The Second Law of Thermodynamics
Vapor and Combined Power Cycles
EGR 334 Thermodynamics Chapter 6: Sections 6-8
Exergy: A Measure of Work Potential Study Guide in PowerPoint
The Second Law of Thermodynamics
Chapter 7 Continued Entropy: A Measure of Disorder Study Guide in PowerPoint to accompany Thermodynamics: An Engineering Approach, 5th edition.
Analysis of Second Law & Reversible Cyclic Machines P M V Subbarao Professor Mechanical Engineering Department Methods to Recognize Practicable Good Innovations…..
5 CHAPTER The Second Law of Thermodynamics.
Thermodynamics Lecture Series Applied Sciences Education.
EGR 334 Thermodynamics Chapter 6: Sections 11-13
EGR 334 Thermodynamics Chapter 5: Sections 1-9
EGR 334 Thermodynamics Chapter 10:
Thermodynamics I Chapter 6 Entropy Mohsin Mohd Sies Fakulti Kejuruteraan Mekanikal, Universiti Teknologi Malaysia.
PTT 201/4 THERMODYNAMIC SEM 1 (2013/2014) CHAPTER 7: Entropy.
PTT 201/4 THERMODYNAMIC SEM 1 (2012/2013). Objectives Apply the second law of thermodynamics to processes. Define a new property called entropy to quantify.
Pacific School Of Engineering. Guided By:- Asst.Prof.Vatsal patel Submitted by:-  Kotadiya Reshma :  Ladva Piyush : 
Chap. 3 (Sec. 3-5 to End of Chapter) Mass Flow Rate =  A V (kg/s) Volume Flow Rate = A V (m 3 /s) V = velocity.
Thermodynamics I MECN 4201 Professor: Dr. Omar E. Meza Castillo
Reversible Processes The second law of thermodynamics state that no heat engine can have an efficiency of 100%. Then one may ask, what is the highest efficiency.
Exergy: A measure of Work Potential
Thermodynamics I Chapter 5 Second Law of Thermodynamics Mohsin Mohd Sies Fakulti Kejuruteraan Mekanikal, Universiti Teknologi Malaysia.
Calculating Entropy Change
THE SECOND LAW OF THERMODYNAMICS
Chapter 6 Using Entropy.
Lecture slides by Mehmet Kanoglu
Chapter 5 The Second Law of Thermodynamics. Learning Outcomes ►Demonstrate understanding of key concepts related to the second law of thermodynamics,
Review for Exam 2.
Entropy Rate Balance for Closed Systems
The Second Law of Thermodynamics Chapter 6. The Second Law  The second law of thermodynamics states that processes occur in a certain direction, not.
Thermodynamic cycles 2nd law of Thermodynamics Carnot Cycle Lecture 30: 2nd Law of Thermodynamics.
© 2005 Pearson Prentice Hall This work is protected by United States copyright laws and is provided solely for the use of instructors in teaching their.
Energy and the Environment Fall 2013 Instructor: Xiaodong Chu : Office Tel.:
Chapter 13: Thermodynamics
PTT 201/4 THERMODYNAMICS SEM 1 (2013/2014) 1. Objectives Introduce the second law of thermodynamics. Identify valid processes as those that satisfy both.
PHY1039 Properties of Matter Heat Engines, Thermodynamic Efficiency, and Carnot Cycles April 30 and May 3, 2012 Lectures 17 and 18.
Chapter 11 Refrigeration Cycles Study Guide in PowerPoint to accompany Thermodynamics: An Engineering Approach, 8th edition by Yunus A. Çengel.
Entropy Rate Balance for Closed Systems
Second Law of Thermodynamics Alternative Statements
Chapter 7 ENTROPY Dr. Kagan ERYURUK
6. ENTROPY. Objectives Apply the second law of thermodynamics to processes. Define a new property called entropy to quantify the second-law effects. Establish.
1 Second Law of Thermodynamics - Entropy. 2 Introduction The second low often leads to expressions that involve inequalities.
CHAPTER 6 Entropy. Copyright © The McGraw-Hill Companies, Inc. Permission required for reproduction or display. The Clausius Inequality: This inequality.
Chapter 11 Laws of Thermodynamics. Chapter 11 Objectives Internal energy vs heat Work done on or by a system Adiabatic process 1 st Law of Thermodynamics.
Chapter 12 Laws of Thermodynamics. Chapter 12 Objectives Internal energy vs heat Work done on or by a system Adiabatic process 1 st Law of Thermodynamics.
Dr. Owen Clarkin School of Mechanical & Manufacturing Engineering Summary of Energy Topics Chapter 1: Thermodynamics / Energy Introduction Chapter 2: Systems.
Chapter 7 THE SECOND LAW OF THERMODYNAMICS
Carnot Cycle Pratik Vasava ( ) Dept. of Mech. Engg., ADIT, New V. V. Nagar.
1 Reversible Processes The second law of thermodynamics state that no heat engine can have an efficiency of 100%. Then one may ask, what is the highest.
First and Second Law of Thermodynamics
Chapter: 07 ENTROPY.
Refrigeration and Heat Pump Systems
Kelvin – Planck and Clausius Statement
LAXMI INSTITUTE OF TECHNOLOGY
The Laws of Thermodynamics
The Second Law of Thermodynamics: Kelvin–Planck Statement
Thermodynamics: An Engineering Approach Yunus A. Cengel, Michael A
Chapter 3 The 2nd law of thermodynamics
Z.E. Z.E. Z.E. IE 211 INTRODUCTION TO ENGINEERING THERMODYNAMICS
Chapter Seven: Entropy
Review for Exam 2.
Second Law of Thermodynamics
The Second Law of Thermodynamics
SECOND LAW OF THERMODYNAMICS
Presentation transcript:

Internal Energy (U): A measure of energy at a macroscopic level due to the molecular translation, vibration, rotation (an Extensive Property). Internal Energy (u) can also be expressed as an intensive property u=U/m (internal energy per unit mass). U (u) is more difficult to measure, compared to velocity and or height/elevation. Hence, they are usually tabulated in tables – Thermodynamic Tables.

