1 、 Connect the Infrared Code Learner with PC via USB port, then install the driver according to the system prompts. The using of Infrared Code Learner

2, select “device” and “Infrared learning device”

3 、 Select “Learning mode” 4 、 Click “Ready for learning the code” ， then it is ready to learn the code

5, Put the transmitting terminal of the remote control to the receiving terminal of the Infrared Code Learner, press the button on the remote control, learn it from the following step. 红外学习器的使用

6 、按下遥控器按键后，当 系统提示 “ 学码成功 ” 即说明 该键学习完毕。点击显示已 学码，确认有码学入。 红外传感器

7 、 Put the Infrared Code Learner facing to the device

8 、 According to the kinds of the button, there are three mode to select in the item ” Select key stroke type”: Single press, Hold, Consecutive press. Most of time we use “Single press”. After the selection, press “Try the key” to check the code. If it is not success, PLS learn the code again.

9 、 Select one kind of the code. For example: DVD, VCD, fan+++. It also can add new kinds for the new code.

10 、 Enter a remark11 、 Upload to the database PS: Go to the step 1 to learn a new code after Upload succeeded. Remark the code clearly. After all the code has been learned, use it in IR Transmitter module.