Single-Side Configuration IPX-1900 Single-Side Configuration Internet Telephony PBX System Copyright © PLANET Technology Corporation. All rights reserved.

2 / 8 FAQ : IPX-1900 Single-Side Configuration? Please refer to the following descriptions and insert proper parameters configurations into the device for establish the voice communications.

3 / 8 Select the [ ] of to create the extension number. Select the [IP PBX Setup -> Extension Management - > SIP Extension] of IP PBX to create the extension number. 1 User Extension : (For Local LAN) User Extension :10 (For Local LAN) Password : Password : 123 Caller Id: Caller Id: 10 2

4 / 8 Select the [ of to create the extension number. Select the [IP PBX Setup -> Extension Management - > FXS Extension] of IP PBX to create the extension number. 3 User Extension : (For Local LAN) User Extension :20 (For Local LAN) Password : Password : 123 4

5 / 8 5 Select the [ ] of to check the FXO Num has appear normally or not. Select the [Trunk Management -> FXO Trunk] of IP PBX to check the FXO Num has appear normally or not. FXO List:. FXO List: 2, 3, and 4. 6

6 / 8 Select the [ ] of to add Trunk Groups. Select the [Trunk Management - > Trunk Group] of IP PBX to add Trunk Groups. 7 8 Create Trunk Group: Create Trunk Group: PSTN Select Trunk Ports : Select Trunk Ports : 2, 3, and 4 Number : Number : 8

7 / 8 Test the Scenario: PHONE1 can call PHONE2 via dial the number: 20 PHONE2 can call PHONE1 via dial the number: 10 There are two ways to call out via PSTN line from PHONE1/PHONE2, it is necessary to press “8” first, and then dial the phone number you wish to call out. e.g PHONE1/PHONE2 press “ ” to call PHONE3 e.g PHONE1/PHONE2 press “8” first, the dial-tone will ring, and then press “ ” to call PHONE3.