Cycles

First Law of Thermodynamics for a Control Volume

Second Law of Thermodynamics Alternative statements of the second law, Clausius Statement of the Second Law It is impossible for any system to operate in such a way that the sole result would be an energy transfer by heat from a cooler to a hotter body.

Second Law of Thermodynamics Alternative statements of the second law, Kelvin-Planck Statement of the Second Law It is impossible for any system to operate in a thermodynamic cycle and deliver a net amount of energy by work to its surroundings while receiving energy by heat transfer from a single thermal reservoir. NO!

Aspects of the Second Law of Thermodynamics ►From conservation of mass and energy principles, (i.e. 1 st Law of Thermodynamics) ►mass and energy cannot be created or destroyed. ►For a process, conservation of mass and energy principles indicate the disposition of mass and energy but do not infer whether the process can actually occur. ►The second law of thermodynamics provides the guiding principle for whether a process can occur.

Applications to Power Cycles Interacting with Two Thermal Reservoirs For a system undergoing a power cycle while communicating thermally with two thermal reservoirs, a hot reservoir and a cold reservoir, (Eq. 5.4) the thermal efficiency of any such cycle is

Applications to Refrigeration and Heat Pump Cycles Interacting with Two Thermal Reservoirs For a system undergoing a refrigeration cycle or heat pump cycle while communicating thermally with two thermal reservoirs, a hot reservoir and a cold reservoir, (Eq. 5.5) the coefficient of performance for the refrigeration cycle is (Eq. 5.6) and for the heat pump cycle is

Maximum Performance Measures for Cycles Operating between Two Thermal Reservoirs It follows that the maximum theoretical thermal efficiency and coefficients of performance in these cases are achieved only by reversible cycles. Using Eq. 5.7 in Eqs. 5.4, 5.5, and 5.6, we get respectively: (Eq. 5.9) Power Cycle: (Eq. 5.10) Refrigeration Cycle: (Eq. 5.11) Heat Pump Cycle: where T H and T C must be on the Kelvin or Rankine scale.

Carnot Cycle ►The Carnot cycle provides a specific example of a reversible cycle that operates between two thermal reservoirs. Other examples are provided in Chapter 9: the Ericsson and Stirling cycles. ►In a Carnot cycle, the system executing the cycle undergoes a series of four internally reversible processes: two adiabatic processes alternated with two isothermal processes.

Carnot Power Cycles The p - v diagram and schematic of a gas in a piston-cylinder assembly executing a Carnot cycle are shown below:

Carnot Power Cycles The p - v diagram and schematic of water executing a Carnot cycle through four interconnected components are shown below: In each of these cases the thermal efficiency is given by (Eq. 5.9)

Entropy and Heat Transfer Integrating from state 1 to state 2, (Eq. 6.23) ►On rearrangement, Eq. 6.2b gives ►In an internally reversible, adiabatic process (no heat transfer), entropy remains constant. Such a constant- entropy process is called an isentropic process.

Entropy and Heat Transfer From this it follows that an energy transfer by heat to a closed system during an internally reversible process is represented by an area on a temperature-entropy diagram:

Entropy Rate Balance for Control Volumes ►Like mass and energy, entropy can be transferred into or out of a control volume by streams of matter. ►Since this is the principal difference between the closed system and control volume entropy rate balances, the control volume form can be obtained by modifying the closed system form to account for such entropy transfer. The result is (Eq. 6.34) whereandaccount, respectively, for rates of entropy transfer accompanying mass flow at inlets i and exits e.

Vapor-Compression Heat Pump Systems ►Evaporator ►Compressor ►Condenser ►Expansion valve ►The objective of the heat pump is to maintain the temperature of a space or industrial process above the temperature of the surroundings. ►Principal control volumes involve these components:

Vapor-Compression Heat Pump System (a) compressor power, in kW, (b) heat transfer rate provided to the building, in kW, (c) coefficient of performance. Example: A vapor-compression heat pump cycle with R- 134a as the working fluid maintains a building at 20 o C when the outside temperature is 5 o C. The refrigerant mass flow rate is kg/s. Additional steady state operating data are provided in the table. Determine the State h (kJ/kg) ►The method of analysis for vapor-compression heat pumps closely parallels that for vapor-compression refrigeration systems.

I hope you’ve enjoyed the course, (or at least the M&Ms) Please fill out the Course Evaluation Form. They are important. Remember to fill out on top of the evaluation form: John Sullivan, ES3001 – Sec 1 Thermodynamics Use “X” (not checks, or blocks) Use Blue or Black Pen